Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
PARKING BRAKE - CONVENTIONAL
94V169001FORD MOTOR COMPANYfrom 07/01/1991 to 05/01/1994V (Vehicle)83579112/16/1994ODIFORD MOTOR COMPANY09/07/199411/23/1994
Defect SummaryThe parking brake control self-adjust pawl does not line up properly with the self-adjust rachet causing the pawl to slip over one or more teeth in the rachet.
Consequence SummaryWhen the above occurs, it can result in parking brake system ineffectiveness. the parking brake will not hold the vehicle, causing the vehicle to roll freely, if the transmission is not left in gear.
Corrective SummaryA wedge will be installed which will serve to lock the parking brake self-adjust mechanism pawl into engagement with the rachet. also, owners will be advised to release and reapply the parking brake whenever tooth skip occurs and will be reminded to always turn off the engine and leave the vehicle in gear when the vehicle is parked.
NotesSystem: emergency parking brake; mechanical.vehicle description: light duty pickup trucks and multipurpose vehicles with manual transmissions.note: if your vehicle is presented to an authorized dealer on an agreed upon service date and the remedy is not provided free of charge within a reasonabletime or the remedy does not correct the defect, please contact ford at 1-800-392-3673. also, contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
PARKING BRAKE
001101/10/2000612194Vehicles may experience parking brake pedal which goes to the floor with minimal effort- bronco and f-series built through 4/22/1994 and explorer/ranger built through 5/13/94.06/06/2000
001201/10/2000612198Information regarding parking brake control assembly concerns- bronco and f-series built through 4/22/1994 and explorer/ranger built through 5/13/1994. *mjs06/06/2000
001301/10/2000612200Procedure for servicing parking brake- service tip- bronco and f-series built through 4/22/1994 and explorer/ranger built through 5/13/1994. *mjs06/06/2000

Consumer Complaints


Fail datemilesoccurencesPurchase date
PARKING BRAKE
12/15/20031440001
 Parking brake slipped when applied, causing the vehicle to roll freely. this vehicle was manufactured on march 1994. dealer and manufacturer stated we didn't care when it was manufactured in 1994, there was not recall on this vehicle.*ak
PARKING BRAKE - CONVENTIONAL
02/16/2000105000103/16/1994
 Tl*the contact owns a 1994 ford bronco. the contact stated that the parking brake does not hold. on several occasions, he applied the parking brake and the vehicle rolled in the direction of the hill on where it was parked. the dealer stated that nhtsa campaign id number 94v169001 (parking brake:conventional) was not an active recall. the manufacturer stated that the recall was not in their database and refused to perform the repair. the current mileage was 180,781 and failure mileage was approximately 105,000. updated 03/09/09. *lj updated 03/11/09. *jb
08/01/199420
 Parking brake failure. *ak