Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SERVICE BRAKES, HYDRAULIC - ANTILOCK
97080173502608/01/199754419Comment that the abs light is on with diagnostic trouble codes (dtc's) 46 and 86 set as current or history. *yc04/07/1998
SERVICE BRAKES, HYDRAULIC - ANTILOCK - ABS WARNING LIGHT
435012A01/01/199543-50-1239072Abs warning light is on. *tw03/06/1995
43501212/01/199437955Abs wire harness for the right front wheel may rub on the brake line causing the abs warning light to come on. *tw02/09/1995

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
SERVICE BRAKES, HYDRAULIC
PE94063GENERAL MOTORS CORP.08/12/199412/21/1994CORRODED REAR DISK BRAKES
 There is no summary currently available

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, HYDRAULIC
10/01/200250
 Dt*: the contact stated the vehicle has had continual problems with the transmission. the vehicle has been to the dealer several times for repairs but the problem persists. the transmission was also rebuilt by an independent mechanic. there is a recall #91v214000 pertaining to power train:automatic transmission. the manufacturer confirmed that vin was included in the recall but that the recall has expired. the vehicle also has continuous failure in the design of the whole brake system. two mechanics confirmed that the brake problem is a chronic problem due to a manufacturer defect. the dealer and the manufacturer do not acknowledge the brake failure as a manufacturer defect.
06/01/19968
 Continuous brake failure.
SERVICE BRAKES, HYDRAULIC - ANTILOCK
 Intermittently when brakes are applied under normal conditions pedal goes to the floor, resulting in extended stopping distance. dealer has lubricated sliders twice, and problem has reoccurred. *ak
07/10/20000
 When putting on brakes consumer would hear a rubbing noise, consumer said it was getting hard to stop vehicle.*ak
06/13/2000
 Brakes have been replaced several times. the brakes pedal goes completely to the floorboard. dealer has tried to repair the vehicle, but can't remedy the problem.*ak
 When the brakes were applied pedal went to the floor, resulting in extended stoppingf distance. dealer has replaced the brake system twice. also, when consumer went to rotate the tires the brake parts started to fall off. the manufacturer has been notified. *ak
507/01/1992
 Both lock on doors do not work, also, vehicle has brake failure.*ak the air condition was leaking, starter was replaced, check engine light appeared while driving, right inside door trim was loose, headlights were out of adjustment, window would not roll up, driver side door handle broke, and driver seat belt would not retract.*jb
09/02/19971012/01/1992
 While driving vehicle about 10 mph the consumer tried to step on the brake pedal for a light or stop sign. she had some problem to stop vehicle. the brakes didn't stop vehicle on time, the vehicle kept rolling. vehicle had been taken to the shop. *ak
106/01/1992
 Anti lock brakes do not work properly, feel spongy and do not stop vehicle.
 Vehicle's rear abs braking system is only 10% effective for stopping.the abs system design was changed for the following years. *ak
11/03/19962
 Owner has abs brakes. while driving vehicle and trying to use brakes they failed, the pedal went to the floor, resulting in loss of control. master cylinder was also replaced. *ak
101/14/1993
 Replaced master cylinder.
09/08/1996
 Without prior warning, no power assist from brakes, pedal goes to floor, caused increase in stopping distance, intermittent problem.*ak
 Abs brakes have soft pedal when applied. when a/c is used vehicle will shut down w/no warning. please describe details.*ak
04/01/1996
 The left front and left back braked locked up. the car is equipped with abs brakes. *ak
09/07/1993
 During brake application pedal went to the floor. resulting from excessive brake wear. this is the third incident. tt
06/28/1995
 The brakes have failed twice. the pedal has gone all the way to the floor. please describe.
SERVICE BRAKES, HYDRAULIC - FLUID
07/18/19948
 Transmission fluid discovered in antilock brake system, causing brake failure. *aw
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
1
 Consumer stated while driving, vehicle experienced a reduction of brake effectiveness.*jb
 Brake failure. *ak
10/11/1995307/01/1995
 Vehicle experiencing multiple brake failures which include the pad,rotor and calipers due to poor design. yh
507/01/1992
 Both lock on doors do not work, also, vehicle has brake failure.*ak the air condition was leaking, starter was replaced, check engine light appeared while driving, right inside door trim was loose, headlights were out of adjustment, window would not roll up, driver side door handle broke, and driver seat belt would not retract.*jb
 When applying the brakes, the pedal went to the floor and brakes failed to stop the vehicle. *ak
12/15/1991312/01/1991
 When applying the brakes in a sudden stop situation, the brake pedal goes to the floor and the vehicle's brakes fail. *ak *slc
10/02/1996
 Brakes completely failed after applying pressure . *ak
06/10/1994
 Brakes failed, vehicle went through red light, had an accident. tt
05/01/1995
 Brake pedal goes to the floor, have to pump to stop. tt
05/04/19924
 Brakes failed, causing loss of control/accident. *aw
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
07/30/20010
 Calipers will not come off the brake pads. consumer is not able to change pads, and has to ride with warped brakes. consumer has contacted dealer. please provide any further information.*ak
08/14/199507/01/1992
 19922-rear doors stick-adjusted 4 times; brakes cleaned dust build up on pads and rotors; 1994-replaced water pump; 95- exhaust seal cracked;replacaed evaporator and compressor and heater core; front brake pads replaced and resurfaced rotors; -96 door stics in freezing rain- had to have door hadle and control rod fixed; 98 replaced water pump again; odemeter stopped working, at 47,000 (?) ,front and rear brak pads and rotors replaced, rust on right rear side window. had my oil and lube job at deaaler; in 11/98 and in12/98 heard noise in front, and found out that power steering fluid was almost gone. the gas station mechanic listened to the noise and found this out. finally, in 99 all doors froze and two front door handles bent and needed to be fixed. the front side window visiability is poor. *ak
 Turn signal switch connectors did not operate properly. also, premature wear of front brake calipers/pads and rotors.
