Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM - SHOES/LININGS
92V026000FORD MOTOR COMPANYfrom 08/01/1987 to 08/01/1991V (Vehicle)46700006/10/1992ODIFORD MOTOR COMPANY03/03/199203/11/1992
Defect SummaryA revised brake lining noise insulator resulted in a decrease in the thermal insulation between the brake lining and the front brake caliper piston. this caused greater heat transfer to the caliper pistons with the potential to overheat the brake fluid and diminish brake effectiveness during severe braking conditions.
Consequence SummaryIncreased stopping distances and inablility to holdvehicles on a steep grade results in increased risk of accident in the event ofa sudden stop or when constant braking is needed to maneuver through areas withsteep grades.
Corrective SummaryAdd snap-in insulators that attach to each of the front brake caliper pistons. in addition, vehicles with 7.5 l engines will have insulation added to the engine compartment brake lines.
NotesSystem: brakes; front brake lining.vehicle description: f250 and f350 trucks with 7.3 l diesel and 7.5 l efiengines ; f250 and f350 4x4 models with 5.8 l efi engines.note: ford recommends vehicle operators do not exceed the gcwr and gvwr of theirvehicles, and proper maintenance of the brakes on these vehicles and any trailerparticularly when operating in mountainous areas with long, steep grades.

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
985A2903/18/1998601036Some vehicles may exhibit excessive brake pedal travel, irregular front lining wear, and brake pull. *yc06/23/1998
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER
985A3803/18/1998601045Front caliper piston boots damaged. *yc06/23/1998

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
SERVICE BRAKES, HYDRAULIC
EA91044FORD MOTOR COMPANY10/30/199110/30/1992LOSS OF BRAKE EFFECTIVENES92V026000
 There is no summary currently available
PE91077FORD MOTOR COMPANY05/23/199110/31/1991LOSS OF BRAKE EFFECTIVENES
 There is no summary currently available
PE94004FORD MOTOR COMPANY01/25/199404/29/1994HYDRAULIC BRAKE LINE CRACKS/LEAKS
 There is no summary currently available

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, HYDRAULIC
 Total brake loss while being operated under hot hilly conditions.
SERVICE BRAKES, HYDRAULIC - ANTILOCK
06/01/1994009/01/1989
 Vehicle's rear differential seals are leaking and oil is falling onto abs, rear brake lining causing complete loss of brakes or lockup due to dirt accumulation. *ak
104/01/1989
 The rear housing seal replaced three times within two years, the gas gauge stopped working , please describe . *ak
05/07/1995
 Abs system has gone bad, brakes locked up while attempting to stop. tt
01/01/1990
 When it rains abs lock up. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
1
 Brake failure while being operated under hot hilly conditions.
06/06/19926
 Grease on rear brake seals, they failed while driving. oil would get onto brakes. could see oil dripping. brakes would lock up. rear brakes not effective at all, especially while towing a trailer. will have dealer check out seals. *ak
11/03/19943
 Brakes failed. *sd
04/29/1996
 Brake failure, when brakes are applied, pedal goes to the floor and experienced extended stopping distance. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS
06/11/1990612/31/1988
 Rear wheel grease retainer seals failed six times, causing oil to leak on rear brake shoes.
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM - SHOES/LININGS
06/01/1994009/01/1989
 Vehicle's rear differential seals are leaking and oil is falling onto abs, rear brake lining causing complete loss of brakes or lockup due to dirt accumulation. *ak