Consumer Complaints


Fail datemilesoccurencesPurchase date
ELECTRONIC STABILITY CONTROL
01/19/201161600
 January 2011: i'm having the exact same problems with my 2007 suburban as the complaint filed on june 13, 2010. this is a problem that i had when the vehicle was new, as well. the engine seemed to be sputtering while idling today and by the end of the day it lost its stability control with warning signals illuminated on the dash. the transmission is bucking out of 1st gear and begins to grind slowly from a stop. i concur that this problem should be recalled, as it poses great danger on the road.
05/28/201081171
 Engine started idling rough and the 'engine light' came on and stayed on.then the next day, went to start car and it was really idling rough, sputtering, then stablitrak light and 'traction control off' light and abs lights all came on. the car felt like it was going to die until about 20 mph, then made a jerking motion and ran fine. this continued to happen until i took it to the shop. they kept it for a week, replaced the fuel pump, but this did not fix the problem. the car still runs rough and the lights still come on whenever i have to idle, intersections, etc... i have benn reading and i am concerned that there is no fix for this problem. i believe it is a faulty engine/electrical issue and there needs to be a recall. this is completely dangerous, if my stabilitrak system goes off and i am on unstable ground, rain, snow, etc... it will cause my car to brake and i will loose control of my car. i am worried that it is going to die in an intersection, since it has a hard time coming out of an idle with any power.
03/25/20089545109/05/2007
 While driving approx. 20 miles an hour there was a loud thud and the service engine light and the traction control light both came on at the same time. the engine began to miss on acceleration and shifting between 1st and 2nd gears was so rough it shook the truck. the truck is only 6 months old and has 9, 000 miles on it. the suburban was driven to the dealership for repairs it took 3 days for them to diagnose computer relay was affecting the traction control system and #7 cylinder had seized. the entire cam shaft is going to be replaced. est. work will take 7-10 days. *tr