Chevrolet Camaro 1975
Model Camaro made in 1975 by Chevrolet got 1 investigation as well as 3 recalls. The car had one investigation (vehicle speed control). There were some recalls concerningengine and engine cooling and equipment.
Model 1975
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
ENGINE AND ENGINE COOLING - COOLING SYSTEM - FAN | ||||||||||||||||
75V087000 | GENERAL MOTORS CORP. | V (Vehicle) | 31073 | 05/14/1975 | MFR | GENERAL MOTORS CORP. | 05/13/1975 | 10/12/1979 | ||||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Chevrolet campaign no 75-c-11.equipped with 350 cid v8 engine andair-conditioning.possibility of failure of the flexble fan blade.thefailure is the result of fan blade resonance which occurs at 42 cycles persecond or at approximately 630 engine rpm.failure of the fan blade couldresult in a hazard to tune-up personnel should failure occur with the enginerunning and the hood open.(correct by inspecting and replacing fan blade). | |||||||||||||||
EQUIPMENT | ||||||||||||||||
07E088000 | HONEYWELL INTERNATIONAL, INC. | E (Equipment) | 121680 | 11/08/2007 | MFR | GENERAL MOTORS CORP. | 10/24/2007 | 10/30/2007 | ||||||||
Defect Summary | Certain honeywell fram racing brand hp4 and hp8 oil filters that were manufactured from may 25, 2006, through september 14, 2007, and sold for use as replacement equipment for vehicles list above. the affected filters are marked with a date code a61451 through a72571 sequentially. the date code and part number appear on the filter housing. fram racing hp4 and hp8 oil filters not bearing a date code in this range are not affected by this recall. the gasket of the oil filter becomes more pliable under high temperatures and pressures. | |||||||||||||||
Consequence Summary | This condition may cause inadequate sealing and loss of engine oil, possibly resulting in a fire. | |||||||||||||||
Corrective Summary | Honeywell will replace the affected oil filters free of charge. the recall began during november 2007. owners can contact fram customer service toll-free at 1-800-890-2075. | |||||||||||||||
Notes | Customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov. | |||||||||||||||
STEERING - WHEEL AND HANDLE BAR | ||||||||||||||||
75V094000 | GENERAL MOTORS CORP. | V (Vehicle) | 3069 | 05/16/1975 | MFR | GENERAL MOTORS CORP. | 05/21/1975 | 10/12/1979 | ||||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Chevrolet campaign no 75-c-13.buick campaign no 75-c-9.possibility thatunits may have been assembled with insufficient torque on the steering potjoint clamp bolt/nut which secures the intermediate steering shaft to the uppersteering shaft.if this condition exists, it may allow the shafts to separateand result in loss of steering control.(correct by inspecting and properlytorquing the steering connections whree necessary.) |
Investigations
NHTSA ID | Manufacturer | Date open | Date close | Subject | Recall campaign | |
---|---|---|---|---|---|---|
VEHICLE SPEED CONTROL - LINKAGES | ||||||
DP85025 | GENERAL MOTORS CORP. | 06/14/1985 | 11/27/1985 | FUEL LEAKAGE AT FILLER NECK | ||
Fuel leakage at filler neck |