Dodge Charger 1975
Model Charger made in 1975 by Dodge got 2 recalls. There were some recalls concerningfuel system, gasoline, vehicle speed control.
Model 1975
Recalls
| Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| FUEL SYSTEM, GASOLINE - CARBURETOR SYSTEM | ||||||||||||||||
| 78V020000 | CHRYSLER CORPORATION | from 08/01/1974 to 04/01/1977 | V (Vehicle) | 370000 | 03/10/1978 | ODI | CHRYSLER GROUP LLC | 01/24/1978 | 10/12/1979 | |||||||
| Defect Summary | When the accelerator pedal on the involved vehicles is depressed and the accelerator pump is activated, a distorted accelerator pump seal in the carburetor may prevent the pump from delivering the proper amount of fuel. | |||||||||||||||
| Consequence Summary | ||||||||||||||||
| Corrective Summary | Dealer will replace the carburetor accelerator pump seal with a seal of improved distortion resistance. the carburetor will also be checked for the proper float level. | |||||||||||||||
| Notes | Vehicle description: passenger vehicles equipped with 225 or 318 cid engines.system: fuel; carburetor accelerator pump seal.consequences of defect: this may result in hesitation or lack of response whendriver attempts to accelerate. engine stalling may occur in some cases; thiscould lead to a vehicle accident in certain traffic situations. | |||||||||||||||
| VEHICLE SPEED CONTROL | ||||||||||||||||
| 76V008000 | CHRYSLER CORPORATION | V (Vehicle) | 15000 | 02/05/1976 | MFR | CHRYSLER GROUP LLC | 01/22/1976 | 10/12/1979 | ||||||||
| Defect Summary | ||||||||||||||||
| Consequence Summary | ||||||||||||||||
| Corrective Summary | ||||||||||||||||
| Notes | Chrysler campaign no 206.equipped with 360/2 barrel engines and automaticspeed controls.possibility that the automatic speed control linkage may havebeen assembled in a manner which may allow the speed control lost motion linkto travel overcenter when the accelerator pedal is pushed to the wide openthrottle position.if this occurs, it can result in the carburetor being heldat wide open position.(correct by inspecting and installing a support clip torestrict travel of speed control linkage). | |||||||||||||||