Recalls


CampaignManufacturerManufacturing dateType# of units affectedDate Owner notified MfgRecall Initiated byManufacturers of recalled vehicles/productsReport Recieved DateRecord Creation DateRegulation Part NumberFMVSS Number
STRUCTURE - BODY
00V343000GENERAL MOTORS CORP.from 03/01/2000 to 03/31/2000V (Vehicle)3565911/16/2000MFRGENERAL MOTORS CORP.10/25/200010/27/2000
Defect SummaryVehicle description: light duty pickup trucks and sport utility vehicles. some of these vehicles have loose or missing rear wheelhouse plugs. under certain vehicle operating conditions, exhaust gases can flow forward and accumulate in the rear wheelhouse.
Consequence SummaryThese gases could flow into the passenger compartment if the plug is missing or loose and could cause possible illness, unconsciousness, or death.
Corrective SummaryDealers will inspect the vehicle for loose or missing wheelhouse plugs and install new plugs if necessary.
NotesOwner notification began november 16, 2000.owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact chevrolet at 1-800-222-1020 or gmc at 1-800-462-8782.also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

Bulletins


BulletinBulletin dateReplacement BulletinItem no.SummaryAdded
STRUCTURE
000861001A03/01/2001000861001622965Information providing revised assist step (running board) installation procedure. *tt10/25/2001
STRUCTURE - BODY
0176001/01/200410006376Buzz noise from headliner above driver. *mr04/30/2004
0014411/10/2000616384Some vehicles may have loose or missing rear wheelhouse plugs. under certain vehicle operating conditions, exhaust gases can flow forward and accumulate in the rear wheelhouse. these exhaust gases could flow into the passenger compart02/23/2001
0008411/01/2000616376General motors has decided that a defect which relates to motor vehicle safety exists in certain vehicles. some of these vehicles have loose or missing rear wheelhouse plugs. under certain vehicle operating conditions, exhaust gases ca02/23/2001
STRUCTURE - BODY - DOOR
01086401410/01/2001627425Subject on door manual lock lever disengages from door trim panel. *yh02/07/2002
01086401510/01/2001627471Information regarding front and rear side access door noise. *yh02/07/2002
STRUCTURE - BODY - DOOR - HINGE AND ATTACHMENTS
01086401510/01/2001628505Subject regarding front and rear side door access door noise (replace door check link). *jg03/12/2002

Consumer Complaints


Fail datemilesoccurencesPurchase date
STRUCTURE - BODY - HATCHBACK/LIFTGATE
02/09/200235990005/03/2000
 I discovered two gaps in the rear seals on the lift gate of my 2000 gmc yukon xl. the gaps are at the bottom corners of the lift gate (right and left sides) and are approximately 1 to 3 inches long and about 1/16 wide. these gaps will allow exhaust gasses to come into the vehicle, or water in the event of a heavy rainstorm. we plan to take the vehicle to the nearest dealer very soon, as we have 35,990 miles on it and we want it fixed under warranty. the seals appear to be inadequate, i.e. insufficient in size or thickness to adequately seal the bottom corners of the lift gate. this problem was found by inspection by myself, as i was inspecting the vehicle prior to allowing the warranty to expire. fortunately, i was able to see light coming through each corner, before anyone has a problem with the gap in the seals.
STRUCTURE - BODY - HATCHBACK/LIFTGATE - SUPPORT DEVICE
01/19/20072500102/08/2000
 Gmc yukon 2000 and above models. tail gate window installation. window is attached to vehicle with plastic fasteners which tend to break and cause the window to come separated from the window frame. the window is then attached to the vehicle primarily by the window lock. to my knowledge this has happened to my 2000 yukon xl, to my daughter's 2001 yukon xl and when i took the vehicle to the dealership shop for repair i was told by the shop personnel that they had fixed several like vehicle with the same problem. the replacement window is completely redesigned indicating that the factory has become aware of the problem, but has no called for a recall. this has been appearing for several years. the only way i have to date was to place the incident date as today's date. *jb