Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
STEERING - COLUMN
06241410022296Lower steering column shaft pop/clunk noise. *kb07/25/2007

Consumer Complaints


Fail datemilesoccurencesPurchase date
STEERING
11/01/201197500
 Engine stalls. stalls whenever it feels like it, hot or cold, slowing down to stop, turning left or right, on the street roads and freeways. starts and go again after 5/10 minutes but this is ridiculous. i paid so much money and time for diagnostic and parts already and yesterday was the worst. my 2006 ford explorer stalled in the middle of the freeway. date: nov 1, 2011, time:1550, and my wife was driving, when she's not happy, nobody's happy....she almost got ran over as she open her door, she could not go anywhere but wait for time to either cool off or reset on the engine.
12/09/2005900111/01/2005
 My ford explorer xlt 2006 had a delayed delivery date to me for 2 days due to a bad cluster on start up. the truck was repaired and i picked it up on november 1, 2005. this vehicle is leased. there was a recall for the windshield wipers which i had repaired on december 8, 2005. on december 9, 2005 while i was driving with my two young children in the truck i pulled out of a parallel parking space and the steering wheel began to feel very tight and it was grinding when steering slightly left or right of the center and then it would free up again making the truck easy to oversteer. as i drove the tightness would go away until i slowed down and then it would get tight again. also the grinding on turns either left or right remained. i got to a safe place and called my purchasing dealer burns ford 359 west jericho tpke, huntington, ny 11743. they advised me not to drive the truck and call ford roadside assistance. i did and they towed the truck to burns ford. they called me later in the day to tell me that ford advised them that there is a problem with the truck and parts will not be available until the 1st quarter of 2006. the following is the notice: 18962 2006 explorer 4dr /mercury mountaineer-intermediate (1) shaft pop/clunk noise. some 2006 explorer 4dr and mountaineer vehicles may exhibit a creak/pop heard and felt through the steering wheel, usually noticed at stationary of low-speed turns while accelerating and braking. if diagnosis finds that this may be due to intermediate shaft having stick-slip condition, do not replace the 1 shaft at this time. this is currently under investigation by engineering. a revised component is due first quarter 2006. monitor oasis for updates. effective date: 12/1/2005. right now my truck is still at the dealer. i do not feel comfortable driving it and i need to rent a car. please advise thank you, laura masiakos. *nm *ak
STEERING - COLUMN LOCKING - ANTI-THEFT DEVICE
05/25/20071
 I bought a ford explorer hybrid last year and it has about 2,000 miles on it. anyways, i was driving it yesterday to work and i was in the passing lane moving to the right turn lane, and as i was doing so the steering wheel locked like it did it when the key was out. i slammed on the brakes just before i headed straight into the local cvs. i took the car to the dealer, and they performed the computer diagnostic, but nothing came up. i knew steering wheels were supposed to lock up when driving, so before anyone died because of this, i decided to bring it to your attention.*ak
STEERING - WHEEL AND HANDLE BAR
11/01/201060000
 2006 ford explorer 60000 miles. front wheel bearings need replacement. no offroad, street driving only.