Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SERVICE BRAKES, AIR - DISC - ROTOR
984503/02/1998601264Availability of hub-mount brake rotor machining equipment. *yc07/15/1998
SERVICE BRAKES, HYDRAULIC - ANTILOCK
785401/01/20007854612215Abs diagnostic trouble codes(dtcs) can only be retrieved using super starii tester or the flash out procedure by grounding out diagnostic circuit at test connector.06/07/2000
9521210/01/199546478The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable because it may be incompatible with the rubber material used in the disc brake system. if petroleum-based grease is used to lubricate any par04/25/1996
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
9919409/20/19996090082Information for servicing and diagnosing brake vibration, brake inspection, and brake friction material replacement. *tt03/06/2000
985A1103/18/1998601009Service tip information regarding elimination of sanding rotors and drums. *yc06/17/1998
985A903/18/1998601007On cobra vehicles only, a rattling noise may be heard from the front wheels when going over bumps and / or a clunking noise may be heard when stopping from reverse. *tt06/17/1998
9622210/21/199650941Brakes - elimination of sanding rotors and drums - service tip. *tw06/17/1997
9511206/01/199545078Cobra vehicles only - a rattle noise may be heard from the fron wheels when going over bumps and/or a clunk noise may be heard when stopping from reverse. *tw11/01/1995
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
985A1303/18/1998601012The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable. *yc06/17/1998
BC285095040104/01/19953010500Unknown11/01/1995
956203/01/199539900Roughness concern during brake application. *tw11/01/1995
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS
9626412/16/199650990Brakes - rear brakes squeak - vehicles built through 11/20/94. *tw06/17/1997
956303/01/199539901Rear brake squeak. *tw11/01/1995
BC285095040104/01/19953010500Unknown11/01/1995
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR
981401/19/1998605562Subject regarding the availability of hub-mount brake rotor machining equipment. *tt07/09/1999
985A503/18/1998601003Hub-mount brake rotor machining equipment from rotunda is now approved for warranty and service use. *yc06/17/1998
9423511/01/199437731Front disc brake noise while braking. *tw01/06/1995
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM
985A1003/18/1998601008Experiencing a squeaking noise coming from the rear brakes on some vehicles. *tt06/17/1998
SERVICE BRAKES, HYDRAULIC - SWITCHES - BRAKE LIGHT
0217609/02/200210008580Lamp-brake-invadvertent disabling of brake shift interlock. *mj08/05/2004

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
SERVICE BRAKES, HYDRAULIC
EA98013FORD MOTOR COMPANY05/27/199810/31/2000PARKING BRAKE00V349000
 Consumers allege that when engaged, the parking brake failed to hold the vehicle stationary, and the vehicle rolled away
PE97051FORD MOTOR COMPANY12/23/199705/27/1998PARKING BRAKE FAILURE
 Consumers allege that when engaged, the parking brake failed tohold the vehicle stationary, and the vehicle rolled away.

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, HYDRAULIC
10/15/2002110000
 The major problem was the head gasket failure (after 100,000 miles) with the engine needing to be replaced. i was not notified at any time regarding this recall. ford denies that this problem was a recall and that it was my fault that the engine went since i do not do all my repairs at the ford dealership and if i had, i would've been notified of the head gasket failure problem. even though i was not notified by mail or by phone of this problem, ford told me that since the car went over 100,000 miles and was three monthe past the deadline date that i was out of luck and that there would be no extensions or exceptions. the biggest problem that i have is that i did not experience a head gasket failure during their so called warranty extension period and that my 1994 ford mustang only failed shortly after the warranty extension expired. a defective part is a defective part from the day of manufacture to the day the car is junked unless the part is repaired or replaced. so much time and money was put out by me because of ford's lack of customer service. i deserved to have been reimbursed by the ford motor corporation but in turn i received nothing. i could go on but this is very upsetting to me. thank you for listening.
