Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SERVICE BRAKES, HYDRAULIC - ANTILOCK - ABS WARNING LIGHT
35213521E10016711Anti-lock braking system (abs) light on speedometer may be erratic. diagnostic trouble code (dtc) c0055 c0235 c0236 or c0237 stored in the ebcm. *tt 1998-2008 all chevrolet, gmc, buick, and oldsmobile mid-sized trucks and utilities. 1909/28/2005
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
06100010/06/2000617715Subject regarding brake system improvements applied to 3,500 series single rear wheel vans only. *tt03/24/2001

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
SERVICE BRAKES, HYDRAULIC - POWER ASSIST
EA04012GENERAL MOTORS CORP.04/30/200402/28/2005HYDRAULIC PUMP FAILRES05V005000
 Gm is conducting a recall on all subject vehicles build between may 1999 and october 14, 1999.significant changes were incorporated into production in early october 1999, and vehicles built after that date have lower warranty failure rates.the complaint and warranty data appear to support the effectiveness of these changes. gm made additional changes in november 1999, february 2000, may 2001, and february 2004.odi will continue to monitor this problem and will take further action, if warranted, in the future.for further technical details see the attached engineering analysis report.

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, HYDRAULIC
03/03/200420000403/31/2001
 Brakes keep wearing out on this vehicle. 4 brake jobs and it only has 55,000 miles and we baby this van.*ak
11/02/200254920208/18/2000
 While driving , the driver and passenger side seat snapped off the base, on different occasions. *ak the seat belts unlatched by themselves, the rear bench seat failed to stay tight, the side doors were difficult to open and the outside mirrors vibrated and the brakes were faulty *jb *nm
SERVICE BRAKES, HYDRAULIC - ANTILOCK
08/15/2000
 Front brakes are wearing out prematurely, it causes front wheel to lock up. dealer notified. feel free to provide any further information. *ak
11/11/2000
 While driving about 30 mph applied brakes, pedal felt spongy and went to the floor. no braking action, hit vehicle in front. $ 1200.00 damage. dealer said there was nothing wrong with brakes. consumer then went to another dealer, was told rear brakes were not functional. chevrolet took no responsibility for accident.*ak
06/01/20011
 When traveling there is no certain speed, and steering is hard to steer. when applying brakes vehicle doesn't stop, results in extended stopping distance. *ak shaft broke in power steeting pump and front brakes failed. *yh
 Gladiator conversion, there is problem with right wheel which is causing both brakes to wear out every 1500 to 1800 miles. dealer has changed spring coil twice on right wheel and once in the left wheel, but problem still occurs.*ak
10/01/20001309/16/2000
 There is a clunking noise when applying brakes at speeds of 20 mph, and under on both corners of front end. after 13 attempts of trying to fix defect , manufacturer is buying vehicle back. *ak *slc
01/08/20011
 Braking system malfunctioned which caused more wear and tear on brake pads, resulting in extended stopping distance. *ak the premature wearing of the brake pads required the rotors to be turned. *yh
01/01/2000
 Major problem with braking system. company will not fix. *ak
10/25/1999
 Vehicle was pulling hard to the left while applying brakes from 0-45 mph.also, abs brakes intermittently would fail to operate and engage while pulling from a stop position. vehicle has been in/out of dealer's shop on three occasions, and consumer was informed that nothing could be found. provide further details.*ak
04/04/2000
 When brakes are applied vehicle pulls to the right. dealer has inspected the vehicle. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
06/23/20008
 Repairs to the brakes 8 times, melted three sets of abs sensors, burnt two sets of calipers and bearings out, melted the hub caps off twice. made eight attemps to repair to no avail.
01/25/20014
 Intermittently when brakes are applied vehicle pulls. dealer has inspected and repaired vehicle, and the problem has not been corrected. *ak after numerous failures, the consumer was negotiating with the dealer for trading in the vehicle. *yh
02/28/2000302/28/2000
 Vehicle has been in repair shop three times pertaining to brake pads . brake pads are too weak, and there is excessive brake wear on front wheels. *ak the dealer says that the brake is too small for the vehicle because of faulty design. excessive brake dust accumulated on front wheel rims. brake rotors show signs of excessive heat generated by brakes. *yh
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
08/02/2003107/07/2003
 While driving front brakes would get too hot, causing extended stopping distance. dealer has been notified. *ak the passenger front side wheel speed sensor melted, the rotors showed many cracks in the surface, and the caliper had been replaced. the front wheel bearings showed signs of heat. the consumer requested to be informed about this problem. *scc *jb
08/15/2000
 Front brakes are wearing out prematurely, it causes front wheel to lock up. dealer notified. feel free to provide any further information. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS
01/08/20011
 Braking system malfunctioned which caused more wear and tear on brake pads, resulting in extended stopping distance. *ak the premature wearing of the brake pads required the rotors to be turned. *yh
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR
05/01/2002
 There was vibration when applying brakes. front rotors have been turned once, then replaced due to warping.*ak
SERVICE BRAKES, HYDRAULIC - PEDALS AND LINKAGES
3
 Poor design of the brake pedal caused the drivers foot to slip off the brake, consumer had the pedal extended. yh