Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SERVICE BRAKES, AIR - DISC - ROTOR
984503/02/1998601264Availability of hub-mount brake rotor machining equipment. *yc07/15/1998
SERVICE BRAKES, HYDRAULIC - ANTILOCK
785401/01/20007854612215Abs diagnostic trouble codes(dtcs) can only be retrieved using super starii tester or the flash out procedure by grounding out diagnostic circuit at test connector.06/07/2000
9521210/01/199546478The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable because it may be incompatible with the rubber material used in the disc brake system. if petroleum-based grease is used to lubricate any par04/25/1996
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
9919409/20/19996090082Information for servicing and diagnosing brake vibration, brake inspection, and brake friction material replacement. *tt03/06/2000
985A1103/18/1998601009Service tip information regarding elimination of sanding rotors and drums. *yc06/17/1998
9622210/21/199650941Brakes - elimination of sanding rotors and drums - service tip. *tw06/17/1997
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
985A1303/18/1998601012The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable. *yc06/17/1998
BC285095040104/01/19953010500Unknown11/01/1995
956203/01/199539900Roughness concern during brake application. *tw11/01/1995
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS
9626412/16/199650990Brakes - rear brakes squeak - vehicles built through 11/20/94. *tw06/17/1997
BC285095040104/01/19953010500Unknown11/01/1995
956303/01/199539901Rear brake squeak. *tw11/01/1995
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR
981401/19/1998605562Subject regarding the availability of hub-mount brake rotor machining equipment. *tt07/09/1999
985A503/18/1998601003Hub-mount brake rotor machining equipment from rotunda is now approved for warranty and service use. *yc06/17/1998
9423511/01/199437731Front disc brake noise while braking. *tw01/06/1995
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM
985A1003/18/1998601008Experiencing a squeaking noise coming from the rear brakes on some vehicles. *tt06/17/1998
SERVICE BRAKES, HYDRAULIC - SWITCHES - BRAKE LIGHT
0217609/02/200210008580Lamp-brake-invadvertent disabling of brake shift interlock. *mj08/05/2004

Investigations


NHTSA IDManufacturerDate openDate closeSubjectRecall campaign
SERVICE BRAKES, HYDRAULIC
EA98013FORD MOTOR COMPANY05/27/199810/31/2000PARKING BRAKE00V349000
 Consumers allege that when engaged, the parking brake failed to hold the vehicle stationary, and the vehicle rolled away
PE97051FORD MOTOR COMPANY12/23/199705/27/1998PARKING BRAKE FAILURE
 Consumers allege that when engaged, the parking brake failed tohold the vehicle stationary, and the vehicle rolled away.

