Ford B700 1980
Model B700 made in 1980 by Ford got 2 recalls. There were some recalls concerningelectrical system, service brakes, hydraulic.
Model 1980
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
ELECTRICAL SYSTEM - WIRING | ||||||||||||||||
81V072000 | FORD MOTOR COMPANY | from 07/01/1980 to 05/01/1981 | V (Vehicle) | 11700 | 06/29/1981 | ODI | FORD MOTOR COMPANY | 06/15/1981 | 06/19/1981 | |||||||
Defect Summary | The primary circuit connection, which provides primary electrical power to the engine, could deteriorate due to high current draw produced by builder-installed equipment. | |||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | The main cab wiring harness electrical connector will be modified to eliminate deterioration at no charge to owner. | |||||||||||||||
Notes | Vehicle description: school buses.system: electrical; primary circuit connector.consequences of defect: depending on the degree of deterioration present,intermittent or complete loss of all vehicle electrical power could result.this would cause the engine to stop running and power steering assist and powerassist for hydraulic brakes would be lost, if the vehicle is so equipped. thesefailures could occur without warning, possibly resulting in an accident.note: vehicle should be removed from service until the problem is corrected. | |||||||||||||||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - HOSES, LINES/PIPING, AND FITTINGS | ||||||||||||||||
81V124000 | FORD MOTOR COMPANY | from 08/01/1980 to 04/01/1981 | V (Vehicle) | 7100 | 10/30/1981 | MFR | FORD MOTOR COMPANY | 10/15/1981 | 10/28/1981 | |||||||
Defect Summary | The master cylinder to chasis brake tube and hose assemblies may have been moved from their intended position, which could allow chafing against underbody components. chafing promotes wear of the brake tube and hose assembly and could cause a loss of brake fluid. | |||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | Upon inspection brake tube clips will be installed, if necessary, and brake tubes and hose assemblies will be replaced or rerouted. | |||||||||||||||
Notes | Vehicle description: school buses equipped with hydraulic brakes.system: service brakes; brake tube and hose assembly.consequences of defect: on models with standard split system hydraulic brakes,loss of brake fluid could cause loss of vehicle braking in the affected system.a portion of the brake system would remain functional but vehicle stoppingdistance would be significantly increased and an accident could result. formodels with single system hydraulic brakes, a sufficient loss of brake fluidcould result in loss of service brakes, loss of vehicle control, and anaccident.note: in both single and split braking systems, the vehicle operator may noticea drop in brake pedal height during application in the early stages of brakeline failure. on split system hydraulic brakes, loss of brake fluid in one partof the system may be detected by illumination of the brake warning lamp.vehicle should not be driven if warning light is activated or visible chafingof the brake tube or hose assembly exists, until the problem is corrected. |