Chrysler Sebring Coupe 1996
Model Sebring Coupe made in 1996 by Chrysler got 14 consumer complains. Consumer complaints with reference, among others things, to power train, suspension and vehicle speed control.
Model 1996
Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| POWER TRAIN - AUTOMATIC TRANSMISSION - PARK/NEUTRAL START SWITCH | |||
| While vehicle is parked is able to shift gears without key in ignition switch.*ak | |||
| SUSPENSION | |||
| 11/01/2010 | 1 | ||
| 1996 chrysler sebring coupe. consumer writes regarding chrysler employee lunch break activities *tgw the consumer stated he experienced mechanical failure while driving 20 mph. the left front ball joint suddenly separated and jammed the tire up into the fender well at an awkward angle. the consumer stated it cost over $800 to replace the suspension parts on both sides. the consumer stated the reason for the failure, was due to lack of lubrication, because years ago, manufacturers chose to delete the inexpensive grease fitting on suspension parts and instead chose substituted sealed ball joints that were subject to failure. *jb | |||
| SUSPENSION - FRONT - CONTROL ARM - LOWER ARM | |||
| 01/26/2004 | 146000 | 1 | 04/15/1996 |
| On december 2000, the lower control arms of the suspension of my 1996 chrysler sebring were replaced. the replacement was due to noise and steering problems of the car. the lower control arms were then replaced due to the complaint and a recall on the lower control arms. on 26 january 2004, the lower control arm on the drivers side of the car failed as i drove in downtown atlanta. the failure caused the cv axle to dislodge from the engine and damage the braking system and body of the car. i the proceeded to contact chrysler for an investigation. the case # is 120-241-89. the investigation was conducted 9 february 2004. *ak | |||
| SUSPENSION - FRONT - CONTROL ARM - LOWER BALL JOINT | |||
| 08/09/2006 | 129000 | 1 | |
| Dt*: the contact stated while driving 65 mph, the front end of the vehicle shook, which caused a loss of vehicle control. the vehicle was taken to a private repair shop, who determined that the rubber on the front lower ball joints had split. there was a nhtsa recall # 99v066003 which pertained to the lower ball joint. the vehicle was not included in the recall due to the vin. | |||
| 05/05/2004 | 120000 | 10/20/1995 | |
| On may 5, 2005 while on interstate 95 in virginia the low ball joint on the right front side of my 1996 chrysler sebring seperated from my vehicle causing me to lose control on the vehicle and stopping in the fast lane on the busy interstate highway unable to move it causing damage to the body of the vehicle and the transmission, the year before the same thing happened to my vehicle due to a recall on the ball joints and it was replaced in a rush by a chrysler dealer, when it happened in may chrysler refused to repair the recall and refused to pay for my rental car fees and i could not afford to repair the vehicle or pay for the rental car and now i have no vehicle all because of shoty work done by chrysler. | |||
| 08/13/2004 | 100465 | 3 | 08/30/2003 |
| Was driving down the road approximately going 65 mph. the front drivers side lower ball joint broke, causing the whole front of vehicle to drop to the ground. slide a cross two lanes of traffic and 1 block later vehicle came to a stop. also having problems with rear struts. i have had all parts replaced. the only damage to vehicle is the paint scrapes to the front lower part. *jb | |||
| 05/25/2003 | 136000 | 1 | 01/03/2000 |
| Last week while driving in my 1996 chrysler sebring on the freeway my lower ball joint disconnected from my car sending car out of control. the wheel ended up underneath my car the rim spark and lighted the tire on fire.*ak i fractured my knee in the accident and have extensive damage to my vehicle i dont not feel safe in this car, i am filing a suit against chrysler this should of never happened. i need info on how to deal with this matter | |||
| SUSPENSION - FRONT - WHEEL BEARING | |||
| 4 | |||
| Consumer states front wheel bearing went bad twice, and the rear wheel bearing also went out twice.*jb | |||
| SUSPENSION - REAR | |||
| 08/13/2004 | 100465 | 3 | 08/30/2003 |
| Was driving down the road approximately going 65 mph. the front drivers side lower ball joint broke, causing the whole front of vehicle to drop to the ground. slide a cross two lanes of traffic and 1 block later vehicle came to a stop. also having problems with rear struts. i have had all parts replaced. the only damage to vehicle is the paint scrapes to the front lower part. *jb | |||
| SUSPENSION - REAR - AXLE - NON-POWERED AXLE ASSEMBLY | |||
| 4 | |||
| Consumer states front wheel bearing went bad twice, and the rear wheel bearing also went out twice.*jb | |||
| VEHICLE SPEED CONTROL | |||
| 12/01/2004 | 6 | 09/01/2004 | |
| Dt: the contact owns a 1996 chrysler sebring couple lx. the throttle control is sticking. if coming to a stop the vehicle will continue on at a full throttle. the contact contacted chrysler about recalls, and they said there were no recalls. the main computer had to be replaced, but that replacement was not related to this problem. the vehicle was taken to a repair shop, and they told the contact that there were false signals from the idle air control solenoid to the main computer, causing the throttle control to stick. the vehicle had not been taken to the dealership yet. he wanted to contact nhtsa first. this problem began nine months ago, and occurred six times, generally at speeds less than 10 mph. *ak *nm | |||
Car dealers selling
| State | City | Zip | Name | Phone |
|---|---|---|---|---|
| CA | LOS ANGELES | B & M AUTO | 323-660-4404 | |
| CA | ONTARIO | CORONA MOTORS | 9093955554 | |
| NV | LAS VEGAS | EASTERN AVENUE MOTORS | ||
| WI | MADISON | 53711 | WAYNES AUTO WORLD | 6082714234 |