Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
SERVICE BRAKES, AIR - DISC - ROTOR
984503/02/1998601264Availability of hub-mount brake rotor machining equipment. *yc07/15/1998
SERVICE BRAKES, HYDRAULIC - ANTILOCK
9521210/01/199546478The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable because it may be incompatible with the rubber material used in the disc brake system. if petroleum-based grease is used to lubricate any par04/25/1996
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
9919409/20/19996090082Information for servicing and diagnosing brake vibration, brake inspection, and brake friction material replacement. *tt03/06/2000
985A1103/18/1998601009Service tip information regarding elimination of sanding rotors and drums. *yc06/17/1998
9622210/21/199650941Brakes - elimination of sanding rotors and drums - service tip. *tw06/17/1997
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
985A1303/18/1998601012The use of petroleum-based grease as a lubricant in servicing disc brakes is no longer acceptable. *yc06/17/1998
956203/01/199539900Roughness concern during brake application. *tw11/01/1995
956203/01/19953012200Unknown11/01/1995
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR
981401/19/1998605562Subject regarding the availability of hub-mount brake rotor machining equipment. *tt07/09/1999
985A503/18/1998601003Hub-mount brake rotor machining equipment from rotunda is now approved for warranty and service use. *yc06/17/1998
SERVICE BRAKES, HYDRAULIC - SWITCHES - BRAKE LIGHT
0217609/02/200210008580Lamp-brake-invadvertent disabling of brake shift interlock. *mj08/05/2004

Consumer Complaints


Fail datemilesoccurencesPurchase date
SERVICE BRAKES, HYDRAULIC - ANTILOCK
07/01/1999
 While applying brakes vehicle pulls to right or left which may cause a loss of vehicle control. dealer replace the front brake calipers 2 times, and brake master cylinder once. problem is still occurring. dealer cannot determine the problem. please provide further information.*ak
1005/28/1998
 Check engine light remains on. consumer continuously has to replace brakes. also vehicle hydroplanes at slightest acceleration when the roads are wet.
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS
08/12/1998
 Vehicle was traveling 40mph downhill, applied brakes and they went to the floor, no brake response, hit a truck, frontal impact. dealer contacted, and cannot duplicate the problem. *ak
 Seatbelt (all) motor doesn't run and backseat stick, power locks only work when it warm, drivers side door doesn't work at all. camshaft pulley was recalled and supposedly fixed, just after warranty ran out it broke again. brakes go out ever six month, replaced waterpump twice, idle pulley, fan motor and the lower front ball joints, starter, alternator, battery twice, entire muffler system 3 times, bar that goes across the front by the wheels, blower motor chrips and squeeks at low blowing speeds, replace muffler heat shields and there still is clanging noise in the front crankshaft, also replaced motor mounts, should have kept the beater it was much cheaper.
05/01/199806/11/1995
 Left rear brake shoe linings separated from shoes. left rear wheel bearings came apart. both rear brake cylinders leaked. front engine pulley/harmonic balancer came apart.
05/29/1996109/01/1993
 Front brakes pulsate. *sd
05/29/1996
 Vehicle did not shut down. put it in neutral than it slowed down. brakes melted hub caps to the wheel. *ak
 Experienced brake grinding, had replaced four times. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC
01/01/1995
 Brake failure, replacement of disc rotors, pads and calipers and fittings in the front, still experience pedal fading. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - CALIPER
07/01/1999
 While applying brakes vehicle pulls to right or left which may cause a loss of vehicle control. dealer replace the front brake calipers 2 times, and brake master cylinder once. problem is still occurring. dealer cannot determine the problem. please provide further information.*ak
01/15/1996
 The right brake cylinder will not hold the brake line which causes loss of brakes when applied. please describe. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - PADS
105/28/1998
 Brake shoes and rotors failed. *et
08/07/19952
 Brake pads and rotors failed on two occasions, causing grinding and vibration. mjs
107/01/1993
 Brake pads replaced.
 Purchased car used, the driver's and passenger's side seat belt retractors stopped working and the brake pads were replaced on four occasions and make noise . please describe .
03/03/19951
 Excessive wear of pads, causing vehicle to vibrate upon braking. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DISC - ROTOR
105/28/1998
 Brake shoes and rotors failed. *et
08/07/19952
 Brake pads and rotors failed on two occasions, causing grinding and vibration. mjs
1005/28/1998
 Check engine light remains on. consumer continuously has to replace brakes. also vehicle hydroplanes at slightest acceleration when the roads are wet.
03/21/1996003/01/1994
 While driving vehicle, went to apply brakes, made loud noises, had not warning. brakes worn out, returned vehicle home. took it to a mechanic & was informed that rotors had to be turned & new brakes put on. manual says ck at 30,000; dealer says 5,000. *ak *ak
 Rotors have been replaced four times. please give more details. *ak
 Brakes shimmy upon application. dealer installed shoes, hubs and rotors. every couple of months dealer replaces same components. please describe details. tt
06/16/1995
 The rotor had to be replace two time consumer almost had 2 accident this weekend . tt
03/03/19951
 Replaced rotors due to vehicle vibration. *ak
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - DRUM - SHOES/LININGS
1005/28/1998
 Check engine light remains on. consumer continuously has to replace brakes. also vehicle hydroplanes at slightest acceleration when the roads are wet.
 Brakes shimmy upon application. dealer installed shoes, hubs and rotors. every couple of months dealer replaces same components. please describe details. tt
SERVICE BRAKES, HYDRAULIC - FOUNDATION COMPONENTS - MASTER CYLINDER
12/15/19955
 Brake master cylinder failed, causing accident/injuries. *dsh
SERVICE BRAKES, HYDRAULIC - PEDALS AND LINKAGES
11/11/19943
 Brake pedal too small and too high, causing accident. *skd
SERVICE BRAKES, HYDRAULIC - POWER ASSIST
07/01/1999
 While applying brakes vehicle pulls to right or left which may cause a loss of vehicle control. dealer replace the front brake calipers 2 times, and brake master cylinder once. problem is still occurring. dealer cannot determine the problem. please provide further information.*ak
SERVICE BRAKES, HYDRAULIC - POWER ASSIST - HYDRAULIC
09/12/19961
 Brake switch wire failed, vehicle would not come out of park. mjs