Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| UNKNOWN OR OTHER | |||
| 06/17/2012 | 93000 | ||
| Severely cracked dashboard which poses a danger in the event of a collision requires attention and/or possible recall for repair. vehicle less than ten years old showing damage, with proper maintenance and care. | |||
| 11/15/2011 | 63000 | ||
| Plastic dashboard has cracked in two places leaving sharp uneven edges sticking up. i can't use the vehicle to transport my grandchildren because i fear they will touch the area and get cut. according to 3 emplyees of the local dodge dealer they are still using this defective part if it is replaced...sad! | |||
| 09/19/2011 | |||
| We bought a 2003 dodge ram 1500 quad cab truck and the dash board has cracked in 6 different places and .i talked with other people wiht the same problem so it's a factroy defect is dodge is at fault and should have to recall and fix the porblem | |||
| 08/27/2011 | 155547 | ||
| My wife was getting into my 2003 dodge 2500 ram pick-up using the grab bar located on the passenger side of the truck. grab bar is located on the interior of the a-pillar of the truck. grab bar failed. the grab bar on the driver side failed 4 years ago, so i use the steering whee to get into the truck. she fell out of the truck onto the pavement injuring her knees. upon inspection of the molded plastic grab bar. the failure occurred when the grab bar interior trim piece tearing at were the bolt interfaces with the trim piece. the bolts remained in the metal thread holes in the metal part of the a-pillar. the molded grab handle bolt to trim interface is not adequate to support any load. | |||
| 01/17/2008 | 75000 | ||
| 2003 dodge ram 1500 quad-cab pickup problem: cracked dash dash cracked shortly after warranty period expired. this problem seems to be prevelant in all dodge ram trucks of this vintage. | |||
| 05/13/2010 | |||
| The air pressure coming out of the vents was minimal while driving and just above minimal when in park. this is an all the time situation. was told it could be a few things: blend door, circulation or vacuum issue. i started searching the issue online and found entire forums devoted to these issues. it was recommended that people file a complaint because it was agreed that a recall was or should be in order on that particular part or housing. | |||