Dodge Dart 1967
Model Dart made in 1967 by Dodge got 6 recalls. There were some recalls concerninglatches/locks/linkages, seat belts and service brakes, hydraulic.
Model 1967
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
LATCHES/LOCKS/LINKAGES - DOORS - LATCH | ||||||||||||||||
66V008002 | CHRYSLER CORPORATION | V (Vehicle) | 41953 | 10/04/1966 | MFR | CHRYSLER GROUP LLC | 10/12/1966 | 10/12/1979 | ||||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Door latch striker assemblies may have a brittle striker sleeve and washer.failure of either of these parts by cracking could render the door latch inoperative once the door is opened.the striker can- not become disengaged from the lock pillar while the door is closed. therefore, there is no hazard of door coming open while car is in operation.(replace door latch striker assemblies.) | |||||||||||||||
SEAT BELTS - REAR | ||||||||||||||||
67V063000 | CHRYSLER CORPORATION | V (Vehicle) | 7407 | 07/03/1967 | MFR | CHRYSLER GROUP LLC | 07/05/1967 | 10/12/1979 | ||||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Possibility that the rear center seat belts could interfere with the diagonal supports behind the rear seat back rest during a severe impact, causing the belt to sever at less than the design impact specifications.(install plastic protectors on the diagonal supports in the area of belt contact.) | |||||||||||||||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER | ||||||||||||||||
66V009003 | CHRYSLER CORPORATION | V (Vehicle) | 363 | 10/11/1966 | MFR | CHRYSLER GROUP LLC | 10/12/1966 | 10/12/1979 | ||||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Disc brake caliper cross over tube may have been improperly positioned.contact with the disc brake rotor may cut tube, rendering front brakes inoperative.because of dual system, rear brakes should continue to operate nor- mally.(inspect and correct, including replacement of tubes if necessary.) | |||||||||||||||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER | ||||||||||||||||
67V009002 | CHRYSLER CORPORATION | V (Vehicle) | 9742 | MFR | CHRYSLER GROUP LLC | 01/08/1967 | 10/12/1979 | |||||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Possibility that the master cylinder push rod bolt may not meet material specifications.breakage of this bolt, if it occurred, could cause a complete loss of service brake operation.(replace the subject bolt.) | |||||||||||||||
SERVICE BRAKES, HYDRAULIC - POWER ASSIST | ||||||||||||||||
66V009002 | CHRYSLER CORPORATION | from 10/01/1966 | V (Vehicle) | 98 | 10/11/1966 | MFR | CHRYSLER GROUP LLC | 10/12/1966 | 10/12/1979 | |||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Possible missing clamp on power brake booster vacuum hose.absence of these clamps may allow the hose to disconnect thus decreasing brake efficiency.(inspect and install clamps where needed.) | |||||||||||||||
WHEELS | ||||||||||||||||
66V008001 | CHRYSLER CORPORATION | V (Vehicle) | 1101 | 10/04/1966 | MFR | CHRYSLER GROUP LLC | 10/12/1966 | 10/12/1979 | ||||||||
Defect Summary | ||||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | ||||||||||||||||
Notes | Possible interference between the flange of the wheel disc and the brake drum.this interference may cause a deformation of the wheel disc flange, resulting in a possible reduction in the structural strength of the wheel which could cause a fatigue failure.also, this interference could cause a false torquing of the wheel attaching nuts which could result in loose wheel nuts.(replace all five wheels.) |