Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
STRUCTURE
30080008/30/2000619027Subject regarding the new reclincer assembly. *tt05/10/2001
STRUCTURE - BODY
411410020462Clunk noise felt through the floor pan. *kb10/23/2006
5707/01/200310016473Water leak in front floor carpet area. gm tech link. *tt09/13/2005
010866011C07/01/2002010866011B634823Technical information - some customers may comment that the rear portion of the roof has some rust forming. *tt10/09/2002
02085700406/01/2002634506Subject regarding general waterleak guide. *tt10/03/2002
010866011B02/01/2002010866016629470Some customers may comment that the rear portion of the roof has some rust forming. *tt04/02/2002
010866011A12/01/2001010866011628854Subject regarding rear roof perforation. *tt03/21/2002
01086601612/01/2001628852Concerns that the rear portion of the roof has some rust forming. *tt03/21/2002
01086601111/01/2001628512Subject regarding rear roof perforation (install new rear roof section) including 1995-1997 gmc blazer.*jg03/12/2002
01086601111/01/2001627489Information regarding rear roof perforation. *yh02/08/2002
STRUCTURE - FRAME AND MEMBERS - UNDERBODY SHIELDS
01136C11/18/200310004206Clunk noise felt through floor pan. *tt11/21/2003

Consumer Complaints


Fail datemilesoccurencesPurchase date
STRUCTURE
10/14/2000701/31/1999
 The chevy blazer had multiple defects. the air bag did not deploy upon impact. *bf the vehicle had air and water leaks around the windows, oil was being consumed abnormally, the seat belt had come loose and the brakes did not work properly. the consumer was informed that the vehicle had been wrecked. the consumer had three accidents in which all were frontal impacts. *sc
08/14/20041
 1999 blazer under 60k, have replaced both front wheel hub bearing, oil cooler lines, front seat recliner handle, condensate water leaks onto floor when vehicle is in motion. have read same problem on complaint web-site. why no action by gm? *jb
09/01/200020000610/01/1998
 Lower ball joints wear out prematurely. *ak the consumer stated the vehicle was on its fifth set of lower ball joints and it sixth idler arm. the cruise control was inoperative, the grill guard was loose, the rear differential leaked, the door latch was inoperative, the sending unit was replaced, the battery was replaced, the door was readjusted due to a vibration, the left front hub assembly was replaced, the exhaust made a noise, the tensioner and serpentine belt was replaced, the front axle seal leaked and the intake gasket leaked. *jb
09/18/2000105/01/1999
 Consumer reporting excessive wear of brake pads and rotors, from 17,614 to 35,500 miles there were three sets of brake rotors and two sets of brake pads replace on the vehicle, and the problem reoccurs. the dealer has been notified. *nlm water leak on passenger side floor, driver side door rattles going over bumps, both front windows outer molding comes off, moldings replaced, humming noise from front wheels when coming to a stop, wheel bearing / hub replaced. *tt
2
 The vehicle experienced clunking noise in the front end due to loose body mounts, this problem has occured on two occasions. nlm
11/30/2000603/02/1999
 Vehicle experiences stalling, after stalling there is a burning smell, dealer has replaced the fuel pump, crank sensor, map sensor, pcm, fuel pump module, vehicle still experiences stalling, consumer feels problem is an electrical problem. ses light flashed at times, dealer replaced coil wire. keyless entry inoperable, dealer replaced receiver, remote module, and reprogrammed transmitters. consumer states vehicle has excessive wind noise on both sides. there is a clunk when backing up and turning left or right. overhead panel goes blank in morning, when first starting vehicle, dash and gauges will not light up, and overhead compass was replaced. consumer states gas mileage is not as good as it used to be. ses light illuminated. *slc
STRUCTURE - BODY
03/21/2010187000
 The tread from a uniroyal laredo tire came off while i was driving on the freeway. i lost control of my vehicle momentarily until i was able to countersteer to correct the weaving and unstable driving of my vehicle. as the tread came off it damaged my wheel well, undercarraige behind the wheel, rear bumper and body trim. i had my son and three of his friends in the car at the time.
