Ford Ford 1969

Model Ford made in 1969 by Ford got 6 recalls. There were some recalls concerninglatches/locks/linkages, service brakes, hydraulic and steering.

Ford year 1969

Recalls

Model 1969

Recalls

Campaign	Manufacturer	Manufacturing date	Type	# of units affected	Date Owner notified Mfg	Recall Initiated by	Manufacturers of recalled vehicles/products	Report Recieved Date	Record Creation Date
LATCHES/LOCKS/LINKAGES - HOOD - LATCH
69V077000	FORD MOTOR COMPANY		V (Vehicle)	354000	05/27/1969	MFR	FORD MOTOR COMPANY	06/02/1969	10/12/1979
Defect Summary
Consequence Summary
Corrective Summary
Notes	Possibility that hood latch mech- anism has insufficient clearance betweenparts.this could cause primary hood latch to bind, thus interfering with hoodclosure and preventing secondary latch from engaging, in which case hood couldopen while car is in motion.(correct by inspecting and replac- ing latch whennecessary.)
SERVICE BRAKES, HYDRAULIC - FLUID
69V110000	FORD MOTOR COMPANY	from 04/01/1969 to 06/01/1969	V (Vehicle)	110000	08/11/1969	MFR	FORD MOTOR COMPANY	08/15/1969	10/12/1979
Defect Summary
Consequence Summary
Corrective Summary
Notes	Possibility that brake fluid may contain excessive inorganic chloride whichwould have adverse effect on corrosion of brake components.this conditionwould ultimately cause brake malfunction.(correct by purging brake system ofold fluid and replacing with proper type.)
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DIFFERENTIAL PROPORTIONAL VALVE
68V126000	FORD MOTOR COMPANY	to 10/01/1968	V (Vehicle)	75000	11/28/1968	MFR	FORD MOTOR COMPANY	12/03/1968	10/12/1979
Defect Summary
Consequence Summary
Corrective Summary
Notes	Possibility front brake hoses incorrectly routed on vehicles equipped with drum-type brakes.improperly positioned hoses may be damaged through contact with brake drums, causing front brakes to become inoperative.however, rear brakes would not be affected due to dual brake system.(correct by inspecting and properly routing hoses where necessary.)
STEERING - LINKAGES - KNUCKLE - SPINDLE - ARM
77V009000	FORD MOTOR COMPANY		V (Vehicle)	5387	05/16/1977	ODI	FORD MOTOR COMPANY	01/27/1977	10/12/1979
Defect Summary	The front wheel spindle on the involved vehicles may crack in service. spindle stem separation could occur due to failure of the stem at the inner bearing fillet location.
Consequence Summary
Corrective Summary	The dealer will replace both front spindles, if necessary, free of charge.
Notes	Vehicle description: passenger vehicles equipped with police package andoptional front disc brakes.system: steering; front wheel spindle.consequences of defect: should separation occur, loss of vehicle control and anaccident could result.
SUSPENSION - FRONT - CONTROL ARM - LOWER ARM
70V105000	FORD MOTOR COMPANY		V (Vehicle)	85000	09/01/1970	ODI	FORD MOTOR COMPANY	09/03/1970	10/12/1979
Defect Summary
Consequence Summary
Corrective Summary
Notes	Possibility that cracks can be induced in front lower control arms if frontsuspension is repeatedly subjected to very severe loading sometimesentercountered in police service.such cracking could ultimately result infracture through arm in ball joint area, and cause discon- nection betweenlower control arm and front wheel which would seriously hamper driver's abilityto fully control vehicle.(correct by replacing with a heavy duty improvedarm.)
VEHICLE SPEED CONTROL - CABLES
69V060000	FORD MOTOR COMPANY	from 02/01/1969 to 03/01/1969	V (Vehicle)	6823	05/02/1969	MFR	FORD MOTOR COMPANY	05/07/1969	10/12/1979
Defect Summary
Consequence Summary
Corrective Summary
Notes	Possibility that accelerator cable was manufactured with improper wire cord.in cold weather may bind, holding accelerator open rather than permittingnormal deceler- ation.(correct by inspecting and installing new cable whenneces- sary.)