Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
SEATS - FRONT ASSEMBLY - POWER ADJUST
93V193000FORD MOTOR COMPANYfrom 02/01/1991 to 02/01/1993V (Vehicle)1600002/18/1994MFRFORD MOTOR COMPANY11/23/199312/01/1993
Defect SummaryAn unused power seat harness connector is positioned on the rubber floor mat under the seat. if the vehicle is operated in cold weather in areas that have large amounts of salt used for snow and ice control, a puddle of saltwater can accumulate on the rubber floor mats, repeatedly wetting the connector. this will result in corrosion of the connector, causing a current to flow between the terminals without tripping the circuit breaker.
Consequence SummaryIf this occurs, current flow can heat the connector andrelease fumes into the passenger compartment, and can result in a vehicle fire.
Corrective SummaryDealers will remove the unused connector and install a sealed heat shrink cap over the affected wires.
NotesSystem: interior systems; tracks and anchors; front seat; power.vehicle description: police/fleet vehicles equipped with rubber floor mats andnon-powered front seats.note: if your vehicle is presented to an authorized dealer on an agreed uponservice date and the remedy is not provided within a reasonable time and freeof charge or the remedy does not correct the defect or noncompliance, pleasecontact ford service center at 1-800-392-3673. also, contact the nationalhighway traffic safety administration's auto safety hotline at 1-800-424-9393.

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SEATS
9824512/07/1998604057Concerns regarding the front seat feeling loose on some vehicle. *yc03/16/1999

