Recalls
| Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER | ||||||||||||||||
| 90V162000 | CHRYSLER CORPORATION | from 07/01/1990 to 08/01/1990 | V (Vehicle) | 18000 | 08/24/1990 | MFR | CHRYSLER GROUP LLC | 09/04/1990 | 09/14/1990 | |||||||
| Defect Summary | Front disc brake caliper guide pin bolts may not have been adequately torqued and could loosen. | |||||||||||||||
| Consequence Summary | This could cause reduced braking effectiveness and couldresult in an accident. | |||||||||||||||
| Corrective Summary | Properly torque front brake caliper guide pin bolts to 250 pounds. | |||||||||||||||
| Notes | System: front disc brake calipe guide, pin bolts.vehicle description: passenger cars. | |||||||||||||||
Investigations
| NHTSA ID | Manufacturer | Date open | Date close | Subject | Recall campaign | |
|---|---|---|---|---|---|---|
| SERVICE BRAKES, HYDRAULIC | ||||||
| EA95016 | CHRYSLER GROUP LLC | 05/26/1995 | 06/24/1996 | ABS BRAKING MALFUNCTION | 96V099000 | |
| There is no summary currently available | ||||||
Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| SERVICE BRAKES, HYDRAULIC - ANTILOCK | |||
| 03/22/2006 | 177000 | 1 | 06/01/2003 |
| Dt*: the contact stated the brake pedal must be stood upon for the vehicle to stop. according to the dealership, the abs was replaced prior to the contact's purchase. the vehicle has not been seen by a mechanic for this problem. | |||
| 09/18/2001 | 5 | ||
| On five occasions vehicle lost complete use of brake system when abs and brake light came on simultaneously. vehicle been to dealer's shop on four occasions, and problem was reoccurring. vehicle back to dealer's shop at this time for the fifth time. feel free to provide any further information. *ak | |||
| 05/18/1996 | 1 | ||
| Anti lock brakes locked up resulting in vehicle collision. | |||
| 08/28/1995 | |||
| The abs system fails on the vehicle at a simple stop they do not stop the car. please describe. tt | |||
| 07/15/1995 | |||
| Ea95-016 active, failure of abs braking system, actuator that controls the abs system is faulty. tt | |||
| 04/01/1995 | 2 | ||
| The abs brakes failed while trying to stop the vehicle. tt | |||
| 05/12/1995 | 2 | ||
| Abs system failure, intermittent problem, brakes feel spongy. tt | |||
| 01/01/1994 | 2 | ||
| Abs failed, had to be replaced twice, also abs light came on. tt | |||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS | |||
| 05/18/1996 | 1 | ||
| Brakes locked up, causing accident. | |||
| 1 | 06/15/1991 | ||
| Brakes failed. | |||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER | |||
| 1 | 12/07/1995 | ||
| Brake indicators on, recall on brake system however dealership refused repairs.(90v-162). yh | |||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM - WHEEL CYLINDERS | |||
| 09/10/2005 | 125555 | 4 | 09/05/1996 |
| This is the fourth time this has happened to this car. it is a 1991 chyrsler new yorker. the rear brakes have one flat pin that comes out of the wheel cylinder. this small flat pin pushes on a thin flat part of the rear brake shoe. because the pin in flat and does not have the fork design like the older models, the pin slips off the brake shoe and over extends. this causes loss of the brake fluid and the loss of the rear brakes. i also now have pictures of what actually occurs. *jb | |||
| SERVICE BRAKES, HYDRAULIC - PEDALS AND LINKAGES | |||
| 10/01/1994 | |||
| The brake system warning light was illuminated constantly and a substantial amount of brake pedal force was required to stop vehicle. two years after repairs were made chrysler issued a recall to correct problem. | |||
| SERVICE BRAKES, HYDRAULIC - SWITCHES - BRAKE WARNING | |||
| 09/18/2001 | 5 | ||
| On five occasions vehicle lost complete use of brake system when abs and brake light came on simultaneously. vehicle been to dealer's shop on four occasions, and problem was reoccurring. vehicle back to dealer's shop at this time for the fifth time. feel free to provide any further information. *ak | |||
| 10/01/1994 | |||
| The brake system warning light was illuminated constantly and a substantial amount of brake pedal force was required to stop vehicle. two years after repairs were made chrysler issued a recall to correct problem. | |||