Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
EXTERIOR LIGHTING - BRAKE LIGHTS - SWITCH
88V040000GENERAL MOTORS CORP.from 06/01/1987 to 10/01/1987V (Vehicle)966104/13/1988MFRGENERAL MOTORS CORP.03/24/198804/06/1988
Defect SummaryThe stop lamp switch may have a loose electrical contact. the loose contact can overheat and melt the surrounding plastic causing the contact to stick open.
Consequence SummaryAn open contact would render the brake lights inoperativewhen the brake pedal is depressed. also, the transmission clutch control andcruise control contacts would remain closed. this condition would result incruise resume upon brake pedal release if the cruise control is in the onposition. either an unexpected cruise resume or inoperative brake lights couldresult in a vehicle crash without prior warning.
Corrective SummaryThe rotary soplamp switch will be replaced on all involved vehicles.
NotesSystem: electrical/stop lampswitch.vehicle description: passenger cars.

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
EXTERIOR LIGHTING
PE90088GENERAL MOTORS CORP.06/11/199010/31/1990FAILURE STOP LAMP SWITCH90V185000
 There is no summary currently available

Consumer Complaints


Fail datemilesoccurencesPurchase date
EXTERIOR LIGHTING - BACK UP LIGHTS
109/17/1999
 Brake light in rear window holds to much moisture. yh
EXTERIOR LIGHTING - BRAKE LIGHTS
3
 Would have no rear signal light unless the signal switch is held in a certain way and position. this would also effect the brake lights. transmission fails to show proper gear while driving. when driving approximately 60 mph or more, the gear shows it's in reverse instead of the drive position.*ak
08/01/199705/01/1988
 Cruise control engaged suddenly after the brakes were released. also brake lights malfunctioned. *ak
EXTERIOR LIGHTING - TURN SIGNAL - SWITCH
3
 Would have no rear signal light unless the signal switch is held in a certain way and position. this would also effect the brake lights. transmission fails to show proper gear while driving. when driving approximately 60 mph or more, the gear shows it's in reverse instead of the drive position.*ak