Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
STEERING - GEAR BOX - SHAFT SECTOR
96V195000GENERAL MOTORS CORP.from 01/01/1987 to 01/30/1995V (Vehicle)14459810/08/1996ODIGENERAL MOTORS CORP.10/08/199610/17/1996
Defect SummaryThe intermediate steering shaft loosens at the steering shaft to steering gear coupling. with this looseness, the yoke pinch bolt can wear on the splines of the shaft until there is no longer an interference between the splines and the bolt.
Consequence SummaryThis condition can cause body to chassis movement allowing the steering shaft to separate from the steering gear which can result in a loss of steering control.
Corrective SummaryDealers will retorque the upper and lower bolts to correct specifications.
NotesVehicle description:postal vehicles only. owner notification:owner notification is expected to begin during late october 1996. note:owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet at 1-800-222-1020.also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

Consumer Complaints


Fail datemilesoccurencesPurchase date
STEERING
05/09/20032094101
 Steering wheel turned 180 without warning and locked up. while driving the steering column turned 180 degrees without warning and locked up. the vehicle was taken to the dealer where it was determined that the bolts were loose. the dealer reinstalled them with thread lockers. *nlm
STEERING - WHEEL AND HANDLE BAR
04/15/2001
 Steering wheel is coming loose. *ak
 While driving at 45 to 50 mph steering column broke, causing a loss of steering for a short period before coming to a stop. their is a old recall for the problem, but it does not apply to this vehicle. dealer has been contacted. *ak