Bulletins
| Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
|---|---|---|---|---|---|
| STEERING | |||||
| 0427 | 10/07/2005 | 051715 | 10018061 | Steering shudder during low speed maneuvers - 4.0l engine. *tt | 12/14/2005 |
| 031912 | 02/09/2004 | 0427 | 10007369 | Steering shudder felt when turning, driving at slow speeds or at stop. *tt | 06/16/2004 |
Investigations
| NHTSA ID | Manufacturer | Date open | Date close | Subject | Recall campaign | |
|---|---|---|---|---|---|---|
| STEERING | ||||||
| PE09020 | FORD MOTOR COMPANY | 04/21/2009 | 08/19/2009 | VEHICLE ROLLAWAY ALLEGATIONS | ||
| In response to an information request (ir) letter sent by the office of defects investigation (odi), ford stated consumer reports of higher than expected efforts when shifting into and out of park could be a result of a groove being worn into the swing arm ramp of the steering column. the swing arm is a component bolted to the steering column that assists in shifting through the transmission gears.an engineering evaluation conducted by ford of returned steering columns found the groove could be created over time if consumer shift more quickly from the drive or reverse to park than the brake shift interlock (bsi) solenoid pin retracts after the brake pedal is applied. in november of 2004, ford released a redesigned bsi solenoid with a shorter pin retracting time as a serviceable component. ford has noted the shorter retraction time significantly lessens the likelihood of bsi solenoid pin to swing arm contact even with rapid consumer shifts.ford also issued a technical service bulletin, tsb 04-22-12, to instruct service technicians on the proper diagnosis and vehicle repair. reviewing complaints to odi and data submitted by ford, odi has identified 200 alleged incidents of unintended vehicle movement after consumers believe they have shifted the vehicle into park, resulting in 85 alleged crashes and 32 alleged injuries.in addition to the reports of alleged incidents of unintended vehicle movement, odi has also identified 883 reports of consumers alleging difficulty or the inability to shift the vehicle into park.this preliminary evaluation has been upgraded to an engineering analysis (ea09-013) to further assess the scope, frequency and risk to motor vehicle safety of the alleged defect in the subject vehicles. | ||||||
| STEERING - COLUMN | ||||||
| PE09020 | FORD MOTOR COMPANY | 04/21/2009 | 08/19/2009 | VEHICLE ROLLAWAY ALLEGATIONS | ||
| In response to an information request (ir) letter sent by the office of defects investigation (odi), ford stated consumer reports of higher than expected efforts when shifting into and out of park could be a result of a groove being worn into the swing arm ramp of the steering column. the swing arm is a component bolted to the steering column that assists in shifting through the transmission gears.an engineering evaluation conducted by ford of returned steering columns found the groove could be created over time if consumer shift more quickly from the drive or reverse to park than the brake shift interlock (bsi) solenoid pin retracts after the brake pedal is applied. in november of 2004, ford released a redesigned bsi solenoid with a shorter pin retracting time as a serviceable component. ford has noted the shorter retraction time significantly lessens the likelihood of bsi solenoid pin to swing arm contact even with rapid consumer shifts.ford also issued a technical service bulletin, tsb 04-22-12, to instruct service technicians on the proper diagnosis and vehicle repair. reviewing complaints to odi and data submitted by ford, odi has identified 200 alleged incidents of unintended vehicle movement after consumers believe they have shifted the vehicle into park, resulting in 85 alleged crashes and 32 alleged injuries.in addition to the reports of alleged incidents of unintended vehicle movement, odi has also identified 883 reports of consumers alleging difficulty or the inability to shift the vehicle into park.this preliminary evaluation has been upgraded to an engineering analysis (ea09-013) to further assess the scope, frequency and risk to motor vehicle safety of the alleged defect in the subject vehicles. | ||||||
| STEERING - COLUMN LOCKING - ANTI-THEFT DEVICE | ||||||
| PE09020 | FORD MOTOR COMPANY | 04/21/2009 | 08/19/2009 | VEHICLE ROLLAWAY ALLEGATIONS | ||
| In response to an information request (ir) letter sent by the office of defects investigation (odi), ford stated consumer reports of higher than expected efforts when shifting into and out of park could be a result of a groove being worn into the swing arm ramp of the steering column. the swing arm is a component bolted to the steering column that assists in shifting through the transmission gears.an engineering evaluation conducted by ford of returned steering columns found the groove could be created over time if consumer shift more quickly from the drive or reverse to park than the brake shift interlock (bsi) solenoid pin retracts after the brake pedal is applied. in november of 2004, ford released a redesigned bsi solenoid with a shorter pin retracting time as a serviceable component. ford has noted the shorter retraction time significantly lessens the likelihood of bsi solenoid pin to swing arm contact even with rapid consumer shifts.ford also issued a technical service bulletin, tsb 04-22-12, to instruct service technicians on the proper diagnosis and vehicle repair. reviewing complaints to odi and data submitted by ford, odi has identified 200 alleged incidents of unintended vehicle movement after consumers believe they have shifted the vehicle into park, resulting in 85 alleged crashes and 32 alleged injuries.in addition to the reports of alleged incidents of unintended vehicle movement, odi has also identified 883 reports of consumers alleging difficulty or the inability to shift the vehicle into park.this preliminary evaluation has been upgraded to an engineering analysis (ea09-013) to further assess the scope, frequency and risk to motor vehicle safety of the alleged defect in the subject vehicles. | ||||||
Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| STEERING | |||
| 02/18/2004 | 9 | ||
| When driving at any speed vehicle vibrated consumer contacted wi dealership about this issue. *ak | |||
| STEERING - RACK AND PINION - RACK | |||
| 10/16/2005 | 34000 | 1 | 02/06/2000 |
| Dt*: the contact stated while driving 40 mph the steering wheel locked up and the control of the vehicle was lost resulting in an accident and injuries. the recirculation ball and the rack and pinion failed causing the steering to lock up. the dealer and the manufacturer were alerted of the incident. the consumer came around a corner and suddenly lost control of the vehicle, the consumer stated the vehicle was involved in an accident 5 months prior, and he believed the vehicle may have not been properly fixed which may have caused the accident. the consumer also stated the air did not deploy in this accident. the police concluded that the consumer was traveling too fast for conditions and upon rounding the corner, he lost control and struck the bank on the side of the roadway causing the vehicle to overturn. the consumer had previous repairs on the vehicle such as an inoperable turn signal light and the rear vents did not blow out air. updated 10/3/06 *jb updated 10/25/2006 - *nm | |||