Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
POWER TRAIN - AUTOMATIC TRANSMISSION
08-07-30-02305/01/2008100256704l60-e/4l65-e/4l70-e automatic transmission fluid leak from oil pump or bell housing area (replace torque converter hub-to-oil pump seal assembly). attn: this bulletin applies to vehicles built prior to december 2007. *pe08/28/2008
393109/28/20063931A10021018No movement when the shift lever is moved to d4 or d3. normal operation when moved to d2 d1 or reverse. *kb updated. *kb02/22/2007
POWER TRAIN - AUTOMATIC TRANSMISSION - CONTROL MODULE (TCM, PCM)
SB-07-06-04-019A11/01/200810028831General motors: intermittent mil/ses/ dtc p2138 with reduced engine power (repair instrument panel (ip) to body harness connector). 2005-08 gm passengers cars/light duty trucks (incl. saturns). *pe06/01/2009
306112/01/20073061F10023773Dtc c0327 with or without additional dtc's setting. with four wheel drive (4wd) only. *nj01/31/2008
POWER TRAIN - AXLE ASSEMBLY
0604200310/01/200610020950Revised rear axle fluid capacity and fluid level checking specification. *kb02/01/2007
03041700212/01/2006030417002A10001111Whine noise from rear axle. *tt04/15/2003
POWER TRAIN - MANUAL TRANSMISSION
31363136K10021019Slip condition in 2nd, 3rd, or 4th. damaged 2-4 or 3-4 clutch. *kb updated 10/31/07. *nj02/22/2007
410810020876Transmission shift indicator adjustment. *kb01/25/2007
POWER TRAIN - TRANSFER CASE (4-WHEEL DRIVE)
05-04-21-00301/01/2008050421003C10017464Service 4wd light illuminated, diagnostic trouble code (dtc) c0374 set. *tt updated 10/05/07. *nj inspect wiring harness to transfer case speed sensors, replace wiring harness. updated 7/18/08 *pe11/08/2005
34243424A10017299Electronic transfer case unable to complete shift. *tt11/02/2005

Consumer Complaints


Fail datemilesoccurencesPurchase date
POWER TRAIN - MANUAL TRANSMISSION - COLUMN SHIFT ASSEMBLY
10/27/2007110/20/2007
 On october 20 the 2007 i purchased a 2007 envoy suv from ramey ford in tazewell va. on october 27, 2007 i had backed into my drive way put the vehicle in park had the keys in my hand and walked around the vehicle to get my daughter out of the car seat. this is when i noticed that the vehicle was rolling i then jumped in the passenger side door and tried to stop the vehicle before i could stop the vehicle we (my daughter and i) were over a five-foot rock wall into the bushes my father stood there and watched the whole accident. my legs were hanging out of the vehicle i was very bruised up. thank god that my daughter had not been unbuckled from her car seat. after my father checked to see if we were okay i handed my father the keys and he moved the vehicle the gear shifter was pushed all the way to the dash in the park position ( i have pictures) the dash lights were reading park but the vehicle would move as though it was in drive. after moving the vehicle the keys would not come out of the ignition. when i wrecked and moved the vehicle there was sand everywhere on the scene from the vehicle it was like beach sand. my question is why did the keys come out of the ignition if the vehicle was not in park and now that the keys are in the ignition you can drive the vehicle in the park position and the keys will not come out????? *tr