American Motors Pacer 1976
Model Pacer made in 1976 by American Motors got 2 recalls. There were some recalls concerningelectrical system, seats.
Model 1976
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
ELECTRICAL SYSTEM - IGNITION - MODULE | ||||||||||||||||
78V048000 | CHRYSLER CORPORATION | from 03/01/1974 to 01/01/1976 | V (Vehicle) | 411333 | 06/05/1978 | ODI | CHRYSLER GROUP LLC | 03/09/1978 | 10/12/1979 | |||||||
Defect Summary | The electronic ignition system sensor circuit contains a two-wire connector which could cause difficulty in the engine ignition. this difficulty may be caused by mechanical or chemical actions at the connector. | |||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | The two-wire connector will be modified by the dealer by cutting and solder-splicing the wires. | |||||||||||||||
Notes | Vehicle description: passenger vehicles.system: electrical; ignition.consequences of defect: engine could hesitate and stall. should this occur inhazardous weather conditions or in heavy traffic, an accident and personalinjury could result. | |||||||||||||||
SEATS - FRONT ASSEMBLY - RECLINER | ||||||||||||||||
76V079000 | CHRYSLER CORPORATION | V (Vehicle) | 20277 | 07/23/1976 | MFR | CHRYSLER GROUP LLC | 06/01/1976 | 10/12/1979 | 571 | 207 | ||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | American motors campaign no tb 12.possibility that the rivet securing therear seat back latch lever to the seat back hinge arm has a shallow stakingimpression.if this condition exists, during the forward pull center ofgravity load test of federal motor vehicle safety standard 207, seatingsystems.the rivet could pull through the hinge and release the latch.(correct by inspecting and adding two tack welds on the staked end of the rivetwhere necessary). |