Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| ENGINE AND ENGINE COOLING - COOLING SYSTEM | |||
| Vehicle has an oil smoking condition that two mechanics stated could not be repaired. owner was going to take van to a ford dealership. please describe details. *ak | |||
| ENGINE AND ENGINE COOLING - ENGINE - GASOLINE | |||
| 06/06/2000 | 1 | 04/25/1992 | |
| Saw recall 96i003000 and 3001 on the internet, dealer said there was no recall on our car, serpentine belt tensioners, belt guides and idler pulleys on other vans being replace, we feel there should be a refund coming to us | |||
| 2 | |||
| Vehicle will begin to drive rough if temperature is 98 degrees or higher. eventually it will stall, causing a safety hazard.dealer cannot isolate defect. also, it cannot be duplicated on premises. *ak | |||
| ENGINE AND ENGINE COOLING - EXHAUST SYSTEM | |||
| 07/14/2003 | 27000 | 6 | 05/05/1993 |
| While running on freeways with hot temp, my motorhome with 92 ford e-350 engine stops. this happens in several occasions. the 1st time it happened, the computer box was replaced in montiplier, idaho in 96 but the problem still exist. i cannot run the engine in a prolong period of time during summer because it dies. i went to looked under the left rear side of the engine by the exhaust pipe and there were melted wire insulations. i tried to tacked them away from the exhaust heat but the problem still exist. another problem is the abs light stays on but the braking was ok. how can i resolve these problems? | |||
| ENGINE AND ENGINE COOLING - EXHAUST SYSTEM - MANIFOLD/HEADER/MUFFLER/TAIL PIPE | |||
| 07/14/2003 | 27000 | 6 | 05/05/1993 |
| While running on freeways with hot temp, my motorhome with 92 ford e-350 engine stops. this happens in several occasions. the 1st time it happened, the computer box was replaced in montiplier, idaho in 96 but the problem still exist. i cannot run the engine in a prolong period of time during summer because it dies. i went to looked under the left rear side of the engine by the exhaust pipe and there were melted wire insulations. i tried to tacked them away from the exhaust heat but the problem still exist. another problem is the abs light stays on but the braking was ok. how can i resolve these problems? | |||