Consumer Complaints


Fail datemilesoccurencesPurchase date
SEATS
05/15/200484000110/05/2001
 (1.) my car is a 1992 ford, crown victoria lx. - i got into the vehicle and leaned back on the back of the seat to get something out out of my pants pocket. as i pressed on the back of the seat there was a metalic snap sound and the back of the seat flopped back 3 to 4 inches on the driver door side. later on viewing the seat from the front of the car in front of the brake peddle i was able to determing that a welded in circular, threaded, metal, tapped fastener, (a custom made nut) had torn through the pressed metal fram that attached it to the motorized portion of the seat. the resulting hole in the pressed metal frame component was about one inch in diameter. (2) the failure of the seat makes the vehicle impossible to drive. (3.) i have checked for recalls and found none relating to the seat except for an electrical failure. i haven't repaired the vehicle as yet but i will likely go to a automobile recycling yard and look for another seat. of course inspecting first for the same failure. also, as near as i can tell this vehicle was never in an accident . and it only has 84,000. miles on it.*ak
1
 Front driver's seat has ripped out of the seat mounting bracket. *yh
12/11/20001
 Front left seat to track attachment bolt tore away when someone leaned on the seats' backrest to reach for something behind the seat. the seat is no longer anchored at that front left corner leaving an unsafe condition. in a rearend collision the seat can easily tilt back causing injury to passengers. *ak
09/01/20001
 Frame is broken and seat will not lock into place.*ak
03/01/2000
 Driver's seat bolt broke, causing the seat move down and towards the left side, which may cause the occupant to lose control of vehicle. please provide further information. *ak
06/01/1995
 Clearcoat of paint coming off in blocks/strips,fly onto windshield while driving, paint rusting. brake pedal doesn't return up, pops up when turning & rough on rough rd.,wear out quickly. elec. dr. locks don't work. driver elec. seat wont go back,engine:spark knock,car pulls left, engine check light goes on,solenoid replaced 3x,fuse blows for interior lts cluster,difficulty removing key from igniition,seat track covers off, climate control inoperable preceeded by initial hot air from a/c, steering wheel vibrates,hood latch difficult to close. *ak
04/15/2000002/15/1993
 Consumer was sitting at light. when light turned green vehicle took off. driver's side seat made a cracking noise and went backward. *ak
06/06/1993308/01/1992
 Air conditioning only works if it's not too hot. brake rotors keep going out and need to be worked. seat tracks can come loose any time. replaced tracks once,worked on twice ,going out again.this has been on-going since purchas of car in aug of 1992. dealer no longer in business. one in ventura is barber ford on main street. *ak
 While traveling after and making a stop driver's seat rocks backwards, causing the seat bolt to pop out and seat to lean. please provide further informaton. *ak
06/04/1999203/01/1992
 Had problems with loose driver's side seat for several years. seat would rock on frame. seat frame finally broke away from track assembly on 4 june. disassembly of seat showed 3 of 4 bolt-holes holding seat to track had totally disintegrated, the lf seat track link had snapped, and there were several stress cracks (one completely through!) in the seat frame itself. have researched 120 separate incidents of this seat failure condition on odi consumer reports on-line database on full-sized fords, lincolns, and mercurys in years 1990-1996. dealer said my car was out of warranty and would offer no satisfaction/remuneration for this obvious defect. would like to share my analysis of these relevant odi listings so nhtsa/odi can pursue this with ford. have compiled them into a 48-page document and also a spreadsheet to total the figures. this is a very dangerous condition possibly affecting many thousands of vehicles, including many crown victorias used as police cruisers. several database listings show seats collapsed seats fly off track and seats separate from car floor during accidents. i am a 3rd generation auto mechanic and managed a goodyear auto repair facility for 6+ years. i know cars very well and have never seen seat assemblies built as poorly as this one! judging from the odi database, i am far from alone in having this defect on a ford motor company product. they must have reengineered the seat since the problems drop off noticeably after 1994. i did not receive any recall notice from ford nor could discover any recalls in the nhtsa/odi db for this reason. there were a few service bulletins. but, nothing resembling a recognition of the seriousness of this problem. a driver cannot control a car if his seat is broken. this also defeats the proper workings of the seat belts and other passenger restraint systems. i would appreciate a call or e-mail reply to discuss this with nhtsa/odi and pursue this with you. regards, jim mathias
204/05/1996
 The driver's side seat track broke .*ak consumer states bottom and back of front driver's seat is loose, seat constantly shifts when vehicle accelerates, slows down or stops, consumer states there has been numberous technical bulletins ,dealership would not replace broken part under service warranty, consumer was told there must be a large number of problems with that part.*jb
03/18/19951
 The drivers seat rail bracket broke, causing the seat to rock back and forth. tt
SEATS - FRONT ASSEMBLY - HEAD RESTRAINT
05/15/200484000110/05/2001
 (1.) my car is a 1992 ford, crown victoria lx. - i got into the vehicle and leaned back on the back of the seat to get something out out of my pants pocket. as i pressed on the back of the seat there was a metalic snap sound and the back of the seat flopped back 3 to 4 inches on the driver door side. later on viewing the seat from the front of the car in front of the brake peddle i was able to determing that a welded in circular, threaded, metal, tapped fastener, (a custom made nut) had torn through the pressed metal fram that attached it to the motorized portion of the seat. the resulting hole in the pressed metal frame component was about one inch in diameter. (2) the failure of the seat makes the vehicle impossible to drive. (3.) i have checked for recalls and found none relating to the seat except for an electrical failure. i haven't repaired the vehicle as yet but i will likely go to a automobile recycling yard and look for another seat. of course inspecting first for the same failure. also, as near as i can tell this vehicle was never in an accident . and it only has 84,000. miles on it.*ak
12/23/19941
 Design of head restraint does not extend high enough to protect occupants head or neck. tt
SEATS - FRONT ASSEMBLY - POWER ADJUST
06/01/1995
 Clearcoat of paint coming off in blocks/strips,fly onto windshield while driving, paint rusting. brake pedal doesn't return up, pops up when turning & rough on rough rd.,wear out quickly. elec. dr. locks don't work. driver elec. seat wont go back,engine:spark knock,car pulls left, engine check light goes on,solenoid replaced 3x,fuse blows for interior lts cluster,difficulty removing key from igniition,seat track covers off, climate control inoperable preceeded by initial hot air from a/c, steering wheel vibrates,hood latch difficult to close. *ak
06/29/19931
 Power seat inoperative.
06/03/1996
 Electrical short, driver's power seat, cauisng the vehicle to catch on fire under the seat *ak
SEATS - FRONT ASSEMBLY - RECLINER
03/01/19951
 Defective seat bolt caused drivers seatback to collapse while driving. tt