Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER | ||||||||||||||||
96V184000 | FORD MOTOR COMPANY | from 08/19/1996 to 08/23/1996 | V (Vehicle) | 1200 | 09/30/1996 | MFR | FORD MOTOR COMPANY | 09/25/1996 | 10/01/1996 | |||||||
Defect Summary | The retainer clip that holds the master cylinder push rod to the brake pedal arm is missing. | |||||||||||||||
Consequence Summary | A loss of service braking can occur increasing the risk of a vehicle accident. | |||||||||||||||
Corrective Summary | Dealers will inspect to verify that the retainer clips are installed and if clips are missing will install clips. | |||||||||||||||
Notes | Owner notification:owner notification occurred september 30, 1996.note:owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact ford at 1-800-392-3673.also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393. |
Bulletins
Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
---|---|---|---|---|---|
SERVICE BRAKES, AIR - DISC - ROTOR | |||||
9845 | 03/02/1998 | 601264 | Availability of hub-mount brake rotor machining equipment. *yc | 07/15/1998 | |
SERVICE BRAKES, ELECTRIC | |||||
BPI9905 | 01/01/1999 | 605849 | Customer may complain that the raybestos electronic brake controller does not work, works incorrectly, works intermittently, pulses the 4-way flashers, and / or interfers with antilock brakes operation. *tt | 07/29/1999 | |
SERVICE BRAKES, HYDRAULIC | |||||
983564 | 01/01/1998 | 607835 | Experiencing a squealing noise from the front brakes when applying the brakes on some vehicles. *tt | 10/13/1999 | |
99411 | 03/08/1999 | 604767 | Vehicles experiencing increased brake pedal effort and / or false abs cycling at low speeds, or abs lamp illumination. *tt | 05/12/1999 | |
97111097238 | 11/10/1997 | 53664 | Subject on rear vibration/shudder when applying brakes. *yc | 03/30/1998 | |
SERVICE BRAKES, HYDRAULIC - ANTILOCK | |||||
996128 | 05/01/1999 | 606984 | Subject regarding right rear brake concerns under investigation. *tt | 09/09/1999 | |
BC0676961025 | 10/25/1996 | 50355 | Information when electronic/hydraulic control unit (ehcu) malfunctions. *tt | 04/24/1997 | |
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS | |||||
4633 | 08/01/1998 | 615171 | Rear brake drag or excessive wear on rear brakes. *tt | 01/03/2001 | |
985A23 | 03/18/1998 | 601026 | A comprehensive pull and drift diagnostic procedure has been developed to assist technicians in helping to resolve pull or drift conditions. *tt | 12/11/2000 | |
98413 | 03/02/1998 | 601274 | A grabbing condition and / or squeal noise from the rear brakes during first few brake applications after rainfall and / or while brakes are cold. *tt | 07/16/1998 | |
985A25 | 03/18/1998 | 601027 | A vibration or shudder may be felt during braking on some vehicles. *yc | 06/19/1998 | |
985A11 | 03/18/1998 | 601009 | Service tip information regarding elimination of sanding rotors and drums. *yc | 06/17/1998 | |
BC3101970224 | 02/24/1997 | 51713 | Soft brake pedal. *tw | 06/27/1997 | |
96222 | 10/21/1996 | 50941 | Brakes - elimination of sanding rotors and drums - service tip. *tw | 06/17/1997 | |
SERVICE BRAKES, HYDRAULIC - SWITCHES - BRAKE LIGHT | |||||
02176 | 09/02/2002 | 10008580 | Lamp-brake-invadvertent disabling of brake shift interlock. *mj | 08/05/2004 |
Consumer Complaints
Fail date | miles | occurences | Purchase date |
---|---|---|---|
SERVICE BRAKES, HYDRAULIC - ANTILOCK | |||
Mileage is 113,086. have abs. brake lines to both rear wheel have rubbed against moving part of shock absorbers. the rubber covering of brake lines is worn off completely and part of metal is worn. ford double insulated the brake lines so it is clear they know the lines were rubbing agains the shock absorbers. if these lines were to wear through and fluid sprayed out, i dread to think what would happen. to repeat: rear brake lines are rubbing agains part of shock absorbers, thus wearing away all the insulation on line.*ak | |||
02/07/2001 | 4 | 05/01/1997 | |
Very intermittent incidents of false abs cycles when braking to a stop from a low speed. this severely extends the stopping distance which could result in a collision into stopped vehicles. most of the incidents have occurred on dry pavement. the abs warning light does not come on during the incidents. this same problem is described in nhtsa item numbers sb604767 and sb606515. will be taking to ford dealer, but it will be highly unlikely that they will be able to duplicate the problem. *ak | |||
07/01/1999 | 5 | ||
When applying brakes the brake pedal chatters and does not stop truck , only when i lift my foot and apply the brake it works. *ak | |||
01/01/2000 | 1 | ||
When applying brakes rear end vibrates. *ak parking brakes are sticks on causing vibration and inadequate braking. *yh | |||
10/01/1999 | 8 | 08/01/1998 | |
When traveling and upon depressing the brake pedal to make a normal stop the rear brakes lock up, causing the vehicle to go into a skid, resulting in extended stopping distance. consumer has contacted the dealer, parts replaced. *ak | |||
Intermittently abs light will illuminate while vehicle is in motion. dealer has inspected vehicle and has not been able to duplicate the problem, thus the problem cannot be confirmed or corrected. the manufacturer will be notified. *ak | |||
