Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
STEERING
190010103/23/20011900300619127Some owners may experience loose feel or clunk in the steering wheel as the wheel is moved from side to side. *tt05/15/2001
1900300B10/06/2000190300A618868Some vehicles may experience loose feel or clunk in the steering wheel as the wheel is moved from side to side. *tt05/03/2001
004209/13/2000615695Advance service information for loose steering. *tt01/28/2001
190300A09/08/20001903006092235Experiencing loose feel or clunk in the steering wheel as the wheel is moved from side to side. *tt11/29/2000
19030006/02/2000614153A condition may exist where a loose feel or clunk in the steering wheel as the wheel is moved from side to side. *tt09/29/2000
19089912/31/1999610017Information when servicing the inner tie rod end to steering gear attachments. *tt04/14/2000
19039702/14/199752029Steering gear cold - squawk noise. *tw07/17/1997
STEERING - WHEEL AND HANDLE BAR
08439510/01/199546368Creaking or clicking noise fron steering wheel area when pushing or pulling on the steering wheel, usually when entering or exiting the vehicle. bulletin involves installing four tape insulating pads between the driver airbag module and th04/25/1996

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
STEERING
EA99031CHRYSLER GROUP LLC10/29/199909/13/2001STEERING SYSTEM RACK AND PINION
 There is no summary currently available
PE99044CHRYSLER GROUP LLC06/28/199910/29/1999STEERING SYSTEM RACK AND PINION
 Consumers have submitted 36 reports involving failures of the tie rod bushings or bolts at the attachment of the tie rod to the steering rack and pinion unit in the subject verhicles.ten of these incidents were reported to have resulted in a loss of vehicler control.additionally, 27 reports have been received which allege failure of the steering gear rack and pinion unit, including five which resulted in a loss of vehicle control.no vehicle crashes were reported, but the failures are of concern in that they may pose a compromise to steering control.a prelimiary evaluation has been opened on this issue.
STEERING - COLUMN
DP03002CHRYSLER GROUP LLC05/07/200307/22/2003STEERING COLUMN SEPARATION
 Mr. larry a. sackey submitted a petition to the national highway traffic safety administration (nhtsa) by letter dated april 18, 2003, requesting that nhtsafurther investigate the defective collapsible steering shaft system on 1987-1995 vehicles manufactured by the daimlerchrysler corporation.in part because of 49 cfr

Consumer Complaints


Fail datemilesoccurencesPurchase date
STEERING
11/16/20081350001
 Complete steering failure on 1995 chrysler new yorker. *tr
04/21/2003324271
 While traveling at normal speed, the driver applied the brakes and the front end of the vehicle vibrated out of control. the steering was very loose. *jb
STEERING - HYDRAULIC POWER ASSIST SYSTEM
05/29/2001
 Steering failure because bolts have sheared off. consumer stated that tie rods has been replaced twice prior to this incident. *ak
12/20/19950
 Loss of power steering, causing loss of control/fluid leakage. *sd
STEERING - LINKAGES
09/01/2000
 Consumer was at a gasoline station. as he pulled out heard a noise, and lost control. there wasn't any steering. steering wheel was going around in circle. dealership was notified, there were no injuries. *ak the loss of control of the vehicle was caused by snapping in half of the bolt that hold the steering rack together. this vehicle had been involved in accident before this customer purchased it. *yh
10/04/2000203/01/1995
 Both tie rod ends at steering gear box replaced. failure due to wear of rubber bushings part no. 501825aa. this should be considered a dangerous situation which could lead to accidents , especially at highway speeds. reported failures believed to be more numerous than chrysler will admit. see oid; id 8449555 8/1/99, id 716813 1999, id 852875 10/29/99, id 715247 at 59,000 miles 9/1/99. cost to repair $589.00.
12/28/1999108/01/1999
 Componant failure was the two bolts that secure tie rods to rack and pinion steering sheared off, both at the same length. this happened while backing out of a parking space. in turn, both tie rods, one to each wheel became totally disabled and all steering was lost. removed the rack and pinion and foind no defects with operation. replaced with a remanufactured one with new bolts from the dealer. cause remains undetermined. *ak
09/01/1999201/01/1999
 Both tie rod ends at steering gear box had to be replaced. car would wonder all over road.. asked dealer why they failed at 59000 miles, just a wear point.. i've had to many other cars and trucks and never had a tie rod problem and this car has both fail at the same time....
10/29/1999
 Had new tires put on. noticed that the front tires were wearing out when making a right hand turn. the wheels would whistle, and when coming down a hill and applying brakes,the front wheels shimmied very badly, especially when traveling at 45mph. contacted the dealer, dealer inspected vehicle, and told consumer that bushings/tie rods and ball joints wore out *ak
STEERING - LINKAGES - TIE ROD ASSEMBLY
08/20/2001111/01/1994
 Both inner tie rod bushings and attached rods had to be replaced, the right side had failed and fallen out(rubber bushing), the left side bushing was fractured and worn out causing play in the right side wheel steering, both items were replaced and wheel alignment done.
05/29/2001
 Steering failure because bolts have sheared off. consumer stated that tie rods has been replaced twice prior to this incident. *ak
08/01/1999
 When traveling at any speed the front end shakes, causing poor control. consumer has contacted the dealer, dealer has replaced tie rod end. please provide any further details. pe 99-044. *ak
STEERING - RACK AND PINION
07/20/2001101/01/1996
 While backing out of a parking place the two bolts that hold the short rack to the frame sheered off at the frame causing complete loss of steering. the new bolts obtained from chrysler were gold in color instead of black like the originals which indicated to my mechanic that the new ones had a different heat treating process. i have the bolts and pieces plus pictures of same and will provide either upon request. had i not been in a parking lot this could have been a desaster. while i have received other recall notices for this car i never received one on this.
05/04/200101/01/2000
 Steering noise when turning wheel left to right, bushings are bad and rack and pinion needs replaceing according to mechanic said such wear is unusually for car with such low miles - dealer, maker aware of problem said it will not do anything unless a recall is forced on them - lose of steering is a safety issue
03/28/19940
 It is extremely hard to steer when turning a corner. dealer said consumer needed to replace rack and pinion steering. consumer claimd it's dangerous to drive on the street. *ak