Bmw F650 Gs Dakar 2007

Model F650 Gs Dakar made in 2007 by Bmw got 1 recall as well as 12 service bulletins. Technical service bulletines regarding electrical system and engine and engine cooling. There was one recall concerning structure .

Model 2007

Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
STRUCTURE - MOTORCYCLE KICKSTAND/CENTER STAND
07V151000BMW OF NORTH AMERICA, LLCfrom 06/23/2006 to 08/31/2006V (Vehicle)30506/01/2007MFRBMW OF NORTH AMERICA, LLC04/03/200704/05/2007
Defect SummaryOn certain motorcycles, the weld between the side stand and the frame bottom section was not positioned properly. the load-bearing capability of the side stand is affected. as a result, the side stand could fail.
Consequence SummaryIf this occurred when the motorcycle was parked, the motorcycle could fall to the ground and injure a person sitting on the motorcycle or a person nearby.
Corrective SummaryDealers will install a new frame bottom section free of charge. the recall began on june 1, 2007. owners may contact bmw at 1-800-831-1117.
NotesCustomers may contact the national highway traffic safety administration

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
ELECTRICAL SYSTEM - WIRING
TB-61-002-0809/01/200810029188Bmw mc: wiring harness of motorcycles is routed along right hand top rail of frame. weld spatter on frame and/or adverse routing in vicinity of banjo bolt of hydraulic spring base adjuster can result in chafing of the wiring harness. m06/24/2009
ENGINE AND ENGINE COOLING - EXHAUST SYSTEM - EMISSION CONTROL - CRANKCASE (PCV)
SIB-11-03-0812/01/201010038217Bmw: crankcase pressure diagnosis and information for all vehicles. *rm06/10/2011
SIB-11-03-0812/01/201010038217Ready06/10/2011
EXTERIOR LIGHTING
SIB-63-02-0108/01/201010037025Ready04/27/2011
SIB-63-02-0108/01/201010037025Bmw: procedure for determining and replacing incandescent and halogen light bulbs under warranty. *rm04/27/2011
FUEL SYSTEM, OTHER
SB-00-021-0711/01/200710030825Bmw motorcycle: engine fuels containing ethanol. bmw motorrad has no objection to the use of si engine fuels containing up to a maximum of 10% ethanol and imposes no warranty restrictions. ethanol mixtures in proportions higher than 10%12/07/2009
FUEL SYSTEM, OTHER - STORAGE - TANK ASSEMBLY - PRESSURE RELIEF DEVICES
13-003-0806/01/200810026845Bmw motorcycle: replacement of fuel-pressure sensor. check of position of protective film (f-800 gs only). *pe12/29/2008
SERVICE BRAKES, AIR - ANTILOCK - WHEEL SPEED SENSOR
SB-61-003-0810/01/200810028386Bmw vehicles: routing abs front wheel speed sensor cable. the wiring harness front wheel speed sensor periphery plug connection is mounted on the fork cover at the bottom. *pe03/27/2009
SERVICE BRAKES, HYDRAULIC - ANTILOCK - WHEEL SPEED SENSOR
SB-61-003-0810/01/200810028386Bmw vehicles: routing abs front wheel speed sensor cable. the wiring harness front wheel speed sensor periphery plug connection is mounted on the fork cover at the bottom. *pe03/27/2009
STEERING - WHEEL AND HANDLE BAR
13-003-0806/01/200810026845Bmw motorcycle: replacement of fuel-pressure sensor. check of position of protective film (f-800 gs only). *pe12/29/2008
31-001-0711/01/200710026226Bmw motorcycle: handlebar fastener loose. may have been fitted with clamping blocks and top fork bridges that the supplier did not manufacture to specification in accordance with the technical drawings. *pe10/08/2008
VEHICLE SPEED CONTROL - CABLES
SB-61-003-0810/01/200810028386Bmw vehicles: routing abs front wheel speed sensor cable. the wiring harness front wheel speed sensor periphery plug connection is mounted on the fork cover at the bottom. *pe03/27/2009