Consumer Complaints


Fail datemilesoccurencesPurchase date
SUSPENSION
03/05/2003106000504/05/1996
 I own a 1996 dodge ram 1500 with the 5.2 liter engine. the engine oil light would flicker when stopped at a stop sign in drive. i took it to the dodge dealership and they said that the engine would have to be replaced due to the wear. i have used mobile 1 synthetic oil since the breakin oil and never let the oil in the vehicle over 4,000 miles. each time the oil filter was also changed. the vehicle has 106,000 miles on it and the engine replacement is costing me $4.700. i've been told that the 5.2 liter engine does not handle synthetic oil well. the oil does not return to the oil pan fast enough to keep the bottom of the engine lubricated. i find this hard to believe but i've never wore out an engine before. my question is how can an engine wear out when it was taken such good care of? i've had several other failures of this vehicle dealing with u-joints, steering shaft, failed fuel pump, and an unstable suspension requiring a $500 piston assembly to repair but the repair did nothing to help. *nlm
12/08/1998009/30/1996
 While driving vehicle about any mph and when stepping on the brake pedal to stop, vehicle wanders from side to side on the road. consumer tried to keep control of vehicle and keep focused on the road. dealer and manufacturer were contacted.*ak
SUSPENSION - FRONT
07/16/20081293851
 Was driving on highway at 65 mph, i crossed a small bump in the road and lost all control of the 1996 dodge ram 1500 4x4 pickup. it shook all the stuff off of my seat as well as my cd holder. this is the second time this has happened. i am at a loss as to how to look for the problem. i love this truck but i have gone through two wheel bearings and a tie rod end and i have only had it for a year.... i want to know how to fix this problem before someone gets killed. *tr
04/04/200268000103/09/2001
 Vehicle is on fourth engine and only 44,000 miles on present engine. dealer says engine is out of warranty. excessive blow by from engine. check engine light comes on. sensors have been replaced but problem still occurs. also the truck wanders on the road, and has a rumbling rattle noise on front passenger side that sounds like its coming from the shocks area. but my mechanic says shocks are ok. the dealer did not check into problem when i purchased the truck but it is listed as complaint when the first engine was replaced. have replaced tracking bar, u-joints, rear springs, stabilizer shock & tires. when going over bumps on highway vehicle jerks the steering wheel to side rail fast giving a fishtail effect. drive shaft has also been replaced. *la
06/16/1998
 Ongoing problem with a clicking sound in steering wheel when turning, and a problem with wandering cross road at 40 or more mph. dealer was notified. feel free to provide any further details on this matter. *ak
02/01/1996
 Truck pulls right / alignment is within normal values / appeared at around 49500 miles. *ak
10/18/1996103/03/1996
 Wheel alignment failed.
04/28/1996
 Front end makes clunking noise.
SUSPENSION - FRONT - CONTROL ARM
01/01/1999103/02/1998
 Front end misaligned due to idle arm,ball joints,tie rod ends pitman arm and steering failure. yh
09/15/1997109/01/1995
 Front end ball joints broke, causing accident.
SUSPENSION - FRONT - CONTROL ARM - LOWER BALL JOINT
3300112/01/1995
 The upper and lower ball joints experienced premature failure. *ak *cb *jb
SUSPENSION - FRONT - CONTROL ARM - UPPER BALL JOINT
3300112/01/1995
 The upper and lower ball joints experienced premature failure. *ak *cb *jb
SUSPENSION - FRONT - STABILIZER BAR
09/02/20061
 1996 ram 1500 sway bar attachment failed. *ts the consumer stated when the sway bar fell to the ground, it caused the front wheels to rapidly go from full-left to full right at the rate of several times per second. subsequent inspection showed that the sway bar plate had never been machine welded to the frame and for several years had been held on only by three small spot welds, meant to hold the plate in place for the machine welder. the machine weld appeared to be about an eighth to a sixteenth of an inch off, missing the entire plate. *jb
01/01/200496000509/13/2001
 S,bar link ,replaced twice within 3 weeks ,no good.transmission failure took to transmission shop ,replaced pressure sol,governor,gov switch,switchand seleriond,still acting the same.left controlarmandboltkit , also say needs right side .will not alligne .light under hood comes on when driving ,and horn does not work no one can fig out why ..?dodge should cover all tranny and frount sup on these trucks ,found out after purchaced all the things that go wrong with this yr of tk.96 dodge ram 4x4 1500 also the 4x4 is hard to shift into and take out and sometimes doesn not come out ,even when light indcates it is out of four wheel.never again dodge!! numerous dates of work to this vehicle. *ak
SUSPENSION - FRONT - WHEEL BEARING
12/08/2003920001
 Consumer heard a clung then a metal to metal noise while driving. passenger's side front wheel bearing malfunctioned, but the wheel didn't fall off. the consumer pulled over in time to keep the wheel from falling off. *ak *nm
03/15/1998
 The wheel bearing on the driver side broke off, caused the vehicle to sway to left lane which almost caused an accident. dealer cannot determine problem. *ak
10/01/1997101/21/1996
 Bearings failed.
SUSPENSION - REAR
04/04/200268000103/09/2001
 Vehicle is on fourth engine and only 44,000 miles on present engine. dealer says engine is out of warranty. excessive blow by from engine. check engine light comes on. sensors have been replaced but problem still occurs. also the truck wanders on the road, and has a rumbling rattle noise on front passenger side that sounds like its coming from the shocks area. but my mechanic says shocks are ok. the dealer did not check into problem when i purchased the truck but it is listed as complaint when the first engine was replaced. have replaced tracking bar, u-joints, rear springs, stabilizer shock & tires. when going over bumps on highway vehicle jerks the steering wheel to side rail fast giving a fishtail effect. drive shaft has also been replaced. *la
10/01/1997101/21/1996
 Rear end seal leaked.
 Rear axle is coming apart and seperating at bolts that hold axle with vehicle. *ak