Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
VISIBILITY - DEFROSTER/DEFOGGER SYSTEM - WINDSHIELD - BLOWER | ||||||||||||||||
91V004000 | CHRYSLER CORPORATION | from 07/01/1989 to 09/01/1990 | V (Vehicle) | 125000 | 07/04/1991 | MFR | CHRYSLER GROUP LLC | 10/02/1991 | 04/11/1991 | |||||||
Defect Summary | Water leaking under windshield cowl in area above heater blower motor resistor block results in corrosion of the resistor terminals. | |||||||||||||||
Consequence Summary | Corrosion of the resistor terminals increases electricalresistance, leading to overheating and possble ignition of the wiring connectorsand insulation, causing a fire in the cowl area. | |||||||||||||||
Corrective Summary | The blower motor resistor block will be replaced, and a mastic patch applied to seal the cowl against water entry. damaged wire connectors will be replaced. | |||||||||||||||
Notes | System: heater blower motor resistor block.vehicle description: passenger cars without automatic temperature controlsystem. |
Consumer Complaints
Fail date | miles | occurences | Purchase date |
---|---|---|---|
VISIBILITY - DEFROSTER/DEFOGGER SYSTEM - WINDSHIELD - BLOWER | |||
04/26/1999 | |||
Whenever heater is turned on vehicle would fail to heat up. problem is listed on recall(#91v004000), but not for this vehicle. contacted dealer & mechanic ordered parts. mechanic informed owner/manufacturer a month later than recall notice. *ak | |||
06/20/1997 | 1 | ||
Water leaking into area above heater blower motor resistor block may result in corrosion and or fire. consumer took car in for repair . consumer was told that there was a safety recall on the vehicle, manufacturer contacted. vin number given . manfufacturer stated vehicle was not under recall. *ak blower resistor had rusted due to water intrusion. the connector had built up resistance from poor connection and burned the resistor. *yh | |||
VISIBILITY - DEFROSTER/DEFOGGER SYSTEM - WINDSHIELD - HEATER CORE | |||
06/20/1997 | 1 | ||
Water leaking into area above heater blower motor resistor block may result in corrosion and or fire. consumer took car in for repair . consumer was told that there was a safety recall on the vehicle, manufacturer contacted. vin number given . manfufacturer stated vehicle was not under recall. *ak blower resistor had rusted due to water intrusion. the connector had built up resistance from poor connection and burned the resistor. *yh |