Ford Pinto 1978
Model Pinto made in 1978 by Ford got 1 consumer complain as well as 3 recalls. Consumer complaints with reference to electrical system. . There were some recalls concerningengine and engine cooling and fuel system, gasoline.
Model 1978
Recalls
Campaign | Manufacturer | Manufacturing date | Type | # of units affected | Date Owner notified Mfg | Recall Initiated by | Manufacturers of recalled vehicles/products | Report Recieved Date | Record Creation Date | Regulation Part Number | FMVSS Number | |||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
ENGINE AND ENGINE COOLING - COOLING SYSTEM - FAN | ||||||||||||||||
83V025000 | FORD MOTOR COMPANY | from 08/01/1976 to 07/01/1978 | V (Vehicle) | 83000 | 03/22/1983 | MFR | FORD MOTOR COMPANY | 03/01/1983 | 03/11/1983 | |||||||
Defect Summary | The flexible blade engine cooling fan blades may crack and break off. this may be caused by high blade stresses that can result from vibration during vehicle operation. | |||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | Dealer will replace the defective engine cooling fan at no cost to owner. | |||||||||||||||
Notes | Vehicle description: passenger vehicles equipped with 2.8 liter engines andoptional air conditioning.system: engine; engine cooling fan.consequences of defect: a blade fragment may separate from the fan assemblywithout prior warning. a broken blade or fragment may damage under-hoodcomponents.note: if the hood is open when blade separation occurs, persons near thevehicle could be seriously injured. | |||||||||||||||
FUEL SYSTEM, GASOLINE - DELIVERY - FUEL PUMP | ||||||||||||||||
07E064000 | FEDERAL-MOGUL CORPORATION | E (Equipment) | 34000 | 10/15/2007 | MFR | FORD MOTOR COMPANY | 08/27/2007 | 08/24/2007 | ||||||||
Defect Summary | Certain federal-mogul aftermarket fuel pumps sold under the brand names of carter, accuflow, napa, truflow, parts depo, and parts master, shipped between august 2006 and july 2007 for use on the vehicles listed above. the fuel pump diaphragm in certain production runs may have been improperly installed or inadequately tested which may cause the fuel pump to leak. | |||||||||||||||
Consequence Summary | A leaking fuel pump could create a vehicle fire hazard. | |||||||||||||||
Corrective Summary | Federal-mogul will notify owners and replace the defective fuel pumps free of charge. the recall began on october 15, 2007. owners can contact federal-mogul at 248-354-7700. | |||||||||||||||
Notes | This recall only pertains to aftermarket carter, napa, accuflow, tru flow, parts master, and parts depot brand fuel pumps and has no relation to any original equipment installed on the listed motor vehicles.customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.safercar.gov. | |||||||||||||||
SEAT BELTS - FRONT - RETRACTOR | ||||||||||||||||
78V047000 | FORD MOTOR COMPANY | from 09/01/1977 to 09/01/1977 | V (Vehicle) | 1956 | 04/07/1978 | MFR | FORD MOTOR COMPANY | 03/08/1978 | 10/12/1979 | 571 | 208 | |||||
Defect Summary | The automatic locking rear seat belt retractors on certain vehicles may fail to lock due to binding of the locking pawl against the retractor housing. this binding is caused by retractor housing deformation which occurred during assembly. as a result the passengers would be restrained only by the fully extended belt. this fails to comply with federal motor vehicle safety standard no. 208, occupant crash protection. | |||||||||||||||
Consequence Summary | ||||||||||||||||
Corrective Summary | Dealer will inspect and, if necessary, replace one or both rear seat belt assemblies free of charge. | |||||||||||||||
Notes | Vehicle description: passenger vehicles.system: interior; rear seat belt retractors.consequences of defect: inadequately restrained passengers could be seriouslyinjured in the event of an accident. |
Consumer Complaints
Fail date | miles | occurences | Purchase date |
---|---|---|---|
ELECTRICAL SYSTEM - WIRING - INTERIOR/UNDER DASH | |||
07/29/2003 | 3 | ||
I have had problems with the plastic panels on the back of the instrument clusters deteriorating and crumbling with heat and age on 3 cars. these were a 1976 ford pinto wagon, a 1976 ford e250 club wagon van, and a 1972 amc matador (appearently the same ford design of this part). this part holds the connectors and components onto the plastic ribbon that carries the wiring. i found that this causes loose connections and i believe that it could start a fire, in addition to the instrumention not working. i have also heard of this same problem from several other people in ford vehicles. it seems to become appearant when they are over about 10 years old.*ak |