Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM - SHOES/LININGS
92V026000FORD MOTOR COMPANYfrom 08/01/1987 to 08/01/1991V (Vehicle)46700006/10/1992ODIFORD MOTOR COMPANY03/03/199203/11/1992
Defect SummaryA revised brake lining noise insulator resulted in a decrease in the thermal insulation between the brake lining and the front brake caliper piston. this caused greater heat transfer to the caliper pistons with the potential to overheat the brake fluid and diminish brake effectiveness during severe braking conditions.
Consequence SummaryIncreased stopping distances and inablility to holdvehicles on a steep grade results in increased risk of accident in the event ofa sudden stop or when constant braking is needed to maneuver through areas withsteep grades.
Corrective SummaryAdd snap-in insulators that attach to each of the front brake caliper pistons. in addition, vehicles with 7.5 l engines will have insulation added to the engine compartment brake lines.
NotesSystem: brakes; front brake lining.vehicle description: f250 and f350 trucks with 7.3 l diesel and 7.5 l efiengines ; f250 and f350 4x4 models with 5.8 l efi engines.note: ford recommends vehicle operators do not exceed the gcwr and gvwr of theirvehicles, and proper maintenance of the brakes on these vehicles and any trailerparticularly when operating in mountainous areas with long, steep grades.

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SERVICE BRAKES, HYDRAULIC - ANTILOCK
9521210/01/199546478The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable because it may be incompatible with the rubber material used in the disc brake system. if petroleum-based grease is used to lubricate any par04/25/1996
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
985A2903/18/1998601036Some vehicles may exhibit excessive brake pedal travel, irregular front lining wear, and brake pull. *yc06/23/1998
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
985A1303/18/1998601012The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable. *yc06/17/1998
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER
985A3803/18/1998601045Front caliper piston boots damaged. *yc06/23/1998

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
SERVICE BRAKES, HYDRAULIC
PE91077FORD MOTOR COMPANY05/23/199110/31/1991LOSS OF BRAKE EFFECTIVENES
 There is no summary currently available
EA91044FORD MOTOR COMPANY10/30/199110/30/1992LOSS OF BRAKE EFFECTIVENES92V026000
 There is no summary currently available

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, AIR - DISC - CALIPER
402/21/1991
 Brakes overheat causing loss of breaking power.
02/21/1991
 Front brake calipers wear excessively causing brakes to overheat.
SERVICE BRAKES, HYDRAULIC
 Brake problems--failing to stop the vehicle in a timely manner. no one has been able to fix them. power steering unit has been replaced three times--car wanders.
 Brakes do not work properly--when pressure is applied on the brake pedal, there is a pause between applying the brake and the vehicle stopping.
SERVICE BRAKES, HYDRAULIC - ANTILOCK
10/14/2000
 Aftering driving for about 10 miles using the brakes frequently vehicle shut off. after vehicle was started again, there was no braking ability. this problem could cause a crash. problem has not been reported to the dealership. please provide any further information.*ak
 Experiencing brake problem, failing to stop the truck in a timely manner, intermittent problem, causes us great concern for safety of others, attempt to repair replace pad, abs box, vacuum pump, brake equalizer, or several other things.
07/01/1993509/13/1991
 Anti-lock brakes faded prior to recall, consumer was never notified of recall.
01/16/1997107/13/1991
 Front abs brakes; upon application, brake pedal goes to the floor, dealership unable to duplicate failure to determine corrective action. tihis failure is not consistent.*ak consumer stated dealer replaced the master cylinder but did not resolve the problem.*jb
02/20/1996
 Abs brakes lock up when the brakes are applied in a panic sudden stop, resulting in an accident. *ak
01/01/19941
 Abs, brake failed on dry surface/ extended stopping distance at low speed, resulting in an accident. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
1
 Brakes failed. nlm
06/08/1999102/01/1997
 Brake system malfunctioned due to the design of the brakes. vehicle had no braking ability at all, which caused a crash. *ak
1
 Ignition recall service denied with no reason given, was told by mcgarity, carter ford lincoln mercury to go to another dealership. this is the closest location. 96v071000. *ak consumer states when he applied the brakes vehicle pulled to the right.*jb
01/01/19921
 Brakes fail intermittently. *dh
05/04/19961
 The brake fluid is overheating, causing increased stopping distance and inablitity to stop the vehicle. recall #92s44. *ak brakes have faded four times failure occured without warning, replaced front pads three times, replaced rotors once, currently rotors appear to warped.*jb
 Brakes failing when in use. please describe the problem. *ak
04/15/1995
 Serpentine belt broke and caused loss of braking ability. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
08/21/1998104/01/1997
 Front right disc brakes; while driving started pulling and felt like a flat tire. when pulled over the right front, drum was in flames. consumer put out fire with a fire extinguisher. dealer cannot duplicate the problem. *ak
05/04/19961
 The brake fluid is overheating, causing increased stopping distance and inablitity to stop the vehicle. recall #92s44. *ak brakes have faded four times failure occured without warning, replaced front pads three times, replaced rotors once, currently rotors appear to warped.*jb
 When going down the hill the brake pedal goes to the floor and there no front brake. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER
02/01/199720
 Brake calipers fail continually. mjs
402/21/1991
 Brakes overheat causing calipers to burn.
06/01/1992210/01/1990
 Brake pads and calipers replaced twice.
06/12/1992606/24/1996
 Front brake calipers failed, causing vehicle to pull to the right, also front end misalignment; windshield wiper motor failed; replaced leaking axle seals; fuel pump failure/ fuel line recall and problems with transmission. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS
06/01/1992210/01/1990
 Brake pads and calipers replaced twice.
01/25/19965
 Front brake pads replaced. *dh
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR
11/01/1994110/01/1990
 Brake rotors replaced.
01/25/19965
 Front rotors failed.
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM
10/14/200003/01/2091
 Front tire wearing unevenly evem with recent alinement-took to americas tire co. for rotation and was told tire had flat spots and rotation would not help-tire defective. is this tire on the recall?
10/14/200003/01/1991
 Front tire wearing unevenly evem with recent alinement-took to americas tire co. for rotation and was told tire had flat spots and rotation would not help-tire defective. is this tire on the recall? (tiresize: lt21585r16)( dot number: tire size: lt21585r16 )
10/14/200003/01/1991
 Front tire wearing unevenly evem with recent alinement-took to americas tire co. for rotation and was told tire had flat spots and rotation would not help-tire defective. is this tire on the recall?( dot number: tire size: lt21585r16 )
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - HOSES, LINES/PIPING, AND FITTINGS
04/02/2002306/01/1991
 Brakes fail sometimes. i need help. i just found out about this recall of 03/11/92to late for this recall ?. nhtsa campaign 92vo26000 .*ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER
06/16/20001
 When driving 25 mph and upon attempting to stop vehicle by depressing brake pedal , brake pedal went to the floorboard, causing extended stopping distance, which resulted in a rear end crash. consumer contacted dealer, dealer noted that master cylinder failed which caused the problem.*ak