Bulletins
Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
---|---|---|---|---|---|
SUSPENSION - FRONT | |||||
02015 | 01/01/2004 | 10006961 | Pop snap noise in the front suspension when braking. *mr | 05/20/2004 |
Consumer Complaints
Fail date | miles | occurences | Purchase date |
---|---|---|---|
SUSPENSION - FRONT | |||
3 | 10/15/1991 | ||
Transmission does not shift out of low gear; also, mount bolts securing the tilt whel knuckle came loose, allowing the steering wheel to move freely up/down and upper/lower ball joints failed. *ak | |||
SUSPENSION - FRONT - CONTROL ARM | |||
04/18/1995 | 8 | ||
Weld on control arm mount failed, causing bracket on frame to break. *skd | |||
SUSPENSION - FRONT - CONTROL ARM - LOWER BALL JOINT | |||
10/01/2002 | |||
The consumer took the vehicle in for inspection. and the techncian noticed that the lower ball joint was gone. the dealership is aware of the problem.. ts | |||
03/19/1996 | 1 | 05/01/1991 | |
Lower ball joints failed. *dh | |||
SUSPENSION - FRONT - SPRINGS - TORSION BAR | |||
08/09/2000 | 1 | ||
While driving stepped on brake pedal, but vehicle would not stop on time. *ak right exhaust manifold , exhaust pipe and oxygen sensor failed. there was a clunk intermittently from back on turns due to broken torsion bar mounts. 4wd often hard to engage due to vac switch in transfer case failure. replace rear main seal, oil pan and gasket because of rust and oil leak. serpentine belt failed. distributor cap and rotor failed. axle seals and bearings are leaking. *yh |