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, AIR - ANTILOCK - WHEEL SPEED SENSOR
05/06/19991
 Consumer could hear a ping noise under the engine area, consumer had ran over a foreign object that damaged the shield and speed sensor. *slc
SERVICE BRAKES, HYDRAULIC - ANTILOCK
01/14/20020
 While driving about any mph could step on the brakes pedal to stop or reduce speed, but will not stop, causing an extended stopping distance that could not be explained by dealer. please provide more information.*ak
01/14/20020
 While driving could apply brakes and would hear a loud noise.had taken vehicle to dealer, and they found out that caliper became loose, but could be fixed. however, it will get loose again. please provide more information.*ak
09/27/2000111/01/1998
 3 separate problems: front disk rotors have warped twice and had to be reground. a/c compressor bearings froze causing drive belt to emit acrid smoke that filled the passenger compartment (happened on original and again on replacement). temp gauge showed fluctuating temperature until bearings froze completely (happened with 2 different compressors). parking brake released causing car to roll into neighbors vehicle, causing damage (parking brake handle was in the up position with no tension felt when the parking brake was moved to the down position.)
12/13/19962
 When braks are applied, the brakes start to have severe pulsating/ hard to control. took to mechanic & was informed irregularities in brake rotors. needed replacing. happened before & brakes were repaired then. *ak
01/30/19971
 Consumer was driving away from stop light when she saw a vehicle 5 cars up ahead, she began to apply the brakes and vehicle never slowed down until she crashed into the rear end of the vehicle. schroeders body shop has vehicle to repair. the hood and fender /headlights. the dealership will be looking at vehicle to determine cause of brake failure. bob bennet ford. *ak
04/29/19974
 While driving vehicle and applying abs brakes, vehicle would shake excessively, took to dealer & was informed that it was warped rotors each time it happened, would rotate them. *ak
 Abs brakes are not safe and it takes a lot of effort to stop vehicle, even after extensive work had been proformed. *ak
10/02/1995
 Consumer was driving on highway went to apply the brakes failed have abs anti-lock brake passenger side air bag deployed and caused the consumer hand to break.
09/03/1995
 Upon braking @ 45 to 50 mph, brakes failed not responding. master cylinder was empty w/copper washer missing on left rear. vehicle has abs brakes. describe. tt
01/06/1995
 Abs brake system did not grab after trying to slow down from 60mph, almost resulting in accident. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
1
 Brake pads and rotors were replaced after 12000 miles. tires were also replaced after 12000 miles, no specific tire information given, consumer is requesting that ford pay for these items to be replaced. *slc
09/27/2000111/01/1998
 3 separate problems: front disk rotors have warped twice and had to be reground. a/c compressor bearings froze causing drive belt to emit acrid smoke that filled the passenger compartment (happened on original and again on replacement). temp gauge showed fluctuating temperature until bearings froze completely (happened with 2 different compressors). parking brake released causing car to roll into neighbors vehicle, causing damage (parking brake handle was in the up position with no tension felt when the parking brake was moved to the down position.)
 While traveling 45 mph on wet pavement& trying to avoid an accident by depressing the brakes, vehicle went into a skid, causing consumer to be apart of the accident.daler has been notifed. please provide further informtaion. *ak
1
 Brakes cause vibration when applied, repairs to components did not rectify vibration.
02/03/1997109/01/1995
 Vehicle shakes violently upon application of brakes.
 When applying the brakes, car pulls to the right. please describe. *ak
12/22/1995
 Failure of the brake system had to replace the brakes often. tt
12/18/1995
 The right side rear brake keeps locking up when braking. tt
01/22/1995
 Brake makes noise took back to the dealer checked it out noise stopped now its back and passenger seat belt lock up and will not release passenger. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
05/17/20010
 Front brakes don't work properly. when going over a bump, it feels like vehicle hydroplaining, and its hard to keep control. *ak
02/05/19951
 Replaced front brakes 4 times. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER
01/14/20020
 While driving could apply brakes and would hear a loud noise.had taken vehicle to dealer, and they found out that caliper became loose, but could be fixed. however, it will get loose again. please provide more information.*ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS
1
 The brake pads and rotors are faulty. nlm
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR
1
 The brake pads and rotors are faulty. nlm
04/18/2000207/01/1996
 Vehicle has been serviced for front brake rotor repair under warranty.*jb
09/27/2000111/01/1998
 3 separate problems: front disk rotors have warped twice and had to be reground. a/c compressor bearings froze causing drive belt to emit acrid smoke that filled the passenger compartment (happened on original and again on replacement). temp gauge showed fluctuating temperature until bearings froze completely (happened with 2 different compressors). parking brake released causing car to roll into neighbors vehicle, causing damage (parking brake handle was in the up position with no tension felt when the parking brake was moved to the down position.)
08/05/20001008/01/2000
 Baught car in august of 2000, drove it one week and it has been in the shop numerous times for various items fixed; ie; overheated twice then blew headgasket, drivers rear rotor caught on fire, recall on hood which was separating, major fuel leak, fuel hose by fuel tank, water leak from timing cover gasket
04/03/2000101/01/1995
 This engine is the same as the taurus and windstar. both vehicles engines have bullitins on their head gasket problems. the mustang has the same problems but ford refuses to do anything about this. i run synthetic oil in this car and have changed the antifreeze every 20000 miles. i change the oil at 3000 miles religiously . this is the only reason it has lasted this long. i have also had problems with the a/c brake rotors and rear differential. ford needs to address this problem, and quite making excuses.rress/cytrh
09/14/1998
 While driving the front end vibrates. the dealer informed the owner that the rotors are warped. the dealer has replaced the rototr twice. *ak
12/13/19962
 When braks are applied, the brakes start to have severe pulsating/ hard to control. took to mechanic & was informed irregularities in brake rotors. needed replacing. happened before & brakes were repaired then. *ak
04/29/19974
 While driving vehicle and applying abs brakes, vehicle would shake excessively, took to dealer & was informed that it was warped rotors each time it happened, would rotate them. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER
09/03/1995
 Upon braking @ 45 to 50 mph, brakes failed not responding. master cylinder was empty w/copper washer missing on left rear. vehicle has abs brakes. describe. tt