SERVICE BRAKES, HYDRAULIC - ANTILOCK
09/01/1997
 Can ford do anything right car has broken down more than i can remember! *ak
05/15/1997605/01/1994
 I have experienced two separate problems with my ford mustang gt. both problems have been repaired while the vehilce was under warranty, however, i feel that the actions taken were only sufficient to carry the vehicle through the warranty period. the largest problem that i have experienced has been with my antilock brakes. on six different occasions i have had my vehicle in the shop at ford dealers for repairs to my antilock brakes. the typical prognosis was that a sensor needed to be changed. ironically, once the vehcile was out of warranty, due to age, the antilock brake failure required a new module costing approximately $1,200. i pleaded my case with ford on this expense and they agreed to pick up the cost of the repair. no later than 4 months had passed and the problems continued. i procrastinated some four to five months prior to having the vehicle returned to the same dealership for repairs to the antilock brakes. this time the problem was different and would cost $1,100. again i pleaded
10
 Abs light will come on/off, sometimes it will stay on. dealer replace sensor/bad grounding/bad connecting wire. said cannot replace whole abs system. has been to different dealer, defect still reoccurring. *ak
12/24/1994
 Brakes periodically lockup while driving causing accident at 15mph. tt
03/23/1995
 Consumer was driving try to stop the abs anti lock brake lock up cause accident. tt
01/23/1995
 In rainy weather no response from the anti lock and braking system. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
12/17/2002187111
 Sudden failure of one- of the two mounting studs which secure the service brake master cylinder to the brake power booster unit. loss of stud allowed master cylinder to move when service brake pedal applied - diminishing braking performance.*ak
04/14/19940
 While driving, started to slow down, weather rainy, rearended another vehicle, the brakes failed to catch, traveling at 45 mph, air bag did not deploy. *ak
08/01/19941
 Brakes failed 4 times. *sd
10/10/1995
 Fuel throttle linkage failure, accelerator pedal stuck, unable to stop vehicle. tt
03/23/19951
 While driving on wet road came to a light tried to stop and brakes locked up, vehicle lost control/skidded, resulting in an accident/injury. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
09/01/19972
 Braske pedal makes a loud creaking noise whenever it is depressed. dealer replaced brake booster twice, but noise continues. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS
205/17/1994
 Air bag light has come on twice. also replaced warped rear rotors and pads. *ak
04/01/1994103/01/1994
 Vehicle pulls to the left at any speed, replaced pads/rotors/and other parts, to no avail. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR
05/01/19955
 Rotors warp prematurely. nlm
4
 Driver's seat caught on fire while parking car in garage. replaced front brake rotors due to warping. also, air bag sensor has come on twice. dup of 517543, added on 25-feb-98. *ak
205/17/1994
 Air bag light has come on twice. also replaced warped rear rotors and pads. *ak
02/01/19941
 Front wheel brake rotors warped twice. *dsh
09/11/19951
 Front brake rotors failed, causing vehicle to pull from left to right, also shakes/vibrates. *ak
04/01/1994103/01/1994
 Vehicle pulls to the left at any speed, replaced pads/rotors/and other parts, to no avail. tt
12/15/19941
 Brake rotors failed. *skd
01/01/1995
 Abs rotors and grinding, when brakes are applied vibration in front vehicle shakes very hard. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - HOSES, LINES/PIPING, AND FITTINGS
1
 Upon crossing a bump in the roadway, brake line severed, causing brake failure.
SERVICE BRAKES, HYDRAULIC - PEDALS AND LINKAGES
08/01/1997
 When applying force to the brake pedal consumer is depressing on the accelerator pedal due to the location, causing unwaited acceleration. consumer has yet to contact the dealer. *ak
SERVICE BRAKES, HYDRAULIC - POWER ASSIST - VACUUM
09/01/19972
 Braske pedal makes a loud creaking noise whenever it is depressed. dealer replaced brake booster twice, but noise continues. *ak