Bmw 528 1982
Model 528 made in 1982 by Bmw got 2 recalls. There were some recalls concerningpower train, vehicle speed control.
Model 1982
Recalls
| Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| POWER TRAIN - AXLE ASSEMBLY | ||||||||||||||||
| 82V108000 | BAYERISCHE MOTOREN WERKE | from 07/01/1982 to 09/01/1982 | V (Vehicle) | 1347 | 01/05/1983 | MFR | BAYERISCHE MOTOREN WERKE | 11/02/1982 | 11/09/1982 | |||||||
| Defect Summary | On some of the involved vehicles, the knurled nut, part of the rubber mount assembly which supports the differential, may have been cracked due to over-torquing of the final drive attaching bolt. this bolt may become loose, and continued operation may cause it to fall out. | |||||||||||||||
| Consequence Summary | ||||||||||||||||
| Corrective Summary | Dealer will inspect and repair or replace attaching assembly, as necessary, without charge to owner. | |||||||||||||||
| Notes | Vehicle description: passenger vehicles.system: power train; axle assembly.consequences of defect: should the bolt fall out, the final drive unit couldlower. this could lead to loss of vehicle control and an accident.note: a loosened bolt may be evidenced by a vibration or rattling noise in therear axle area. | |||||||||||||||
| VEHICLE SPEED CONTROL | ||||||||||||||||
| 82V010000 | BAYERISCHE MOTOREN WERKE | from 08/01/1981 to 01/01/1982 | V (Vehicle) | 3780 | 01/21/1982 | MFR | BAYERISCHE MOTOREN WERKE | 01/28/1982 | 02/01/1982 | |||||||
| Defect Summary | On the involved vehicles, under a combination of low temperature conditions and a warmed up engine, water vapor in the warm air from the crankcase housing may condense and freeze after a period of steady state driving causing ice build up around the throttle plate. the ice might prevent the throttle plate from fully closing when the driver releases the accelerator pedal, causing a slower than normal deceleration rate and an increase of the idle speed. | |||||||||||||||
| Consequence Summary | ||||||||||||||||
| Corrective Summary | Dealer will replace the existing throttle housing with a heated throttle housing at no cost to owner. | |||||||||||||||
| Notes | Vehicle description: passenger vehicles.system: throttle control; throttle plate.consequences of defect: loss of vehicle speed control could result in loss ofvehicle control and an accident. | |||||||||||||||