07/01/2000106/26/1999
 Due to location of drainage hose, the top pin hinge on passenger and driver doors rusted out. consumer has contacted dealer. *ak the hinge bushings are showing signs of wear, the dealer admits there is a problem with the drain locations, consumer states with the corrosion present on the hinge pins there is a possibility of breaking. *slc
07/26/1999
 There is hot heat coming from the vents under the dashboard, and one of the vents is right near the gas pedal. *ak
STRUCTURE - BODY - DOOR
07/03/20081
 Driver side door is very bad if go over the slightest bump seems like door will fall off or blow open. *tr
07/05/200492000207/01/2001
 Both the driver side door and front passenger side doors,door bushings went out,causing the doors to droop and cause damage to the frame latch...attempt to fix the problem was unsuccessful. the bushings need replaced and welding work needs to be done on the frame. *ak
09/01/200020000610/01/1998
 Lower ball joints wear out prematurely. *ak the consumer stated the vehicle was on its fifth set of lower ball joints and it sixth idler arm. the cruise control was inoperative, the grill guard was loose, the rear differential leaked, the door latch was inoperative, the sending unit was replaced, the battery was replaced, the door was readjusted due to a vibration, the left front hub assembly was replaced, the exhaust made a noise, the tensioner and serpentine belt was replaced, the front axle seal leaked and the intake gasket leaked. *jb
09/18/2000105/01/1999
 Consumer reporting excessive wear of brake pads and rotors, from 17,614 to 35,500 miles there were three sets of brake rotors and two sets of brake pads replace on the vehicle, and the problem reoccurs. the dealer has been notified. *nlm water leak on passenger side floor, driver side door rattles going over bumps, both front windows outer molding comes off, moldings replaced, humming noise from front wheels when coming to a stop, wheel bearing / hub replaced. *tt
11/30/2000603/02/1999
 Vehicle experiences stalling, after stalling there is a burning smell, dealer has replaced the fuel pump, crank sensor, map sensor, pcm, fuel pump module, vehicle still experiences stalling, consumer feels problem is an electrical problem. ses light flashed at times, dealer replaced coil wire. keyless entry inoperable, dealer replaced receiver, remote module, and reprogrammed transmitters. consumer states vehicle has excessive wind noise on both sides. there is a clunk when backing up and turning left or right. overhead panel goes blank in morning, when first starting vehicle, dash and gauges will not light up, and overhead compass was replaced. consumer states gas mileage is not as good as it used to be. ses light illuminated. *slc
 Power locks on hatch back door is inoperable, causing no enter or exit from that door, cause unknown. please give any further details.*ak
STRUCTURE - BODY - DOOR - HINGE AND ATTACHMENTS
02/01/20052
 Dt: the front driver side door was falling off. the way the door was designed made it impossible for hinge to hold the weight of the door. the door was repaired three times by the previous owner. each time it was repaired it did not last for much more than a year. consumer had the dealership give her an estimate. when she contacted the manufacturer, they said they might do something for her after she had the repair done. the consumer felt this was a manufacturing defect, and they should pay for the repair or replacement. there were other problems with the vehicle. the seat did not work. there were other parts of it that either broken or were breaking. *ak
07/02/2004404/06/2004
 1)component: latches/locks/linkages:hood:latch, )seats:front assembly adjustment level. 3)component: equipment:electrical:heater , 4)structure:body:door:hinge and attachments,(hand was smashed by door trying to get it to close right.these problem have been going on since april of 2004. *ak
08/01/200350000208/01/2002
 Consumer complained about a ball joint problem. it was discovered that the ball joints were defective. the consumer contacted the dealership, who was asking for $1200.00 to repair the defective ball joints. *ak the hinges on the drivers door have rusted extensively causing the door to sag when opened. *sc *jb
12/08/200355000106/04/2002
 I have 1999 chevrolet blazer with 60000 miles the drive side door has fallen down about 1 inch in the last two months sometimes i have to lift up on the door to get it to shut if this keeps up the door may fall off.*ak
07/01/2000106/26/1999
 Due to location of drainage hose, the top pin hinge on passenger and driver doors rusted out. consumer has contacted dealer. *ak the hinge bushings are showing signs of wear, the dealer admits there is a problem with the drain locations, consumer states with the corrosion present on the hinge pins there is a possibility of breaking. *slc
306/25/1999
 Door hinges/slides/rollers fail to secure the door in the open position causing injuries when door has closed on consumers. *mjs
STRUCTURE - BODY - HOOD
07/02/2004404/06/2004
 1)component: latches/locks/linkages:hood:latch, )seats:front assembly adjustment level. 3)component: equipment:electrical:heater , 4)structure:body:door:hinge and attachments,(hand was smashed by door trying to get it to close right.these problem have been going on since april of 2004. *ak
STRUCTURE - BODY - TAILGATE
12/24/1998111/01/1998
 Hatch raises to vertical, or near vertical position. opened garage while vehicle was in garage with hatch open and garage door busted hatch. exact same thing happened on a friend's suburban. hatch should only open to horizontal or angled position - not vertical. dealer charged $1300 to replace hatch!!!!!
STRUCTURE - FRAME AND MEMBERS
01/01/2001101/01/1999
 I have contacted chevrolet and they will not assume responsibility for the frame weld failing. they acknowledge the vehicle is unsafe to drive, but offer no remedy other than replacing the frame at my own expense. they could not provide me with a cost to do this type of replacement. i feel this is a potential safety issue effecting other owners. i would like to see chevrolet take responsibilty for what is obviously a manufacturing defect. i realize the vehicle is out of warranty because of miles, but it is a 2 year old vehicle which a reasonable person should expect the frame to last beyond that time.*ak
03/05/2000410/01/1999
 Internal bracing is inadequate and has, as a result of the apparent lack of structural integrity of the mounting brackets (and internal mounting structures), caused a few welds to begin splitting and begun to cause denting in the sheet metal on the side of the vehicle.
12/20/19981
 Pulley makes squealing sound and could cause drive belt failure.... tire would rub on iner fender well when making turns. front suspension make a squeeking or creeking sound at any speed when going of any type of bump.....driver side seat adjustment lever broke off in my hand when trying to adjust front seat position.