Bulletins
| Bulletin | Bulletin date | Replacement Bulletin | Item no. | Summary | Added |
|---|---|---|---|---|---|
| SERVICE BRAKES, HYDRAULIC - POWER ASSIST - VACUUM | |||||
| 18223 | 10/01/2004 | 10010734 | Vacuum pump inoperative or runs continuously - climate control defaults to defrost. oasis. to also include 2005 super duty f-series, excursion, and f650/750. *tt | 12/07/2004 | |
Consumer Complaints
| Fail date | miles | occurences | Purchase date |
|---|---|---|---|
| SERVICE BRAKES, AIR | |||
| 07/01/2001 | 13200 | ||
| While applying brakes the vehicle's wheel wont turn. dealer notified. please provide additional information. ts | |||
| SERVICE BRAKES, HYDRAULIC | |||
| 06/01/2005 | 27000 | 4 | 07/20/2002 |
| The consumer stated at 27,000 miles his 2001 ford f250 developed an engine vibration. *jb the consumer was told there was no fix for the problem. when the consumer applied the brakes, there was a vibration. the dealer machined the front rotors and replaced the pads that were cracked. there was a rattle noise coming from under the vehicle. the exhaust shields were loose, the hose clamp on the radiator was replaced and the power door lock was replaced. *jb *nm | |||
| 10/20/2003 | 32000 | 1 | |
| When driving in slush/snow or wet road conditions and depressed brake pedal it went to the floor. when this occurred vehicle either had no brakes or the brakes locked up. as a result, vehicle was almost involved in several accidents. dealership serviced the truck several times, but the problem recurred. *ak | |||
| SERVICE BRAKES, HYDRAULIC - ANTILOCK | |||
| 03/15/2005 | 45000 | 5 | 03/15/2002 |
| Dt: abs brakes, air bags, and fuel system failed. at 4700 miles they replaced the entire brake system. had it a mechanic shop and discovered it was the abs. while going 55 mph and making a left hand turn kept pushing the brakes and nothing happened causing a wreck. kept taking vehicle to ford, they could not find anything wrong. upon impact, air bags also did not deploy. also, fuel lines shut off. this happened on march 15, 2002. *ak *nm | |||
| 04/01/2001 | |||
| While applying brakes and slowing down engine will continue to surge and accelerate. this problem is causing an increase in stopping distance and trouble maintaining control of truck. could not determine a cause for this problem. please provide any additional information / attachments.*ak | |||
| 10/11/2001 | 2 | 10/01/2001 | |
| The problem occurs when applying brakes which causes steering wheel to lock up, resulting in loss of steering control. this occurs at a low speed as well as at a complete stop. dealer states that a higher steering effort w/sitting still w/brakes applied is normal. when ask to try it for himself, he refused. leading me to believe it was impossible for them to use the higher steering effort theory. it is impossible to turn the wheel or steer when brakes are applied at a low speed or at a stop!!! | |||
| 02/06/2001 | 4 | ||
| Automatic fails to shift into lower gears for engine braking. when decending a steep grade the automatic transmission fails to apply. this has the same effect of putting the truck in neutral when going down hill. when driving in the mountains this is extremely dangerous in that it requires the brakes to do the work of slowing the truck. if the brakes overheat then the truck will run away. *ak | |||
| 04/01/2001 | 3 | 02/01/2001 | |
| I have had three incedents in which i had to use heavy braking to to avoid an something. all of these incedents where at speeds above 40 mph. in the first incedent i had to make a heavy emergency application on the brakes. when i did this the truck pulled violently to the left almost causing me to loose control of my truck. it appeared that i did not have any control of the steering of this vehicle. since then i have tried several times to duplicat this situation. it does not allways do it to as a severe degree. but i have got it to violently pull the truck to the left on two other occasions. i am a above average driver because i have been a deputy sheriff for about 16 years and have had alot of experience and training in driving in extreme conditions. i have not taken this truck back to the dealer or rotated the tires because i have been advised that the nhtsa wants to drive one of these trucks before any work is done on them. i would be more than willing to let you drive this vehicle . please advise me what your intentions are. *ak | |||
| 09/26/2000 | 2 | 09/01/2000 | |
| Complete brake failure has occurred. the night i brought it home then two weeks later the same thing. went to apply brakes and pedal went to floor. i did hear a noise coming from under the hood while it occured. after i coasted to stop. brakes were find again. very bizzarre! | |||
| SERVICE BRAKES, HYDRAULIC - ANTILOCK - CONTROL UNIT/MODULE | |||
| 12/14/2006 | 74800 | 20 | 04/11/2001 |
| When applying brakes, the pedal went slowly to floor. pumping brakes helped in stopping failure was in anti-lock brakes control part # 5c7z-2c286-a. *jb | |||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER | |||
| 50000 | |||
| The vehicle experienced rear brake failure while driving. it was later determined that the piston in the caliper exploding and broke into pieces. *nlm | |||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR | |||
| 05/08/2002 | 1 | 09/10/2001 | |
| Vehicle is hard to steer while driving. vehicle had been to dealer and problem was reoccurring. *ak steering is becoming difficult to handle at higher speeds. consumer has to continually be aware because you never know when the steering will fail. also the front rotors needed resurfacing at 25335 miles. the right front was badly warped and was causing a vibration while in motion. it was grabbing at stops or when slowing down. *jg | |||
| SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - HOSES, LINES/PIPING, AND FITTINGS | |||
| 03/12/2004 | 36800 | 1 | 09/12/2001 |
| The left rear brake line failed. the line was made of rubber. as a result, when the brakes were applied, the driver's foot went to the floor and the driver had to down shift to stop the vehicle. *ak *sc *jb | |||
| 03/31/2001 | 1 | 02/24/2001 | |
| The clutch hose hydraulic line the runs from the master cylinder to the clutch slave cylinder melted across the exhaust manifold. | |||
| SERVICE BRAKES, HYDRAULIC - PEDALS AND LINKAGES | |||
| 03/11/2004 | 1 | 03/15/2001 | |
| The brake pedal and the gas pedal are too close, and gas pedal is 1/2 inch lower. when stepping on the brake pedal consumer can hit the gas pedal at the same time. dealer states no modification because of design specifications. *ak this problem would become worse in the winter when the consumer wears boots. *sc | |||
| 01/01/2001 | 0 | ||
| When pressing on brake pedal consumer foot hit gas pedal because the two are so close together. when this happens vehicle will not stop it surges forward. consumer feels this is dangerous.*ak | |||
| 11/01/2000 | |||
| Brake pedal and gas pedal are too close together. consumer is applying brake pedal and will apply gas pedal at same time.*ak | |||
| SERVICE BRAKES, HYDRAULIC - POWER ASSIST | |||
| 04/08/2002 | 1 | 05/07/2001 | |
| While backing out of dealer's service garage, bolts for hydroboost unit broke off. *ak dealer replaced hydroboost unit and added fluid. *tt | |||