Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
STRUCTURE - BODY
526012/01/1998615381Brief information concern idle vibration (typically in gear) felt thru the steering wheel and / or body. *tt01/16/2001
STRUCTURE - BODY - DOOR
99-8-1505/03/1999606419Subject regarding door trim panel replacement - service tip. *tt01/05/2001

Consumer Complaints


Fail datemilesoccurencesPurchase date
STRUCTURE
02/12/200663446110/24/2001
 Failurre of all four motor mounts in my 1999 ford escort. *nm
STRUCTURE - BODY
04/19/20031
 Car was not sealed before it was painted,so the paint is chipping away,and rust is beginning to show,on the hood,top,and trunk of car.*ak
10/01/2000
 The structural integrity of the entire vehicle is unsound. there are broken welds, distorted sheet metal subframe componants, and shifting or flexing of the body throughout the entire vehicle. it has severe oversteer at speed when cornering over roads with varying surfaces. the undercarraige will twist allowing the gas tank to strain and loosen at its retaining straps and the brackets they attach to are pulling loose at their welds. the windshied angle changes, the roof bulges and buckles, the rear doors drop and lift as well as the rear hatch area as the car is accellerated or the brakes are applied. when the steering wheel is turned left or right the body twists. there is a noticable pull under accelleration. also the interior seats shift and sway seperate from the exterior. *ak
10/13/2000
 Under carriage is separating. spot welds are breaking. fuel tank straps are not secured for tank, which causes it to move around. structural integrity of vehicle is compromised because of spot welds. windshield tilts towards driver. passenger's door in rear of the station wagon would pivot and was getting worse. *ak
STRUCTURE - BODY - DOOR
08/09/20037100010/15/2002
 I have a manufacturing defect in my 1999 ford escort, which i am second owner of. i contacted local dealer from where purchased as used car, york motors, whom told me to contact local ford dealer, galpin ford. tony pacini, at galpin, contacted scottsdale ford engineer, with pics i provided of defect. after a few weeks engineer was able to come to my place of employment and see it up close. engineer confirmed that the rear quarter panel for the car had been pressed to thin in the manufacturing phase. i got the estimate for repair, as they requested, for approx. $1500.00. now they are telling me that this fits under their good will policy and i would be lucky if ford will pay for 50% of the repairs. the damage is an open gash of 17 in the rear door casing. i have small children, whom ride in the back and can cut themselves severly with this fault. according to the body shop, where i got estimate and whom told me to do this complaint, the repair procedure that ford initially requested would hinder the proper crash compression of the car and therefore increase danger in an accident. needless to say, i had originally asked the ford engineer and mr. pacini that if ford was not willing to consume the cost of repairs, that i would be willing to give them the car and take my choice off their used car lot, with no difference in my car payments or cost. just a flat out trade. if you need the correspondences i have encurred with ford i would be glad to forward them to you with pictures of the fault.
10/13/2000
 Under carriage is separating. spot welds are breaking. fuel tank straps are not secured for tank, which causes it to move around. structural integrity of vehicle is compromised because of spot welds. windshield tilts towards driver. passenger's door in rear of the station wagon would pivot and was getting worse. *ak
STRUCTURE - FRAME AND MEMBERS
01/01/1999
 No summary listed for this vehicle. *ak