American Motors Pacer 1975
Model Pacer made in 1975 by American Motors got 3 recalls. There were some recalls concerningelectrical system, equipment and fuel system, gasoline.
Model 1975
Recalls
| Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ELECTRICAL SYSTEM - IGNITION - MODULE | ||||||||||||||||
| 78V048000 | CHRYSLER CORPORATION | from 03/01/1974 to 01/01/1976 | V (Vehicle) | 411333 | 06/05/1978 | ODI | CHRYSLER GROUP LLC | 03/09/1978 | 10/12/1979 | |||||||
| Defect Summary | The electronic ignition system sensor circuit contains a two-wire connector which could cause difficulty in the engine ignition. this difficulty may be caused by mechanical or chemical actions at the connector. | |||||||||||||||
| Consequence Summary | ||||||||||||||||
| Corrective Summary | The two-wire connector will be modified by the dealer by cutting and solder-splicing the wires. | |||||||||||||||
| Notes | Vehicle description: passenger vehicles.system: electrical; ignition.consequences of defect: engine could hesitate and stall. should this occur inhazardous weather conditions or in heavy traffic, an accident and personalinjury could result. | |||||||||||||||
| EQUIPMENT - MECHANICAL - JACKS | ||||||||||||||||
| 75V104000 | CHRYSLER CORPORATION | V (Vehicle) | 909 | 06/17/1975 | MFR | CHRYSLER GROUP LLC | 05/28/1975 | 10/12/1979 | ||||||||
| Defect Summary | ||||||||||||||||
| Consequence Summary | ||||||||||||||||
| Corrective Summary | ||||||||||||||||
| Notes | American motors campaign no jack.possibility that the jack assembly does notmeet the minimum stability requirements under load in raised position.(correct by replacing jack assembly with one of known capability). | |||||||||||||||
| FUEL SYSTEM, GASOLINE - DELIVERY - HOSES, LINES/PIPING, AND FITTINGS | ||||||||||||||||
| 75V045000 | CHRYSLER CORPORATION | V (Vehicle) | 13676 | 03/31/1975 | MFR | CHRYSLER GROUP LLC | 03/18/1975 | 10/12/1979 | ||||||||
| Defect Summary | ||||||||||||||||
| Consequence Summary | ||||||||||||||||
| Corrective Summary | ||||||||||||||||
| Notes | American motors campaign no silclip.possibility that the fuel line retainerclip was improperly installed which would allow fuel hose to bear against thefront engine/suspension crossmember.causing abrasion and hose failure withsubsequent fuel leakage.(correct by inspecting and properly routing hose byplacing retainer clip in correct postion.replace hose where necessary). | |||||||||||||||