Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
ENGINE AND ENGINE COOLING
07039705/09/199707-05-936088786Concerns with engine coolant usage. *nlm01/07/2000
ENGINE AND ENGINE COOLING - COOLING SYSTEM
07039705/09/199752963Various car owner's have expressed interest in using engine coolants made with propylene glycol instead of ethylene glycol. *yc11/13/1997
ENGINE AND ENGINE COOLING - ENGINE
18059702/14/199751978Vehicles with 3.0l engines - intake valve deposits - driveway die out, rough idle, lack of power, sags or hesitation. *tw07/17/1997
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE - BELTS AND ASSOCIATED PULLEYS
070394A12/01/199407-03-9439005Serpentine belt comes off pulleys. *tw02/28/1995

Consumer Complaints


Fail datemilesoccurencesPurchase date
ENGINE AND ENGINE COOLING - ENGINE
04/27/19947
 Vehicle leaks oil. *dsh
08/01/1995
 Tensioner belt broke while driving, also making a loud noise pe95-012 active. tt
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE
01/02/2002106/18/1995
 Vehicle would constantly shutdown while driving without warning, dealer has replaced computer command control module, but problem is still occurring.*ak consumer stated the starter, fuel injector, fuel pump, fuel filter coil pack, map sensor, and catalytic converter have all been replaced.*slc
ENGINE AND ENGINE COOLING - ENGINE - GASOLINE - BELTS AND ASSOCIATED PULLEYS
03/14/2007251
 Purchased said vehicle in sept. 2006 used. was just driving at posted speed limits in a community area of phoenix, when all of a sudden a loud clacking noise started as i pulled up to my designation, so i turned off the motor, lifted the hood and immediately noticed that the tension pulley had nearly completely came off the motor. it did cause the serpintine belt to come off of all the pullies of the motor. i had to have the vehicle towed home, again for the second time since sept. 2006. hen the vehicle was at my home i finished removing the pulley that was loose, causing it to bent enough to throw it totally off of its tension purpose. upon removal a bolt was also broken which may have caused the total problem because it was not tightened to torque specs. had to replace both parts attached to this pulley.*ak
03/29/19959
 Tensioner belt replaced due to noise. *sd
09/15/1995103/01/1994
 Steering became hard, resulting in no steering ability, replace belt tensioner and belt. tt dealer replaced serpentine belt and belt tensioner. *slc
ENGINE AND ENGINE COOLING - EXHAUST SYSTEM - EMISSION CONTROL - CATALYTIC CONVERTOR
111/01/1991
 Exhaust converter failed.