Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SERVICE BRAKES, AIR - ANTILOCK - ABS WARNING LIGHT
PIT-4648B06/01/201010036515Chevrolet/gmc: abs light and/or service stability message on with dtc c0045 and/or c0050.. this code may be caused by a wire pulling out of the crimp on a terminal at the x413 or x414 connector. *pe03/25/2011
SERVICE BRAKES, AIR - ANTILOCK - CONTROL UNIT/MODULE
SB-09-05-25-00207/01/200910032294Gmc/chevrolet: unintentional stabilitrak/abs activation on banked/curved road. (reprogram electronic brake control module). the stabilitrak activates on banked curved roads during normal driving conditions for the surface. impact to brak03/01/2010
SERVICE BRAKES, HYDRAULIC - ANTILOCK - CONTROL UNIT/MODULE
08052500101/01/200810024423False traction control system (tcs) activation at low speeds, dtc c0710 set (reprogram electronic brake control module (ebcm)) with rpo jl4 and built prior to august 13, 2007. *nj04/14/2008

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, HYDRAULIC
08/31/200936000
 My rotors keep warping and endangering my life!!!!!!!!!!!!!!!! i am on my fourth set of rotors in 84,000 miles!!!! and on top of that i have the original brake pads. as a matter of fact from 14,000 mi to 94,000 my brake pads have not worn at all. i had to cut the rotors at 30,000, and then at 50,000 they were warped and too thin to resurface. i replaced them again. at 80,000 i had to have them cut because they were warped. then at 85,000 i had to have them replaced again because they were warped. my rotors get to hot that when i brake, my whole steering column shakes and the vehicle swerves to hard that i can barely stay within the lines on the interstate. i feared for my life. i have tried to have chevy look into this and every time they just slap new rotors on and send me on my way. they give a 12,000 mile warranty on rotors and they are warping in half that time. chevy has had to replace them for free under warranty 3 times and i have had to pay once. i feel like all they want to do is slap new parts on instead of finding the problem or having a recall! i have spoke to corporate, who agrees something else is wrong but they won't do anything about it. they say they've checked everything. i finally got the service supervisor to admit to me that these vehicles have crappy metal rotors from china and that they have been failing in the safety lane tests for their ability to brake and stop in the required distance. i feel that my vehicle was overrated to it's weight limit and it cannot stop itself if it has any kind of load in the cargo area. i have already filed a complaint with the us department of transportation highway safety administration. i have also worked with a gentleman from the corporate office, he seemed to be on my side but was unable to do anything. my case #'s are 71-869-1333444.