Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
985A2903/18/1998601036Some vehicles may exhibit excessive brake pedal travel, irregular front lining wear, and brake pull. *yc06/23/1998
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER
985A3803/18/1998601045Front caliper piston boots damaged. *yc06/23/1998

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
SERVICE BRAKES, HYDRAULIC
EA91044FORD MOTOR COMPANY10/30/199110/30/1992LOSS OF BRAKE EFFECTIVENES92V026000
 There is no summary currently available
SQ99005FORD MOTOR COMPANY02/10/199909/21/2001FRONT BRAKE FADE
 Front brakes can fade
PE91077FORD MOTOR COMPANY05/23/199110/31/1991LOSS OF BRAKE EFFECTIVENES
 There is no summary currently available

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, AIR - DISC - CALIPER
03/01/1990406/18/1989
 Brake failure.
SERVICE BRAKES, HYDRAULIC - FLUID
04/15/19965
 Brake fluid overheated, causing brake failure. *dh
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
2
 Brakes failed.
09/18/19962
 Brakes experiencing overheating, replacement of the defective rear brake cylinders did not rectify overheating.
11/03/19943
 Brake failure. *ak
05/29/19954
 After sustained and frequent use of brakes they apparently overheat and pedal goes to the floor. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
10/06/1995407/01/1990
 Wrote an explanation of whole problem but won't fit here. planning trip to mountains, but scared to go without resolution to problem. no safety defect listed within summary. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER
06/24/2001105/01/1998
 Brake caliper failed to release, boiling the brake fluid (unbeknownst to me until it came time to apply the brakes). the brake pedal went all the way to the floor. i let it up completely and when depressed, it went to the floor once again. i used the transmission (gearing down) and the emergency brake to bring vehicle to a stop. the master cylinder brake indicator light never illuminated. when repairs were completed, the primary fault was identified as extremely rusty front brake calipers. one did not release completely after a brake application, causing sufficient heat buildup to boil the brake fluid. mechanic said the rear brakes were badly out of adjustment, giving the opinion that was the reason the master cylinder indicator light did not illuminate. until this incident occurred, i did not know that it was incumbent on the vehicle operator to occasionally make reverse moves with aggressive brake applications (done several times) to cinch up the rear brake adjustment. thus, over time, the front brakes were basically doing almost all the braking effort. if i had had the presence of mind to pump the brake pedal repeatedly, i perhaps could have caused the rear brakes to engage, and bring the vehicle to a stop without downgearing and using the emergency brake.*ak
09/15/199608/13/1990
 Lost braking power while driving down steep grade, no pressure in pedal. was told by a dealer that calipers/pads overheated. *ak
06/01/1992
 The front brake failure(caliper over heat) the brake fluid caught on fire. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS
09/15/199608/13/1990
 Lost braking power while driving down steep grade, no pressure in pedal. was told by a dealer that calipers/pads overheated. *ak
06/21/1996111/11/1993
 Coming to a stop while going down hill the brakes failed/replaced front brake pads, rotors and brake hoses. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR
06/21/1996111/11/1993
 Coming to a stop while going down hill the brakes failed/replaced front brake pads, rotors and brake hoses. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM - WHEEL CYLINDERS
09/18/19962
 Brakes experiencing overheating, replacement of the defective rear brake cylinders did not rectify overheating.
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - HOSES, LINES/PIPING, AND FITTINGS
05/21/2004250003
 Intermittently vehicle loses brake power when the brake pedal is depressed, brake pedal goes to the floor and fails to stop the truck. the emergency brakes had to be engaged to stop the vehicle. master brake cylinder was replaced, but the failure occurred with in 400 miles. dealership replaced the master cylinder again, and bleed the brakes. however, failure recurred within 1500 miles. then, dealership indicated that this failure occurred because the brake line was routed behind the engine , which get hot and boiled the fluid.*ak
06/21/1996111/11/1993
 Coming to a stop while going down hill the brakes failed/replaced front brake pads, rotors and brake hoses. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER
05/21/2004250003
 Intermittently vehicle loses brake power when the brake pedal is depressed, brake pedal goes to the floor and fails to stop the truck. the emergency brakes had to be engaged to stop the vehicle. master brake cylinder was replaced, but the failure occurred with in 400 miles. dealership replaced the master cylinder again, and bleed the brakes. however, failure recurred within 1500 miles. then, dealership indicated that this failure occurred because the brake line was routed behind the engine , which get hot and boiled the fluid.*ak
06/24/2001105/01/1998
 Brake caliper failed to release, boiling the brake fluid (unbeknownst to me until it came time to apply the brakes). the brake pedal went all the way to the floor. i let it up completely and when depressed, it went to the floor once again. i used the transmission (gearing down) and the emergency brake to bring vehicle to a stop. the master cylinder brake indicator light never illuminated. when repairs were completed, the primary fault was identified as extremely rusty front brake calipers. one did not release completely after a brake application, causing sufficient heat buildup to boil the brake fluid. mechanic said the rear brakes were badly out of adjustment, giving the opinion that was the reason the master cylinder indicator light did not illuminate. until this incident occurred, i did not know that it was incumbent on the vehicle operator to occasionally make reverse moves with aggressive brake applications (done several times) to cinch up the rear brake adjustment. thus, over time, the front brakes were basically doing almost all the braking effort. if i had had the presence of mind to pump the brake pedal repeatedly, i perhaps could have caused the rear brakes to engage, and bring the vehicle to a stop without downgearing and using the emergency brake.*ak
SERVICE BRAKES, HYDRAULIC - PEDALS AND LINKAGES
08/06/1996106/01/1994
 Brake failure.