12/24/1998 | 3 | 06/01/1998 | |
Rear brake failure on numerous occasions. finally resulted in crash. dealer could not find any problem. self diagnosis of raising rear of vehicle while idling in drive with rear wheels spinning rear wheels could not be stopped with full brake pressed. no braking on rear wheels. disconnecting wire to proportioning valve results in normal rear brake operation. possible cause is ebcm or proportioning valve. | |||
09/11/1998 | 08/03/1997 | ||
While driving on the highway rear abs brakes failed, vehicle lost control, resulting in a crash. | |||
03/01/1997 | |||
While depressing the brakes the vehicle continues to travel, causing an accident. dealer has been contacted. please provide further details. *ak | |||
07/10/1997 | |||
Consumer was entering a freeway at 45-50 mph when he tried to stop vehicle and could not due to brake failure. *ak | |||
03/05/1997 | 2 | 12/03/1996 | |
When driving on normal road conditions the back brakes do not grab at all or slow the vehicle down. the vehicle has to be taken out of drive and put in neutral in order to stop. on 3/14/97 brakes adjusted by dealership, problem still occurring. *ak | |||
11/10/1996 | |||
Brakes: driving approximately 10mph preparing to make left turn and vehicle would not stop. ice was on highway, applied brakes and pedal went completely to the floor, cause of failure unknown , vehicle not taken in for repairs. manufacturer insists that there is no recall. *ak | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS | |||
11/11/1997 | |||
While driving on wet pavement at any speed and applying brakes, the brake's felt like they were not working and would lock up. also, the rear end of the vehicle would come out from behind. *ak | |||
07/01/1998 | 20 | 04/02/1997 | |
Brakes continually fail, unable to find problem. | |||
06/07/1997 | |||
Driving at various speeds right rear brake will lock up, causing tire to slide. dealer has been notified. *ak | |||
1 | 06/01/1997 | ||
Brakes lock up occasionally. | |||
1 | 09/23/1996 | ||
Brake system overheats and fails. | |||
10/06/1996 | |||
While driving under wet or snowy road conditions the engine goes idle once taking foot off the gas pedal. comsumer also stated that has loss of control of the vehicle once trying and putting on the brakes. consumer contacted the dealer and was told that's how the engine was built into the fuel computer. *ak | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC | |||
Front brake pads and rotors are prematurely wearing out, cause unknown. please give any further details. *ak | |||
09/01/1998 | 1 | 06/01/1997 | |
Rear brakes worn out. yh | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS | |||
11/04/1998 | |||
Tires are rubbing against the rims, and there is a loud noise coming from the tires where the brakes pads are. ak | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR | |||
05/01/2001 | 103000 | 6 | 09/10/1996 |
The brake pedal had to be pumped in order to get the vehicle to stop. the front and rear rotors have been replaced 5 times. the parking brake cable failed and was replaced. the radiator failed 3 times and the heater core failed. *ts *nlm | |||
09/24/1999 | 0 | ||
While getting new tires put on vehicle dealer noticed that front brake rotors were cracked. dealer refused to fix problem, even though car was still under warranty. | |||
02/13/1999 | 2 | ||
Both front rotor assemblies cracked. nlm | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM | |||
10/01/1999 | 11/01/1998 | ||
Rear brakes lock up; abs not working properly; emergeny cable not working properly. | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM - DRUM | |||
06/06/1999 | |||
Left rear drum is overheating . the dealer was contatced, and replaced various parts. otherwise, dealer insisted that can find nothing wrong . *ak | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - HOSES, LINES/PIPING, AND FITTINGS | |||
Mileage is 113,086. have abs. brake lines to both rear wheel have rubbed against moving part of shock absorbers. the rubber covering of brake lines is worn off completely and part of metal is worn. ford double insulated the brake lines so it is clear they know the lines were rubbing agains the shock absorbers. if these lines were to wear through and fluid sprayed out, i dread to think what would happen. to repeat: rear brake lines are rubbing agains part of shock absorbers, thus wearing away all the insulation on line.*ak | |||
11/01/2001 | |||
Both rear brakes line contact with rear shock absorber, cause brak lines to wear and leak.*ak | |||
07/21/2001 | 1 | 02/01/2001 | |
The brake line broke where it is retained by a clip. no previous rough driving or abuse.*ak | |||
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER | |||
10/08/2004 | 1 | ||
Whiel the vehicle was parked for a few days, a mechanic noticed smoke coming from under the truck. he opened the hood and the engine compartment was engulfed in flames. the flames were coming from the master cylinder. as the brake fluid resevoir melted brake fluid it made the fire bigger. no problems with the vehicle prior to the fire. no after market equipment. photos and investigation report mailed to bruce york. *jb |