Consumer Complaints
Fail date | miles | occurences | Purchase date |
---|---|---|---|
SERVICE BRAKES, AIR - ANTILOCK - CONTROL UNIT/MODULE | |||
06/08/2002 | 57000 | 09/29/1999 | |
Abs brake failure | |||
SERVICE BRAKES, HYDRAULIC - ANTILOCK | |||
12/15/2001 | 15 | 04/01/1996 | |
My abs brake system comes on under 10mph during normal braking. there is no panic stop involved during the normal braking event. this situation is becoming very troublesome and i'm worried as to whether i'll be able to pull my travel trailer.*ak | |||
11/01/2000 | 1 | 05/01/1996 | |
Don't know the date of or mileage at failure! no safety defec tmentioned. *ak | |||
04/01/1996 | |||
When brakes are applied, the brakes become weak, resulting in extended stopping. distance, brake system is weak, too much pedal effort. *ak | |||
When the brakes were applied, the pedal went to the floor, causing extended stopping distance which resulted in a collision. the dealer has been notified. *ak *yc | |||
05/01/1998 | 1 | ||
In bumper to bumper traffic vehicle in front stopped suddenly. truck hit brakes (abs); vehicle kept going & rearended vehicle in front. took to dealer & mechanic repaired abs brakes. was not told what caused problem. *ak | |||
12/01/1996 | |||
Brakes: brakes pulsating when attempting to stop. driving and attempting to stop and the vehicle kept rolling and would not stop. *ak | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC | |||
03/10/2002 | 1 | 02/01/1996 | |
The hub of the brake rotor became separated from the rotor during vehicle operation. this resulted in a severe vibration, loud grinding noise and a partial lose of control during braking. when the brakes were applied, essentially, one of the calipers was rendered inoperative as the disc it clamps on had separated from the hub. the hub is sheet metal welded to the disc vs. a complete casting as has been previously the standard for this part. weld failed resulting in the catastrophic failure of this critical brake component. additionally, had this failed at speed, it is unknown what other damage may have resulted to the braking and/or steering systems.*ak | |||
12/01/1996 | |||
When making a firm stop (not panic) when tires pass over a ridge on dry road surface, pass over a sewer cover (or any kind of road irregularity) abs activates at approx 20mph or less.braking forces lessens for about one truck lenght and pedal vibrates a little. it seems like abs stays on even though the road is dry and smooth. load in the bed is about 400lbs, tires are good, brakes are clean. dealer did not want to go for test drive...said there may be a recall for this. truck has been at dealer about a dozen times the first year and a half for rear brake pulsation and lock up. went to arbitration...performing as designed' even though 4 drums and 6 pairs of shoes replaced . cover. *ak | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR | |||
09/18/2003 | 82000 | 1 | |
Upon making a left turn brakes locked up, consumer lost control of vehicle and went into a ditch. this was due to the brake rotors breaking and jamming into the brake. this failure was caused by poor design of the rotors, per the dealership. | |||
11/29/1999 | 1 | 01/01/1996 | |
Stepped on brakes and left front rotors broke loose from its' hub, causing a severe reduction in braking, and a hard pull to the right. brake shop says they've never seen this before. also, right front rotors appear to have stress cracks at rotor/hub juncture. contacted general motors, no satisfaction. *ak | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM | |||
6 | 02/01/1996 | ||
No summary | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER | |||
5 | 04/01/1999 | ||
No summary | |||
SERVICE BRAKES, HYDRAULIC - POWER ASSIST - VACUUM | |||
09/14/1999 | |||
Due to defective brake booster, the braking system malfucntioned, causing extended stopping distance which may result in a crash. dealer replaced the brake booster. *ak |