Buick Skylark 1982
Model Skylark made in 1982 by Buick got 3 consumer complains there is 1 investigation as well as 3 recalls. Consumer complaints with reference, among others things, to fuel system, gasoline, seat belts and service brakes, hydraulic. The car had one investigation (steering). There were some recalls concerningfuel system, gasoline, power train and service brakes, hydraulic.
Model 1982
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
FUEL SYSTEM, GASOLINE - STORAGE - TANK ASSEMBLY - FILLER PIPE AND CAP | ||||||||||||||||
82V021000 | GENERAL MOTORS CORP. | from 02/01/1981 to 01/01/1982 | V (Vehicle) | 519329 | 03/15/1982 | MFR | GENERAL MOTORS CORP. | 03/08/1982 | 03/12/1982 | |||||||
Defect Summary | Under certaain conditions, the hose clamps on the fuel tank filler pipe and fuel tank filler vent pipe could fracture. the fracture of these clamps could cause fuel leakage at any of the four pipe to hose connections. leakage can occur during refueling, or while driving, if the fuel tank is above 3/4 full. | |||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | Dealer will inspect and replace the hose clamps on the fuel tank filler pipe and vent pipe at no cost to owner. | |||||||||||||||
Notes | Vehicle description: passenger vehicles.system: fuel; fuel tank, filler and vent pipes.consequences of defect: if an ignition source is present when fuel leakageoccurs, a fire could start and cause vehicle damage and serious personalinjury.note: until the vehicle can be inspected and the necessary modifications aremade, the fuel tank should not be filled more than 3/4 full. also, the dealershould be contacted immediately if any fuel leakage is detected. | |||||||||||||||
POWER TRAIN - CLUTCH ASSEMBLY - PEDAL/LINKAGE | ||||||||||||||||
82V018000 | GENERAL MOTORS CORP. | from 09/01/1981 to 12/01/1981 | V (Vehicle) | 4987 | 03/08/1982 | MFR | GENERAL MOTORS CORP. | 03/02/1982 | 03/12/1982 | |||||||
Defect Summary | The clutch cable may rub against the master cylinder brake pipe when the clutch pedal is operated. continued operation of the vehicle may result in wear through of the insulation on the clutch cable. the resulting metal on metal contact could lead to failure of the brake pipe, loss of brake fluid, and partial loss of brake action. | |||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | Dealer will inspect and, if necessary, correct system by providing a minimum 1/2 inch clearance between clutch cable and brake pipe to avoid metal on metal contact. | |||||||||||||||
Notes | Vehicle description: passenger vehicles equipped with four speed manualtransmission and power brakes.system: power train; clutch assembly linkage, flexible.consequences of defect: partial loss of brake action could lead to loss ofvehicle control and an accident. | |||||||||||||||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - HOSES, LINES/PIPING, AND FITTINGS | ||||||||||||||||
83V007000 | GENERAL MOTORS CORP. | from 05/01/1982 to 06/01/1982 | V (Vehicle) | 15495 | 01/27/1983 | MFR | GENERAL MOTORS CORP. | 01/01/1983 | 02/04/1983 | 571 | 106 | |||||
Defect Summary | Rear brake hoses may have been manufactured incorrectly when the metal end fittings were installed. some rear brake hoses may separate from the metal end fittings when subjected to the pulling force specified by federal motor vehicle safety standard 106, brake hoses. | |||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | The dealer will inspect and replace, if necessary, the rear brake hoses at no charge to owners. | |||||||||||||||
Notes | Vehicle description: passenger vehicles.system: service brakes; rear brake hoses.consequences of defect: a separation may result in a loss of brake fluid and apartial loss of braking action. a partial loss of braking action could resultin a vehicle crash in situations in which a minimum stopping distance isrequired. |
Investigations
NHTSA ID | Manufacturer | Date open | Date close | Subject | Recall campaign | |
---|---|---|---|---|---|---|
STEERING | ||||||
EA87006 | GENERAL MOTORS CORP. | 12/16/1986 | 09/19/1988 | POWER ST. ASSIST | ||
There is no summary currently available |
Consumer Complaints
Fail date | miles | occurences | Purchase date |
---|---|---|---|
FUEL SYSTEM, GASOLINE - FUEL INJECTION SYSTEM | |||
100 | |||
Engine stalls when cornering or waiting at intersections with stop lights whenever ambient air temperatures exceed 85 degrees f*. must wait longer as temps. increase. *ak | |||
SEAT BELTS - FRONT - ANCHORAGE | |||
1 | 03/01/1994 | ||
The seat belts did not work while accident occurred, four people injured and one death due to seat belt failure. | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER | |||
01/10/1996 | 0 | ||
Brake calipers locked up. *sd |