Chevrolet Biscayne 1965
Model Biscayne made in 1965 by Chevrolet got 2 recalls. There were some recalls concerningengine and engine cooling, steering.
Model 1965
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
ENGINE AND ENGINE COOLING - EXHAUST SYSTEM - MANIFOLD/HEADER/MUFFLER/TAIL PIPE | ||||||||||||||||
69V030000 | GENERAL MOTORS CORP. | V (Vehicle) | 2570914 | 02/26/1969 | MFR | GENERAL MOTORS CORP. | 02/28/1969 | 10/12/1979 | ||||||||
Defect Summary | Exhaust emissions (carbon monoxide) may enter the interior of the vehicle when the exhaust pipe is substantially out the design position, deteriorated from use, or when an opening in the body develops near the exhaust outlet and, at the same time, a negative air pressure occurs in the vehicle interior. | |||||||||||||||
Consequence Summary | Under these conditions, vehicle occupants may experiencecarbon monoxide poisoning. | |||||||||||||||
Corrective Summary | Reseal nearby body joints and replace the draw plug in the body which was used to remove surplus bonderizing solution during manufacture. | |||||||||||||||
Notes | System: exhaust.vehicle description: passenger cars. | |||||||||||||||
STEERING - LINKAGES - ARM - IDLER AND ATTACHMENT | ||||||||||||||||
67V098000 | GENERAL MOTORS CORP. | V (Vehicle) | 1143000 | 10/23/1967 | ODI | GENERAL MOTORS CORP. | 10/23/1967 | 10/12/1979 | ||||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Possibility that, after extended mileage, the idler arm assembly could separate during vehicle operation and result in a severe pull to the right as brakes are applied at low to moderate speed.(inspect and re- place idler arm assembly as required.) |