Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SUSPENSION
020010101/19/2001618392Some customers may experience a situation in which the rear of the vehicle sits too high to attach their fifth wheel or goose neck trailer to the trailer hitch turnable. *jb04/12/2001

Consumer Complaints


Fail datemilesoccurencesPurchase date
SUSPENSION
10/05/1996
 While driving theres a squeeking noise, and if you hit a pot hole squeeking increases. took to dealer and they have replaced sharks three times. problem still occurs. the vehicle is now out of warranty. dealer refusing to correct the problem free of charge. please provide any further information. ts
08/15/2001
 Intermittently, when vehicle runs over a bumps or pothole it causes a severe vibration. dealer/manufacturer were not notified at this time. feel free to provide any further details on this matter.*ak
07/01/1996106/21/1996
 While traveling when road was warm and over a bump tire would leave skid marks on road. vehicle would travel from left to right. *ak at 65 mph, the front tires makes deep skid marks on the road until the vehicle stops. the square shaft from the steering wheel and steering box makes noise while driving. *yh
SUSPENSION - FRONT
 While driving 40-70 mph consumer noticed front end of vehicle shaking. consumer would have to slow vehicle down. dealer has been notified. please provide further information.*ak
1
 Problems with the front end suspension, causing excessive tire wear. mjs
SUSPENSION - FRONT - STABILIZER BAR
05/01/2001101/01/1996
 I am reporting a defect on a original frame weld. the stabilizer bar that is connected to the frame that keeps your vehicle from shaking has separated. i have had 3 welders look at this vehicle to repair it and they all say they wont for they dont want to be held responsible for it, be cause if i would have been going at a higher rate of speed i probably would have injured. i contacted chrysler and they stated to me that i should consider the mileage, well i have not had one problem with my engine and without a frame a engine is really no good. they also stated to me that mine was the first one they ever heard of, which i dont hardly beleive that. thank you for you rtime in advance. *ak