Buick Estate 1986
Model Estate made in 1986 by Buick got 3 consumer complains there are 2 investigations as well as 3 recalls. Consumer complaints with reference to service brakes, hydraulic. . The car had one investigation (steering). There were some recalls concerningexterior lighting, vehicle speed control.
Model 1986
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
EXTERIOR LIGHTING - HEADLIGHTS - SWITCH | ||||||||||||||||
86V056000 | GENERAL MOTORS CORP. | from 09/01/1985 to 11/01/1985 | V (Vehicle) | 93317 | 05/15/1986 | MFR | GENERAL MOTORS CORP. | 04/28/1986 | 05/01/1986 | |||||||
Defect Summary | The push-pull headlight switch may have electrical contacts which allow an intermittent headlight circuit causing headlight to flicker or suddenly go out. consequence of defect: sudden loss of the headlights under severe weather or nighttime driving conditions could reduce driver visibility which might result in a vehicle crash without prior warning. note: also, see nhtsa campaign number 86v131000. | |||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | Replace headlight switch as necessary. | |||||||||||||||
Notes | System: headlight switch. vehicle description: passenger cars, trucks and vans. | |||||||||||||||
86V131000 | GENERAL MOTORS CORP. | from 03/01/1986 to 04/01/1986 | V (Vehicle) | 106111 | 05/15/1986 | MFR | GENERAL MOTORS CORP. | 09/19/1986 | 09/30/1986 | |||||||
Defect Summary | The push pull headlight switch may have electrical contacts which allow an intermittent headlight circuit causing headlight to flicker or suddenly go out. consequence of defect: sudden loss of the headlights under severe weather or nighttime driving conditions could reduce driver visibility which might result in a vehicle crash without prior warning. | |||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | Replace headlight switch as necessary. | |||||||||||||||
Notes | System: headlight switch. vehicle description: passenger cars and trucks/ vans. | |||||||||||||||
VEHICLE SPEED CONTROL | ||||||||||||||||
89V102000 | GENERAL MOTORS CORP. | from 08/01/1983 to 02/01/1988 | V (Vehicle) | 1755897 | 07/20/1989 | ODI | GENERAL MOTORS CORP. | 06/16/1989 | 07/25/1989 | |||||||
Defect Summary | A small nylon bushing in the cruise control servo bail may slip out of place, causing intermittent and unexpected increases in engine speed or dieseling (engine run on with ignition off). | |||||||||||||||
Consequence Summary | Servo rod assembly could catch on engine components andresult in a stuck throttle with potential for a vehicle crash. | |||||||||||||||
Corrective Summary | Install a new bushing in cruise control servo bail. | |||||||||||||||
Notes | System:cruise control.vehicle description:passenger vehicles equipped with cruise control andcertain gasoline and diesel engines. |
Investigations
NHTSA ID | Manufacturer | Date open | Date close | Subject | Recall campaign | |
---|---|---|---|---|---|---|
STEERING | ||||||
EA88019 | GENERAL MOTORS CORP. | 01/28/1988 | 10/31/1990 | HYDRO BOOST | ||
There is no summary currently available | ||||||
PE87038 | GENERAL MOTORS CORP. | 07/09/1987 | 01/28/1988 | HYDROBOOST FAILURE | ||
There is no summary currently available |
Consumer Complaints
Fail date | miles | occurences | Purchase date |
---|---|---|---|
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS | |||
02/22/1998 | |||
Consumer states while depressing the brakes to make a stop the vehicle contacted to travel. please provide further information. *ak | |||
SERVICE BRAKES, HYDRAULIC - POWER ASSIST | |||
05/01/1999 | |||
Understand gm had problems with this powermaster brakes | |||
SERVICE BRAKES, HYDRAULIC - POWER ASSIST - HYDRAULIC | |||
08/01/2004 | 74000 | 1 | 07/16/2004 |
Currently own 1986 buick estate equipped with power master brake unit. this is the original factory brake unit for this automobile. the pressure switch developed a crack, allowing the brake fluid to be pumped out. my father was driving the vehicle at the time, and managed to get the car stopped and off the road without crashing. nevertheless, the results could have been much different. what's more, i know now that gm has long been aware of this defect. since this occured, i have learned that gm was aware of this problem for quite some time, and issued a recall for this particular part (pressure swicth) as well as for the divider valve. upon contacting the local gm dealer (dallas automotive group, jackson, oh.) i was informade that my vehicle was not covered by this recall. in fact, i was told that it only applied to 2 vin! finding it hard to believe that a recall was issued, but for only 2 vehicles, i contacted gm customer assistance. i talked with greg martin, customer relations manager, and was infrmaed that my buick's vin was not among those covered. however, according to the gm service bulletin regarding this brake problem, all pressure switches that are black in color are to be replaced, along with the o' ring seal. it further states that after replacing this part with the gray replacement part, service personell should check the divider valve . if it is cast iron, it is to be replaced with a brass valve. in spite of all this, they maintain that this vehicle is not covered. further, they claim this vehicle is not effected even though the part failed, and did so in the exact manner described in the service bulletin. i believe that they are simply not honoring the recall because i am not the original owner, and don't have the original recall notice. they are merely thumbing their corporate noses at the safety issues involved in total brake system failures.*ak |