02/22/1996
 Corroded rear disc brakes, causes excessive wear on front brakes
12/23/1995
 Corroded rear disc brakes which caused reduction in brake pe94-063. tt
10/27/1995
 Ea94-041 active, corrosion of the rear disc brakes in for inspection will not pass. tt
05/04/19924
 Brakes failed, causing loss of control/accident/injury. *skd
06/01/19951
 Front brakefailed/noisy at 10,000. tt
 Front brakes are wearing out prematurely. tt
03/30/1995
 Corroded disc brakes, replaced rotors and calipers on rear. tt
02/01/1995
 Abs, failure of disc brakes, experience extended stopping distance, pe 94-063 active. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER
 Intermittently when brakes are applied under normal conditions pedal goes to the floor, resulting in extended stopping distance. dealer has lubricated sliders twice, and problem has reoccurred. *ak
1
 Brake calipers and master cylinder failed.
12/12/19932
 Having excessive braking problems. having to replace calipers, rotors, and pads over and over again in less than a year's time.*ak *jb
08/22/1996
 Brake failure, front disc brake overhauled, replaced rotors and rear guide pin set, also due to corrision replaced calipers. *ak
08/07/19957
 Left rear caliper overheated, causing brakes to fail.
09/01/19951
 Rear brake calipers replaced. *sd
03/25/19951
 Rear brake jammed, would not operate due to frozen caliper. *ak
01/13/1995
 Vehicles rear brake had complete failure due to disc calipers becoming inoperative.(pe94-063). tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS
 Malfunctioning of the braking system, the rear brakes are not grabbing, causing the front brakes to wear often. *ak
12/12/19932
 Having excessive braking problems. having to replace calipers, rotors, and pads over and over again in less than a year's time.*ak *jb
04/01/19941
 Brake pads replaced. *sd
04/25/19951
 Had to replace the pads. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR
11/03/1995101/14/1993
 Front brake rotors rusted/pitted.
12/12/19932
 Having excessive braking problems. having to replace calipers, rotors, and pads over and over again in less than a year's time.*ak *jb
08/22/1996
 Brake failure, front disc brake overhauled, replaced rotors and rear guide pin set, also due to corrision replaced calipers. *ak
04/01/19941
 Brakes rotors replaced. *sd
05/04/19924
 Pitted rotors, causing brake failure, resulting in loss of control/accident/injury. *ak
08/08/19956
 Left rear rotor warped, causing vehicle to chatter. *ak
04/01/1995
 Pe94-063 brake failure, front brake overheating cause warp of rotors and disc pads, in for repair. tt
 Front brake rotors warp continuously. brake pads are glazed due to excessive heat. please describe details. tt
04/25/19951
 Rotors worn out. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM
11/03/1995101/14/1993
 Rear brakes replaced.
 Malfunctioning of the braking system, the rear brakes are not grabbing, causing the front brakes to wear often. *ak
01/01/1992
 Rear brake freeze up, resulting in wear on front brake and rear part rusting, also strut replace once. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER
11/09/1999210/01/1992
 Master cylinder had failed and was replaced with factory unit about a year ago. this master cylinder is also failing, requiring excessive pedal pressure and poor stopping. front brake do not appear to work well.
1
 Brake calipers and master cylinder failed.
07/11/1998210/23/1992
 While driving the consumer tried to make a sudden stop by depressing the brakes the vehicle continued to travel. *ak consumer hit a parked car due to brake failure, garage replaced master cylinder after a second brake failure. *slc
11/01/1996
 While applying brakes on downhill section of highway, experienced total brake failure, pedal fade to the floor, did not slow down, after a few minutes pedal pressure return, possible defect in master cylinder.
11/03/19962
 Owner has abs brakes. while driving vehicle and trying to use brakes they failed, the pedal went to the floor, resulting in loss of control. master cylinder was also replaced. *ak