Dodge D500 1969
Model D500 made in 1969 by Dodge got 6 recalls. There were some recalls concerningservice brakes, hydraulic, steering.
Model 1969
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM | ||||||||||||||||
69V028000 | CHRYSLER CORPORATION | V (Vehicle) | 41 | 03/11/1969 | MFR | CHRYSLER GROUP LLC | 03/19/1969 | 10/12/1979 | ||||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Possibility that rear axle brake sup- port bolts may have been inade- quatelytightened.this could lead to failure of service brake system and possibleloss of vehicle control.(correct by properly torquing bolts.) | |||||||||||||||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - HOSES, LINES/PIPING, AND FITTINGS | ||||||||||||||||
73V088000 | CHRYSLER CORPORATION | from 05/01/1968 to 02/01/1973 | V (Vehicle) | 1552 | 05/25/1973 | MFR | CHRYSLER GROUP LLC | 04/24/1973 | 10/12/1979 | |||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Chrysler campaign no 110t.trucks.possibility that the flexible brake hosesconnecting the lower and upper brake master cylinder tubes may have beenimproperly clipped and routed.if this condition exists contact between thebrake hoses and steering column shaft coupling may be possible, with chafing ofthe hose resulting in a brake fluid leak and reduction of brakingeffectiveness.(correct by inspecting and rerouting flexible hose and replacewhere necessary. | |||||||||||||||
70V090000 | CHRYSLER CORPORATION | V (Vehicle) | 10288 | 07/27/1970 | MFR | CHRYSLER GROUP LLC | 07/30/1970 | 10/12/1979 | ||||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Possibility that front wheel brake hose could contact steering knuckle arm nutor cotter pin.this could cause chafing of brake hose which could result inloss of brake fluid and subsequent loss of braking ability.(correct byinstalling hose bracket where necessary.) | |||||||||||||||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER | ||||||||||||||||
70V089000 | CHRYSLER CORPORATION | V (Vehicle) | 5487 | 07/27/1970 | MFR | CHRYSLER GROUP LLC | 07/30/1970 | 10/12/1979 | ||||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Possibility that master cylinder brake hoses where misrouted so that theycontact steering column coupling.prolonged contact could result in loss ofbrake fluid and subsequent loss of braking ability.(correct by inspecting androuting properly where necessary.) | |||||||||||||||
SERVICE BRAKES, HYDRAULIC - POWER ASSIST - VACUUM - HOSES, LINES/PIPING, AND FITTINGS | ||||||||||||||||
69V106000 | CHRYSLER CORPORATION | V (Vehicle) | 246 | 07/29/1969 | MFR | CHRYSLER GROUP LLC | 08/06/1969 | 10/12/1979 | ||||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Possibility that brake booster vac- uum lines may be improperly installed.ifthis condition exists, gasoline vapors from intake mani- fold could enter brakebooster causing rapid deterioration of internal rubber components, andadversely affecting stopping ability.(correct by inspecting and properlyinstalling lines). | |||||||||||||||
STEERING | ||||||||||||||||
68V099000 | CHRYSLER CORPORATION | V (Vehicle) | 548 | 10/14/1968 | MFR | CHRYSLER GROUP LLC | 10/18/1968 | 10/12/1979 | ||||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Possibility rear spring clip (u-bolt) nuts on s-200, d-300; w-200 and w-300 models, and front clip on all others listed were improperly heat treated.could cause eventual breakage of nuts.if multiple fractures occur, possible loss of steering control could result.(correct by replacing spring clip nuts.) |