Consumer Complaints


Fail datemilesoccurencesPurchase date
SUSPENSION
10/01/20001
 Consumer stated the torque tube cracks inside of weld on left hand side of vehicle which weakens the trailing arm. dealer contacted. nlm *yh
02/03/1999
 Consumer was driving approximately 35mph when he heard a metal grinding noise, at that time consumer decided to park vehicle and tied it in. *ak
SUSPENSION - FRONT
1
 The entire front end of the vehicle feels unstable while driving. nlm
08/10/1993
 Vehicle vibrates, difficult to drive. dealer cannot locate problem. tt
1
 Front end noisy. *ak
SUSPENSION - FRONT - CONTROL ARM
11/21/199604/26/1994
 Vehicle in parking lot ready to exit, the front driver's side wheel fell off due to broken ball joint/axle shaft. has never seen anything like it. sending copy of invoice. *ak
SUSPENSION - FRONT - CONTROL ARM - LOWER BALL JOINT
 While traveling at low speen noticed vehicle would not move. consumer looked around vehicle and noticed lower ball jont broke. dealer has been contacted. please provide further informaton. *ak
SUSPENSION - FRONT - SPRINGS - TORSION BAR
09/08/1999204/01/1994
 Dealer welded ends of broken torsion bars to trailing arms 9/8/99 the weld broke 8/30/00 chrysler says it is not a manf. defect. the car was not involved in an accident so what caused it to break 2 times? it sure seem to me like a manaf. defect. one of the repair places i had look at it thought the entire rear end needs to be replaced. was told that in present condition when going at 60-70 mph & turn one may lose control. also, the rear end is wobelly.
SUSPENSION - REAR
09/15/199909/01/1994
 While driving at a speed of 20 mph passenger's side rear wheel began to wobble, causing the consumer to lose control . the dealer was unable to fix the problem because of too many broken welds on rear wheel. *ak
09/13/1999101/01/1995
 The welds on the back wheel failed causing vibration. all the welds did not fail, but enough failed so the suspention could not be repaired. the failure was so bad a complete new read suspention had to be done. a dealer comment that this is a common problem caused me to fill out this report. this has been reported to chrysler ref 630-5949. i have not seen a failure such as this in any vehicle i have owned in the past 40 years. crysler seemed unconcerned about this issue.
03/09/1998104/01/1994
 Rear axel broke causing problem with mobility.
03/09/1998104/01/1994
 Rear axle broke causing poor mobility.
SUSPENSION - REAR - AXLE - NON-POWERED AXLE ASSEMBLY
12/13/200470349203/13/2003
 Rear axle: rear cross-member: weld separation; incident #1 7/24/97 mileage 32,640, incident #2 12/13/04 mileage 70,349. *ak