Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| EXTERIOR LIGHTING | |||
| 03/18/2011 | 100000 | ||
| Tl*the contact owns a 2005 dodge 2500. the contact stated that the turn signals are malfunctioning, when he turns the right turn signal on the left one blinks and vice versa. the vehicle was taken to the dealer who did not diagnose the problem. the manufacturer was not contacted. the vehicle was not repaired. the failure and current mileage was 100,000. | |||
| 03/18/2011 | 100000 | ||
| Tl - the contact owns a 2005 dodge 2500. the contact stated that the turn signals are malfunctioning. he stated that when he turns the right turn signal the right one blinks and vice versa. the vehicle was taken to the dealer who have not diagnosed the problem. the manufacturer was not contacted. the vehicle was not repaired. the failure and current mileage was 100,000. pm | |||
| 11/20/2009 | 59133 | 1 | |
| 2005 dodge 2500 power windows on the pass. side front pass. go down don't come up, driver side rear pass. window sometimes works and sometimes doesn't from the drivers door switches, open the same door and the interior light doesn't come on, third brake light works sometimes, windshield wipers act as if you have them on the constant cycle when it is in the intermittent cycle, blend door does not change from floor to vent or defrost. *tr | |||
| 01/10/2009 | 90000 | 1 | |
| While driving my 2005 dodge ram truck, i have recently noticed a malfunction with the indicator lights. when i indicate a right turn from the indicator switch, the left indicator light starts to flash. additionally, when i indicate a left turn from the indicator switch, the right indicator light starts to flash. currently the malfunction occurs approximately once per 10 uses of the indicator switch. extremely difficult for the owner to spot this type indicator malfunction. potential to be struck by another vehicle is extreme since surrounding vehicles believe you are turning one direction when in fact you turn the opposite way. initially i disassembled the multifunction switch in question and slightly bent the spring contract slides to ensure proper contact was being made. this worked for approx. 6 months however the problem is now re-occurring. i've recently purchased a new multifunction switch $140 which i intend to install, however i would like confirmation it is designed in an inherently safe way so that this issue will never be able to occur again. *tr | |||