Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
STRUCTURE - BODY - BUMPERS
983202/16/1998600586Front and rear bumpers made of xenoy plastic have had the conductive primer removed from service parts. *yc05/27/1998

Consumer Complaints


Fail datemilesoccurencesPurchase date
STRUCTURE - BODY - DOOR
11/17/2000
 Harness straps and two back power locks are defective. harness strap will strap on correctly, and two back doors won't even open. contacted dealer, and the dealer has not done anything to remedy situation.*ak
07/07/1996405/01/1994
 Windshield wiper motor: the original windshield wiper motor was replaced with a rebuit one since the original failed to operate on any of the intermittent settings. it would work on high and low only. the original motor was replaced with a rebuilt wiper motor and operated fine but made a loud noise. i had the rebuilt wiper motor replaced with another rebuilt wiper motor and have had it for 13-14 months. the wiper motor i have currently is now making the same noise as with the second wiper motor. it is still operational at this point on all settings.door locks: the power door locks have individually stopped working at different times. i used wd-40 on all of the locks and it has helped all but one (rear passenger side) that refuses to work when depressing the lockunlock button. it will still work manually. revving of engine: the engine will rev very high when the car is placed in park. pressing the brake or the gas pedal does not decrease the revving nor does lifting the gas pedal up. the only solution is to turn the car off and to turn it back on. this is tied to the car accelerating without pressing on the gas pedal. they both happened on the same brief trip (20 miles) but have also happened individually on separate occasions. the car accelerates slowly - approximately 1 mile per second - and will continue until about 40 - 50mph where its remains constant. no dealer has been able to determine the problem even after searching the cars computer for a stored code or cause. ignition: the key has become stuck in the ignition on several occasions. the key will not come out because the ignition does not return back to the place where you can remove the key. to help clarify - it gets frozen in the postion where you would turn the key to roll the windows up/down but not start the car. i have had to move/jiggle it back and forth to get the igniton to return back to home state and to the position where i was able to remove the key.
 Seatbelt (all) motor doesn't run and backseat stick, power locks only work when it warm, drivers side door doesn't work at all. camshaft pulley was recalled and supposedly fixed, just after warranty ran out it broke again. brakes go out ever six month, replaced waterpump twice, idle pulley, fan motor and the lower front ball joints, starter, alternator, battery twice, entire muffler system 3 times, bar that goes across the front by the wheels, blower motor chrips and squeeks at low blowing speeds, replace muffler heat shields and there still is clanging noise in the front crankshaft, also replaced motor mounts, should have kept the beater it was much cheaper.
112/06/1993
 Power door locks inoperative in inclement weather.
STRUCTURE - BODY - DOOR - HINGE AND ATTACHMENTS
1
 Door is falling off due to pillar rusting around the hinge.
12/01/1995110/01/1993
 The brackets that hold the gas tank up are corroded , also the tank is leaking. *ak consumer states gas tank has rusted, the hinges on driver and passenger side were also found to be rusted, consumer contacted dealership and was told vehicle was out of warranty and consumer would be responsible for repairs, consumer received a call from delarship and was advised the repairs would be done free of charge.*jb
STRUCTURE - FRAME AND MEMBERS
104/28/1994
 Vehicle experiences massive rusting of the frame and hinge pillars, the hinge pillars are the main support of both doors. mjs